A technician determines the concentration of calcium in milk using two instrumental methods. If Fcalculated > Ftable for the two sets of calcium data, what conclusion(s) can the technician make? I. The difference in standard deviations for the two instrumental methods is significant. II. The difference in standard deviations for the two instrumental methods is not significant. III. The data come from populations with the same standard deviation. IV. The data do not come from populations with the same standard deviation. II and III O II I and IV I and III II and IV

A technician determines the concentration of calcium in milk using two instrumental methods. If Fcalculated > Ftable for the two sets of calcium data, what conclusion(s) can the technician make? I. The difference in standard deviations for the two instrumental methods is significant. II. The difference in standard deviations for the two instrumental methods is not significant. III. The data come from populations with the same standard deviation. IV. The data do not come from populations with the same standard deviation. II and III O II I and IV I and III II and IV

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

A student determines the concentration of an unknown sample using two different methods. Each method has three different trials; the average, standard deviation and percent error produced by each method is listed below. Method 1 Average: 10.56 M NaOH Standard deviation: 1.35 M NaOH Percent error: 1.25% Method 2 Average: 10.92 M NaOH Standard deviation: 1.02 M NaOH Percent error: 3.45% Which method was more precise? How can you tell?
The following volumes were obtained for the calibration of a 10 - mL pipet: 10.028415, 10.140035, 10.091111, and 10.012213 mL. Calculate the mean value, the standard deviation and then report your value.
The following densities of water were obtained by Student A: 1.07 g/mL, 1.14 g/mL, and 1.13 g/mL. Show how Student A determined the density of water to be 1.11 ± 0.04 g/mL. Calculation for the average = 1.11 g/mL: Calculation for the standard deviation = 0.04 g/mL:
How would you calculate Standard Deviation?
An ore sample was analyzed for its Fe content. Student A analyzed the sample a total of six times and her results had a standard deviation of 1.33. The same sample was analyzed five times by Student B and his results had a standard deviation of 3.42. To determine if their standard deviations are similar, they perform an F test. The calculated F value is and the table value of Fis 3 in your book for critical values of F. O 6.61; 7.39 O 6.61; 9.36 O 0.151; 9.36 O 2.57; 7.39 O 6.61; 6.98 Refer to Table 4-
Calculate the sample standard deviation, s, for this set of data: 4.5, 6.7, 4.2, 9.6, 3.4, 8.2 Report your answer to the fourth decimal place.
Calculate the sample standard deviation, s, for this set of data: 1.9, 1.5, 6.0, 2.0, 1.4, 1.2 Report your answer to the fourth decimal place.