A TDMA system uses 25 MHz for the forward link, which is broken into radio channels of 200 kHz. If 8 speech channels are supported on a single radio channel, how many simultaneous users can be accommodated?

A TDMA system uses 25 MHz for the forward link, which is broken into radio channels of 200 kHz. If 8 speech channels are supported on a single radio channel, how many simultaneous users can be accommodated?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Which of the following factors determine how successful the receiver will be in interpreting the incoming signal? a. Signal-to-noise ratio (SNR) b. Bandwidth c. Signal encoding scheme d. All of the above e. Only (a) and (b) f. Only (b) and (c) 2. Which of the following statements is the most accurate one? a. The main purpose of any communication system is to get data from a Source to a Destination through a guided medium. b. The main purpose of any communication system is to get data from a Source to a Destination across some medium, even in the presence of noise. C. The main purpose of any communication system is to get data from a Source to a Destination using optical fiber cables with the highest possible data rate. d. The main purpose of any communication system is to transmit binary data to very long distances. e. None of the above 3. In Simplex transmission mode, one station works as a transmitter and the other works as a receiver. a. True b. False
(b) In a particular implementation of ADSL2+, 400 downstream subchannels are being used to achieve a data rate of 10.4 Mbit s-1. If 75 subchannels are using 1024-QAM, 125 are using 64-QAM and 100 are using 16-QAM, what modulation scheme must the remaining channels use, assuming they all use the same scheme? Show all your workings
Dive into the technical specifications of optical fiber cables. Explain the principles behind fiber optics and its advantages over traditional copper cables for high-speed data transmission.
Q3. Draw a time division multiplexing PAM (TDM-PAM) and show that the minimum required channel BW is 2nfm where n is the number of users and fM is the maximum frequency of the message signal.
Question 6: Which of these use Capacitors and Latches from SRAM and DRAM for storage purpose? How long both can retain data?
Given the Manchester Line Coding Waveform, the corresponding binary data is ________________
Write an ALP to transfer the message “CORONA” serially at 2400 baud rate, 8-bit data, 1- stop bit. Do it continuously.
(iii) Describe the purpose of multiplexing in an optical communication system and explain the advantages of multiplexing. (iv) How the performance of this system is measured? Provide an example.
Four computers are sending the digital data over a multiplexed line as shown in the Figure below. A). Show how the messages are multiplexed into frames using synchronous TDM and Asynchronous TDM. B). How many frames are generated if you are using Synchronous TDM? C) How many frames are generated if you are using asynchronous TDM with frame size 3? SAMPLE DATA HELLO CODE
In an FDMA-based multiple access system, each user is assigned an 80 kHz channel for full-duplex communication. There are 1000 channels in the system.Depending on the information given above, if the initial frequency of the frequency spectrum used by the FMDA system in one direction is 1000 MHz, which of the following is the correct spectrum of the bond's spectrum.A1.000.000 KHz - 10000.080 KHzB1000.000 KHZ - 1.000.040 KHzC1.000.000 KHZ - 1.040.000 KHzDNoneE1.000.000 KHZ - 1.020.000 KHZ
Given that the probability of bit error on a given channel is p and that n-bit words are transmitted. a.) Calculate the probability of a correction error in the Hamming 7,4 code. b.) Calculate the probability of a detection error in the Hamming 7,4 code.
Higher bit rates can be achieved over voice grade line by employing M-ary modulation schemes TRUE FALSE