(a) the melting temperature for ic

Q: 7////////

A: The number of degree of freedom or mobility of planar mechanism is given by the following relation…

Q: A 4.8 m long from fixed point, 0.5 m wide and assumed a thickness of 30 mm throughout a springboard…

A: “Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: Name 3 ways to maintain fatigue-prone components

A: In mechanical components, the fatigue failure occured when components are subjected to variable…

Q: Materials of mechanics questionUse figure below Parts A & B Part A - Based on the figure, give the…

A: A) External force is the member force plus the change in bolt force .Lets see the maximum and…

Q: What are valid reasons for adding Yttrium to the zirconia in the Thermal Barrier Coating (TBC) in a…

A: The yttrium stabilized zirconium has very low conductivity and remains stable at very high…

Q: I’m a doing a stiffness compliance matrix. E_1 is 150 GPA; what are the units of E_1 when I do…

A:

Q: Convert to cis form

A: Conversion to cis form.

Q: determine and plot the moment M rotate arm 0A over the range 0 < Find the maximum value of M and

A:

Q: 3.

A: For solution refer below images.

Q: Why isnt the temprature used in this equation?

A: To state the reason for temperature in the equation

Q: If FB = 830 N, Fc = 450 N, determine the magnitude of the resultant force at A. (Figu Express your…

A: Given FB=830NFC=450N

Q: For a shaft diameter of 7.50 inches, a rectangular key size of 2.0 in.(W) x 1.50 in. (H) should be…

A: As per the diagram and question given For a shaft diameter of 7.50 inches, a rectangular key size of…

Q: Perform unit conversion. 28.9 nm to μm

A: Given 28.9 nm To be find Convert to μm

Q: wouldn't your last equation be Q/A= H (Tair-Tsurface)

A: Required:The explanation on the equation of heat flow per unit area, QA=h×To,surface-Tair

Q: What does the length characteristic specifically entail?

A: The meaning of term "length characteristic" depends on the specific performed analysis and context.…

Q: The creep rate (in sec-1) for the 40N loaded polyethylene at 45C is: (enter in decimals, up to six…

A:

Q: Calculate the volume (in ft) of material used in making 350 ft of 2 in. type L copper tubing.

A: Given that, From the table of type L copper tubeFor a 2 in. in nominal size tube:Outside diameter,…

Q: Write the Compatibility Equations?

A: Compatibility Equations…

Engineering Drawing

Technical drawing has been around since ancient times. As in the ancient Renaissance, complicated drawings were created, including Leonardo da Vinci's drawing. Modern engineering drawing, including its specific orthographic projection with scale conventions, began in Europe (France) during the early stages of Industrialization. L.T. C. Rolt also made some of Marc's drawings for its block-making machinery (in 1799) that also may have contributed significantly to British engineering technology. Since he learned the art of presenting three-dimensional(3D) items in a two-dimensional(2D) plane, as we now term mechanical drawing.