A Telecom operator has been assigned the bandwidth from 2100MHZ to 2105MHz, this can support 100 voice channels and 6 users per channel. Assume there is a guard band (inter channel space) of 10KHz then what will be the size of a single channel? And how many total number of users could be accommodated? Draw figure on your note book along with your arid number and then add screen shot here.

A Telecom operator has been assigned the bandwidth from 2100MHZ to 2105MHz, this can support 100 voice channels and 6 users per channel. Assume there is a guard band (inter channel space) of 10KHz then what will be the size of a single channel? And how many total number of users could be accommodated? Draw figure on your note book along with your arid number and then add screen shot here.

Np Ms Office 365/Excel 2016 I Ntermed

1st Edition

ISBN:9781337508841

Author:Carey

Publisher:Carey

Chapter1: Getting Started With Excel

Section: Chapter Questions

Problem 3.9CP

See similar textbooks

Similar questions

An Internet-service provider company uses a fiber-optic network to transmit data between locations. Data are carried through fiber-optic cables and switching nodes. A portion of the company's transmission network is shown here. The numbers above each arc show the capacity in gigabits of data per second that can be transmitted over that branch of the network. 3 4 3 4 2 4 1 2 6 5 5 3 2 7 To keep up with the volume of information transmitted between origin and destination points, use the network to determine the maximum amount of data, in gigabits per second, that may be sent from node 1 to node 7. X GB/s 1
How would you write a system of linear equations based on the given scenario and directions? Scenario You are employed as a network engineer and have been asked to analyze a communication network to determine the current data rates and ensure that the links aren’t at risk of “reaching capacity.” In the following figure of the network, the sender is transmitting data at a total rate of 100+50 = 150 megabits per second (Mbps). The data is transmitted from the sender to the receiver over a network of five different routers. These routers are labeled A, B, C, D, and E. The connections and data rates between the routers are labeled as x1,x2, x3, x4, and x5 . Directions For this assignment, you will analyze the communication network and solve for the unknown data rates using a variety of techniques. The system can be modeled mathematically as a system of linear equations by writing an equation for each node/router in the network. Each of these equations can be written by noting that the sum…
Quèstion 24 Consider the figure below, with three links, each with the specified transmission rate and link length. ELink 1 Transmission rate: 1000 Mbps Link Length: 1 Km Link 2 +Link 3- Transmission rate: 100 Mbps Link Length: 1 Km Transmission rate: 10 Mbps Link Length: 5000 Km Assume the length of a packet is 16000 bits. The speed of light propagation delay on each link is 3x10^8 m/sec What is the transmission delay of link 2? 0.5 second O A 0.0016 seconds OB. 0.016 seconds OC. None of the above OD.
A company has a dedicated link of 100 Mbps. Each employee, when online, transmits continuously at 12 Mbps when active, but each user is active only 20 percent of the time. Assume packet switching is used. (a) What is the probability that more than 2 users are transmitting at the same time?
A network with Ethernet LAN protocol in MAC layer having minimum frame length is 1000 bits. If the speed of signal is 2x10³ m/s and length of cable is 1 km. Then what is the expected data rate in Mbps_ ?
One important issue in networking is the performance of the network. The question is how can measure the performance of heterogeneous networks. For example, UIT network which provides access to students at both wired and wireless networks. In this kind of scenario: a) You may need to define key performance parameters that can be used to evaluate the network performance. b) If UIT has a total bandwidth of 100Mbps and 40Mbps is reserved for admin and faculty. Due to COVID-19 pandemic total students coming daily altogether in morning and evening are 500. How much bandwidth a student can achieve if all students are using internet at the same time?
Consider a network with a ring topology, link bandwidths of 100 Mbps, and propagation speed 2 × 108 m/s. What would the circumference of the loop be to exactly contain one 1500-byte packet, assuming nodes do not introduce delay? What would the circumference be if there was a node every 100 m, and each node introduced 10 bits of delay?
Assume the VC number of a virtual-circuit network is a 16-bit field. What is the maximum number of virtual circuits that can be carried over a link? If the path and the VC number for each VC are determined by a central node of the network and the same VC number is used for all links along the path of same VC, how does the central node determine the VC number at the setup time?
Describe the signal pattern produced on the medium by the Manchester-encodedpreamble of the IEEE 802.3 MAC frame. Explain the term handoff Assume a system of 32 cells with a cell radius of 1.6 km,a total of 32 cells, a total frequency bandwidth that supports 336 traffic channels,and a reuse factor of N=7. If there are 32 total cells, what geographic area is covered, how many channels are there per cell, and what is the total number of concurrent calls that can be handled. What is the difference between a virtual channel and a virtual path? How does Fast Ethernet differ from 10BASE-T, other than the data rate?
What are the propagation time and the transmission time for a 5-MB (megabyte) message (an image) if the bandwidth of the network is 1 Mbps? Assume that the distance between the sender and the receiver is 12,000 km and each word requires 8-bit with light travels at 2.4 * 108 m/s
Segments are transmitted using GO-BACK-N ARQ over a link with RTT= 6 milliseconds with 17 Mbps transmission rate. The packet size is 3721 bytes and the window size is (static) 449. Assume there is no transmission errors and we always have data to send. Then, the link utilization is 66 x %. Note: provide a number greater without any signs.
Consider two hosts S and R connected directly by a link. A link has a transmission speed of 107 bits/sec. It uses data packets of size 400 bytes. Data needed to transmitted is 400 bytes. Length of the link is 600 km and the propagation speed are 3 × 108 meter per second. T is the transmission delay and P is the propagation delay. The propagation delay in millisecond and transmission delay in microsecond respectively are