A tank contains water up to a height of 10 m. One of the sides of the tank is inclined. The angle between free surface of water and inclined side is 60 degrees. The width of the tank is 5 m. Find the force in kN exerted by the water on the incline side. a. 283.19 b. 126.52 c. 128.92 d. 193.58

Q: Refer to Figure 1. What force P applied to block B acting to the right that would cause impending…

A:

Q: 12. Find the vertical displacement at the midspan of the beam shown, El is constant. (in kN m^3/El)…

A:

Q: What is the vertical reaction at A for the frame shown? 2 k/ft B 100 k •ft 15 ft El = constant E =…

A: Figure is as shown

Q: Calculate the horizontal support reaction at D of the structure shown. 0.4 kip/ft B 10' 10 kips 16'…

A:

Q: Find the location and the intensity of the maximum negative moment from the left end of the beam…

A: To maintain equilibrium, the sum of vertical force acting on the beam is equal to zero. ∈V =0RB +…

Q: 30 k 2 k/ft D C 6 ft- -10 ft FIG. P5.35

A:

Q: Solve the axial forces of the members indicated in the given image.

A:

Q: Situation K. A frame is shown in the figure 31. The internal degree of static indeterminacy of the…

A:

Q: P11.30b For the beams and loadings shown below, assume that EI= 5.0 x 104 kN-m² is constant for each…

A: 1. Concentrated moment M 2. Reactions at support B 3. Deflection at point A

Q: Axis of rotoinversion indicates إختر أحد الخيارات: translation + inversion .a O penetration +…

A: Brief concept introduction- Axis of rotoinversion- Rotation around a rotation axis is combined with…

Q: 55 kN 55 kN 30 kN/m 30 kN/m 116.67| 9 m 3 m 208.33 El = constant E= 200 GPa I- 830(10) mm (b) Real…

A:

Q: A simply supported beam has a span of 12m. The beam carries a total uniformly distributed load of…

A: A beam is a load-carrying component of the building which is used to resist seismic condition and…

Q: etermine the magnitude of the moment of P about the following lines in N. m

A: Given figure shows the parallelepiped, it is required to find the magnitude of moment of force "P"…

Q: *(26-27): An isocles triangular plate of height 460 mm and base of 200 mm is submerged vertically in…

A:

Q: It is required to calculate the moment about point A for the following structure. 30 A 120mm Moment…

A:

Q: Determine the internal forces at point C.

A: It is asked to calculate internal force at point C

Q: Write the shear and moment equation. Draw the shear and moment diagram

A: A beam is given we need to draw the shear force and bending moment diagram

Q: The bar shown below is inclined at 45 degrees with the horizontal and at equilibrium. The force at C…

A: Given: Angle made by the bar with the horizontal=45°. Force at C is perpendicular to the bar. To…

Q: thor the system shown to the right a. find the resultant force and couple moment at point A 400N/m…

A:

Q: Prob. 1. The 300N block rests upon a level plane for which the coefficient of kinetic friction is…

A:

Q: Draw the shear force and bending moment diagram for the beam shown. Determine the maximum shear and…

A: To find out the shear force and bending moment diagram and also find out the maximum shear, maximum…

Q: Referring to Fig. P-519, block A weighs 4 kN and B weighs 3 kN. If u = 0.20 under B, compute the…

A:

Cables

Cables are collections of wires, alternatively referred to as a cord, connector, or plug. They are one or more wires covered in a plastic covering that allows for the transmission of power or data between devices. The earliest use of recognizable electrical cable was the early commercialized telegraph lines. These were iron-made and tedious to produce and install cabling.