A tap discharges water evenly in a jet at a velocity of 2.6 m/s at the tap outlet, the diameter of the jet at this point being 15 mm. The jet flows down vertically in a smooth stream. Determine the velocity and the diameter of the jet at 0.6 m below the tap outlet.

Q: Find the discahrge through pipe having cross sectional area of 4 mm2 and velocity of flow is 3.31…

A: Given data : Velocity of flow V=3.31 m/s Cross sectional area A=4 mm2   To find : Discharge through…

Q: to pump water from lower reservoir to upper reservoir, a centrifugal pump is used. if the length of…

A: Given:Suction head=3 mdelivery head=30 m

Q: The nozzle which furnished the water to a certain hydraulicturbine 275 mm in diam. and has…

A: Flow rate: The amount of fluid flowing through a particular crosssection per unit of time is known…

Q: The discharge of a fluid is 0.80 L/s in a 100 mm diameter pipe. Determine the type of flow if the…

A:

Q: EB, Fluid Transport. Water is pumped from a reservoir to top of the mountain through a 1800m long…

A: Given:Lenght of the pipe, L=1800 mPipe=6 inch schedule 120 pipeAverage velocity of fluid, v=5…

Q: A closed cylindrical vessel, 3m in diameter and 8m high is shown. Assuming that C of orifice is…

A: we have to determine the flow rate

Q: Water is flowing through a pipe of 0.50-meter diameter and 2.5-kilometer length. If the average…

A: Given Data⇒ Diameter of pipe(d)=0.50 m Length of pipe (L)= 2.5 km Length of pipe (L)= 2.5×1000 m…

Q: A closed cylindrical vessel, 3m in diameter and 8m high is shown. Assuming that C of orifice is…

A:

Q: A water discharge of 8 m3 s is to flow through this horizontal pipe, which is 1 m in diameter. If…

A: Given Data⇒ Discharge Q=8m3s Horizontal Pipe Diameter of pipe(d)=1 m   Assumptions made in…

Q: water flows through a horizontal venturyi meter whose inlet diameter is 33 cm. and throat diameter…

A:

Q: Calculate the theoretical discharge through a vertical orifice 0.3 m square in the side of a tank if…

A: Given Data,A=0.3m×0.3m=0.09 m2h=150 mm⇒0.15Now, Let coefficient of  velocity        CV=0.99So,…

Q: Q2/ Water is flowing through the system. If P1 = 0.18 MPa gage, and mass flowrate is 15 kg/s.…

A: The velocity of flow at section 2 can be determined as, The velocity at section 1 can be determined…

Q: 7. For the flow of a thin layer of liquid down an inclined plane shown: a. Using the cross-hatched…

A: As per company policy, we are restricted to solve three sub-part of one question at a time. Please…

Q: Q7) Air is flowing through a pipe and a mercury manometer is attached with this pipe. If the…

A:

Q: AAA cir Water is flowing through a horizontal pipe of diameter 200 mm at a velocity 3 m/s. A…

A: Given:pipe diameter, D=200 m or 0.2 mvelocity of flow, v=3 m/sdiameter of solid plate, d=150 mm or…

Q: A closed cylindrical vessel, 3m in diameter and 8m high is shown. Assuming that C of orifice is…

A:

Q: Example the bottom and upper end respectively. The intensity of pressure at the bottom end is 350…

A: The entire mechanical energy of the flowing fluid, which includes the gravitational potential energy…

Q: Water flows from a pressurized tank (@ 300 kPa) to an open tank 5m above. Determine the pressure…

A: Given data Water flows from a pressurized tank Pressure of tank = 300 kPa Open Tank is 5 m above…

Q: Find: the rate of change of water surface level with a unit of m/s from the given information in the…

A:

Q: The 150 mm pipeline as shown conducts water from a reservoir and discharges at a lower elevation…

A:

Q: Given the venturi meter and the two pressure is shown, calculate the mass flowrate of water in the…

A:

Q: Water flows from section 1 to the reservoir at section 3 (where V3 = 0 ft/s) through first 300-ft…

A: Given DataL1=300ft=91.44md1=2in=0.0508mL2=100ft=30.48md2=3in=0.0762mQ=40gal/min=0.0252m3/sTotal…

Q: 3. A 20-mm-diameter commercial steel pipe, 30 m long is used to drain an oil tank. Determine the…

A: Question A 20 - mm diameter commercial steel pipe, 30 m long is used to drain an oil tank.  Neglect…

Q: There is an upward flow from the vertical pipe shown in the figure. If the flow rate is 0.05 m3 / s,…

A: Given data: The flow rate is, Q̇ = 0.05 m3/s. Write the expression to calculate the velocity at…

Q: Q.2.A. Blood flows through the branching blood vessels as shown in figure at a rate of 1o Aaln ft/s.…

A:

Q: The water in an aquarium will be drained for cleaning. A flexible tube (D = 4mm) will be used to…

A: The volumetric flowrate of water is 2.587 LPM (litre/min).

Q: Two pipes are connected in series with a diameter ratio of 2:5. If the flow velocity in the smaller…

A:

Q: 1. Water flows over a flat surface at 1.2 m/s, as shown in the figure. A pump draws in water through…

A: Calculate the source strength. Write the equation of stream function for uniform flow and sink.…

Q: A pipe of 60 meters long and 150 mm in diameter is connected to a water tank at one end and flows…

A: Given that, Diameter of pipe, d=150 mm=0.15 m Length of pipe, L=60 m H=2.6 m, f=0.01

Q: The water flows through a pipeline 1.2m diameter at a velocity of 3m/s which bifurcates at a…

A:

Q: A 50. 49mm diameter horizontal jet of water strikes a plate. Determine the velocity of the jet if…

A:

Q: A 75-mm diameter orifice discharges 23.41 L/s of liquid under a head of 2.85 m. The diameter of the…

A: To find :  The three orifice coefficients. Given :  The diameter of orifice is do=75 mm. The…

Q: Water flows steadily with negligible viscous effects through the pipe shown in the figure below.…

A:

Q: Water flows through the piping junction, entering section 1 at 20 US gallons/min (1 US gal = 3.78…

A: Given data: Q1=20 US gallons/min=12.62×10-4 m3/sv2=2.5 m/sdh=1 mm Need to determine the exit…

Q: PROBLEM 3 The pipe bend shown is in a horizontal plane. Oil with a specific gravity of 0.86 enters…

A: Given ,  Specific gravity of oil  =0.86  Velocity at section A = 3.2 m/s Pressure at section A  =…

Q: Determine the velocity and pressure at sections 2 and 3 if water flows steadily through the pipe…

A:

Q: A fan has a suction pressure of 37mm water vacuum with air velocity of 8m/s. the discharge has 230…

A:

Q: A 20 hp pump with a suction from an open reservoir (10 m above the pump) has a flow rate of 125…

A:

Q: A pump is required to pump water from a large reservoir to the water tower located 20 m above the…

A: Given data :- Datum head Z2 = 20 m  Discharge Q = 0.03 m3 /s  Density = 1000 kg/ m3 diameter d = 30…

Q: The 600 mm diameter pipe conducts water from reservoir A (El. 61 meters) to a pressure turbine (El.…

A: To given that D=600=0.6mhA-1=5×V22gh2-B=0.20×V22gQ=708/1000 m3/sQ=0.708m3/sPOUT=480hp consider the…

Q: the power produced by the 100 mm diameter jet discharging at the nozzle is equivalent to 60 kW.…

A: given informationdiameter of the jet d=100 mm=0.1mpower produced P=60KWto find the velocity of the…

Fluid Dynamics

The study of the flow of gases and liquids, usually in and around solid surfaces, is known as fluid dynamics in physics and engineering. Fluid dynamics, for example, can be used to evaluate the movement of air through an airplane wing or the surface of a vehicle. It can also be used in ship design to increase the speed at which ships pass through water.