A ten year investigation of river potential gave an average flow of 25 cm per second at the bottom and 90 cm per second at the surface. The average cross section at the same location is 80 sq.m. What is the average flow rate in cubic meter per hour? A. 165,600 B. 57,500 C. 46,500 D. 5,760 What is the answer for this and solution?

Q: = 3.7.9. The water surface elevation difference between two reservoirs 2,000 m apart is 26 m.…

A:

Q: In March of 1996 a special release of water, U Canyon Dam, to create an artificial flood in the…

A:

Q: figure below with negligible losses. Determine the flowrate.

A:

Q: A pipe of 324 mm diameter, having friction factor as 0.04, connects two reservoirs with 15 m…

A: given- diameter of pipe d=324 mmfriction factor f=0.04L=1500 m

Q: A pipe of 324 mm diameter, having friction factor as 0.04, connects two reservoirs with 15 m…

A:

Q: Apply Hazen William’s Equation to the pumped system shown in the following figure, having a pumping…

A: Data Given: Pumping head = 77 mwc Q = 4000 m3/hr Pressure = 50 mwc L = 1200 m Hazen William’s…

Q: Estimate the flow under the dam below given: k = 5.2x10^-4 cm/s, h1 = 32ft, h2 = 11ft. Answer in…

A: Coefficient of permeability, To find: Flow under the dam.

Q: Water discharging into a 10 m wide rectangular horizontal channel from a sluice gate is observed to…

A:

Q: As shown in figure 3., water flows through pipe A 1.5 m in diameter at 2.5 m/s and passes through…

A: Diameter of pipe A, DA=1.5mDiameter of pipe B, DB=1mDiameter of pipe C, DC=0.7mVeocity of flow in A,…

Q: For the given figure shown below What is the velocity at the 300mm pipe?

A: Dia. of pipe = 300 mm = 0.3 m  Flow rate (Q) = 0.056 m3/s

Q: The annual peak flow rates in a river between 1980 and 1996 are as follows: Year Peak flow Year Peak…

A: Annual peak flow rates in a river between 1980 and 1996:YearPeak flow,…

Q: 5: There are two reservoirs, A and B, with the water surface elevation in A 10 m higher than that in…

A:

Q: A city well field has 2 wells pumping at the same rate Q. Each well is located 200 m from a straight…

A: The expression of discharge for drawdown of well  is given as q1=q2=2πkbH-hlogR2r H-h=qlogR2r2πkb…

Q: The river discharges into the reservoir shown at a rate of 400,000 ft³/s, and the outf the reservoir…

A: Given :

Q: Question- A pipe of 324 mm diameter, having friction factor as 0.04, connects two reservoirs with 15…

A: Given data- Diameter of pipe d=324 mm=0.324 m, Friction factor f=0.04, Water level difference h=15…

Q: dam supplies to a suburban area using a 0.21m diameter pipeline that is 881m long. For the water to…

A:

Q: The peak flow data for 5 years is provided in the table below. Based on the table below, what are…

A: Determine the a, b and c value in above table.

Q: An orifice with 0.80 cm radius is inserted in a vertical wall of a tank under a constant head of…

A:

Q: A pipe of 324 mm diameter, having friction factor as 0.04, connects two reservoirs with 15 m…

A:

Q: For the flow situation shown in figure, determine the ratio h₁/h₂ if the area Density = Pa A₂ A₁ A₁…

A:

Q: 2 A rectangular channel of 2.5 m width is carrying a discharge of 4 m³/s. Considering that…

A:

Q: Duration: 110 dk. (30p): Water demand of a city with 10.000 population is supplied from a well…

A:

Q: Water discharging into a 10 m wide rectangular horizontal channel from a sluice gate is observed to…

A:

Q: An open canal of rectangular cross-section with horizontal base and vertical sides is built through…

A: Given data: Slope of the bed (S) = 1 in 845 Depth of canal (d) = 6.5 m Width of canal (b) = 8 m

Q: The figure below represents the flow measured in a single day in River City. 2,500 2,000 1,500 1,000…

A: (1) Consider the graph,

Q: The storage-outflow characteristics for a reservoir are given below. Storage (106 m³) 70 80 85…

A: To find:graph of storage outflow function

Q: 7. What is the head loss per m through media of kh 0.04 h/m at a velocity of 0.5 m/min and…

A: Note that the units of hydraulic conductivity should be meters/hour or (m/h). The question has been…

Q: 5. A smooth plastic 10-m long garden hose with an inside diameter of 20 mm is used to drain a wading…

A:

Q: Q3: The stage discharge for a river is given below: Stage(H),m 3 4. 7 q m/s 90 203 420 710 900 1-…

A: Given the stage-discharge for a river as,  Stage(H), m q m3/s 1 90 3 203 4 420 6 710 7…

Q: A pipe of diameter 20 cm and length 2000 m connects two reservoirs, having difference of water as 20…

A: Given: Diameter of Pipe D=20 cm=0.20 m, Length of pipe L=2000 m, Difference of water level H=20m,…

Q: Problem 1: A fluid having v = 4 x 10-5 m²/s flows in a 750 m long pipe having a diameter of 20

A:

Q: 1 3 2 Figure Q1

A: Supercritical Flow:- Depths of flow less than critical depths resulting from relatively steep…

Q: A hydraulic jump is observed in an open channel that is 10-ft wide. The upstream depth of the flow…

A: We have relation between flow and depths:2q2g=y1y2(y1+y2)2q29.81=(1)(6)(1+6)q=14.353ft3s·ft

Q: The following figure illustrates the flow net for a proposed structure at the Alaska shore. From the…

A: Given data: H=10, K=6×10-5m/sec from figure, Nf=3, Nd=12 K=6×10-5K=6×10-5×60×60×24=5.18m/day For…

Q: 7. When just full, a reservoir has a surface area of 0.8 km², and this area is approximately…

A:

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.