A tank contains 1,500 L of water and 2020 kg of dissolved salt. Fresh water is entering the tank at 15 L/min (the solution stays perfectly mixed), and the solution drains at a rate of 10 L/min. How much salt is in the tank at 10 minutes?

A tank contains 1,500 L of water and 2020 kg of dissolved salt. Fresh water is entering the tank at 15 L/min (the solution stays perfectly mixed), and the solution drains at a rate of 10 L/min. How much salt is in the tank at 10 minutes?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: lly holds 100 gallons of brine that contains 150 pounds af salt, and tank B holds 100 gallons of…

A: Given:- Tank A holds= 100 gallons of brine Tank A =150 pounds of salt Tank B holds-100 gallons of…

Q: A 0.15 L sample of water has an initial dissolved oxygen level of 8.35 mg/L. After five days in…

A: BOD5=initial dissolved oxygen-final dissolved oxygen(sample volumesample bottle volume)

Q: 15m SAE 30 ol Water 25m Oiive ol 29m Mercury 04m

Q: When an unknown fluid passes through a 10 m pipe (ID: 10 cm) at a discharge of 0.010 m³/s, the head…

A: L=10 mD=10 cm = 0.1 mQ=0.010 m³/sHL=1 mTo determine: kinematic viscosity of this unknown liquid

Q: The chlorine demand test conducted in a laboratory for raw water samples is tabulated below. Sample…

Q: A high-rate digester is being operated at a constant temperature of 100°F. The sludge loading rate…

A: Given data- High-rate digester- Temperature = 100oF, Sludge loading rate SLR=396 m3/d, To Find- The…

Q: As a design engineer, you have been hired to address water hardness problems in the town of St.…

Q: A well mixed tank with a capacity of 1500 gals originally contains 1000 gals of fresh water. One…

A: Tank capacity =1500 gals Fresh water content = 1000 galsTo find salt concentration in tank

Q: Although gas station owners lock their tanks at night, a gas station owner was the victim of theft…

A: Given that, Specific gravity of gasoline = 0.733 Density of gasoline = 733 kg/m³

Q: Assume the described is at steady state. A fluid goes up to an aquifer that has groundwater and a…

A: Volume of groundwater reservoir, Outflow, Chloride Concentration of fluid, Chloride outflow,

Q: A wastewater treatment plant discharges its effluent into a river at time 0 days as shown in the…

A: (a) It is required to determine the initial DO deficit. From the graph, saturated DO is 9 mg/L, and…

Q: QI/ A tank is initially filled with ( 250 gal) in which 50 lb of salt are dissolved. salt Fresh…

Q: If a certain liquid weighs 6.80 kN/m³. Compute the following: 1) Mass density in kg/m³ . 2)…

Q: 11.61 A 4.0% sodium fluoride solution is applied to increase the fluoride concentration from 0.4 to…

A: Given, Strength = 4% Initial fluoride = 0.4 mg/L Final fluoride = 1 mg/L

Q: In a wastewater treatment plant, the supply of oxygen supply is 073 kgO2/h is necessary…

A: Given data: oxygen supply under operating conditions, Ns = 73 kgO2 /kwh = 73 MJ Liquid temperature:…

Q: A water contains 100.0 mg/L CO2-3 and 75.0 mg/L HCO-3 at a pH of 10 (T =25C). Calculate the exact…

A: Given, CO2-3 = 100 mg/L HCO-3 = 75 mg/L pH = 10

Q: A BOD test is conducted using standard size BOD bottles. The technician prepares two BOD bottles on…

Q: A completely mixed tank has a volume of 10 Litres. It contains 0.5 Litres of dirty water with a…

A: According to given data A completely mixed tank has a volume of 10 Litres.It contains 0.5 Litres of…

Q: 4. Tank A initially holds 100 gallons of brine that contains 100 pounds of salt, and tank B holds 10…

A: Given, Initial salt content in tank A = 100 lb Volume of tank A = 100 gallon Volume of tank B = 10…

Q: .3 Q4. A municipal wastewater treatment plant has an aeration basin that is 1000 m3 in volume, with…

Q: Question Calculate Reynold's number, if a fluid having a viscosity of 0.4 Ns/m² and density of 900…

A: Viscosity=0.4 N-s/m2 Density=900 kg/m3 Pipe length L=20 mm Velocity V=2.5 m/s Reynold's number=?

Q: 200 liters of fresh water are contained in a tank. At a pace of 4 liters per minute, brine…

Q: The rate of the water flowing from a pipe is at 1500 gal/min. Convert this volume rate of flow in…

A: To convert the volume rate of flow to the given units. Given, Volume rate of flow, say Q = 1500…

Q: A 1500 litre full capacity tank holds 500 litres of pure water. A salt solution containing 0.04 kg…

A: Given:- full capacity = 1500 litre pure water =500 litres salt solution=0.04 kg per litre pumped…

Q: A large tank is filled to capacity with 500 gallons of pure water. Brine containing 2 pounds of salt…

A: The concentration of the salt in the inflow is 2lb/gal. Capacity is 500 gal Pumping in and out rate…

Q: Given concepts of water quality: Some of the more important general water quality parameters can be…

A: Some of the more important general water quality parameters can be listed as a) Turbidity b)…

Q: Determine the total mass of solids removed over the entire 8-hour period, in kg.

A: A table is shown in the given figure as need to findThe total mass of solids removed over the entire…

Q: APPLICATIONS OF DIFFERENTIAL EQUATION: A tank is initially filled with 100 liters of pure water.…

A: solution Let y(t) be the amount of salt in gram in the tank after 4 minutes, then we can write…

Q: Determine the preak point dosage of chlorine given the data below which was obtained from…

A: Determine the break point dosage of chlorine.

Q: Approximately 505 gallons of liquid gasoline have contaminated the soil underneath an existing…

A: Given data, Total amount of gasoline contamination = 505 gallons Amount of gasoline to be extracted…

Q: Consider the following data for irrigation water: 1 2 3 Concentration Milli-equivalent per litre Nat…

A: Sodium Absorption ratio: Sodium adsorption rate (SAR) is an irrigation water quality parameter used…

Q: Determine the preak point dosage of chlorine given the data below which was obtained from…

A: Determine the break point dosage of chlorine.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

A bottle is filled with river water. The initial dissolved oxygen concentration is 10.2 mg/L. After 5 days the dissolved oxygen concentration is 3.0 mg/L. Calculate the BOD 5. in mg/l
The value of the equivalent volume of 1100 gallons is . m^3. 4.00 O 4.75 5.00 5.75 O other answer
Sketch a typical surface water treatment plant, label all its parts, and explain theirfunctions.
QUESTION 4 Adding 20ml sample to a 300ml DO bottle causes its dissolved oxygen concentration to decrease by 10 mg/l. by the end of the first day What is the BOD1 of the sample? Answer mg/L
An oil of density 850 kg/m3 is pumped in a pipe of diameter 20 cm. The discharge is measured as 0.015 m/s. The drop in pressure in a length of 800 m of pipeline, both ends of which are at the same elevation is measured as 98 kPa. Assuming Re < 2000, calculate the value of absolute viscosity of the oil.
An Analysis of water from a surface stream yields the following results Ca+2=60mg/L HCO3-=115mg/L Mg+2=10mg/L SO4-2=96mg/L Na+=7mg/L NO3-=10mg/L K+=20mg/L CI-=11 mg/L If an error of 10 percent is acceptable, should the analysis be considered complete?
A wastewater treatment plant is operated at a steady state DO concentration of 1.5 mg/L. If the temperature of the wastewater is measured at 10 °C, a= 0.8 and B = 0.95 and the KLa reported by the aerator manufacturer at 20°C in tap water is 5 hrt, estimate the oxygen uptake rate (in mg/L-min) in the aeration basin. You can assume 0=1.024. If the aerator's oxygen transfer efficiency is 24%, what would be the mass of air (kg) required per hour in a 8500 m³ tank? What volumetric flow rate would you have to supply (m³/hr)? 3.
Can you please solve step by step I can't seem to understand it.
I need the answer as soon as possible
We have a 20 meter long pipe for sewage transfer. If the mass percentage of solids in the effluent is 0.5%, calculate the minimum slope of the pipe so that the solid does not settle in the pipe.
A sewage sludge has a water content of 99%. The concentration of suspended solids in the sludge will be mg/l. [Take density of wet sludge = 1000 kg/m³]
Problem 4. A vessel contains 200 Liters of brine with 30 grams of dissolved salt. Brine containing 1 gram of salt per liter enters the vessel at 4 liters per minute. The solution is kept thoroughly mixed and drains from the vessel at the same rate. Calculate the amount of salt in the tank after 5 minutes.