A tank containing water moves horizontally with a constant linear acceleration of 3 m/s2. The tank is 3 m long and the depth of the water when the tank is at rest is 1.5 m. Calculate the: (A) Angle of the water surface to the horizontal (B) The maximum pressure intensity at the bottom and (C) The minimum pressure intensity on the bottom

A tank containing water moves horizontally with a constant linear acceleration of 3 m/s2. The tank is 3 m long and the depth of the water when the tank is at rest is 1.5 m. Calculate the: (A) Angle of the water surface to the horizontal (B) The maximum pressure intensity at the bottom and (C) The minimum pressure intensity on the bottom

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Manometer and guage pressure are connected to one gas tank. If the atmospheric pressure is 100 kPa and the liquid level in both manometers is different from 0.75 m. (The liquid inside is mercury), find the absolute pressure of the gas tank. this (specify the density of mercury is 13,000 kg/m3)
h = 4 ft F 2 ft A hemispherical glass bubble is installed in the side of a tank as a viewing window with its center 4 ft below the surface of the water. What is the magnitude of the vertical component of the force on the glass in lbs? The specific weight of water is 62.4 lbf/ft3.
A tank of water 5m deep receives a constant upward acceleration az= 4 m2/sec, determine the gauge pressure at the tank bottom in pascal is: *
Consider a differential manometer whose ends are connected to two different pipes A andB and containing different liquids at different levels. Let us assume that the pressure at point A is more than that at point B. Oil is in pipe A whose density 800 kg/m³ shows a difference in mercury levels as 100 mm. The height of oil between center of pipe A to the mercury level in left limb is 200 mm. Methanol (relative density 0.791) is in pipe B and the height of Methanol between center of pipe B and mercury level in the right limb is 5 cm. Calculate the difference in pressures at the two points A and B.
A tidal barrage is in the shape of a quarter cylinder of radius r=16m, as shown in the picture above. If the barrage is 13m wide and holds back water of density 1014kg/m³ to its full height, what is the magnitude of the vertical force on the barrage? Assume that the atmospheric pressure is constant. Give your answer in Kilo Newtons to the nearest whole number. Use an acceleration due to gravity of g=9.81m/s²
Chemistry The contact angle for water in a clean glass is zero. Calculate the surface tension of waterin a 0.3 mm diameter vertical tube if the water rises to a height 4.96 cm above the liquidoutside the tube, knowing that specific gravity of water equals 998.2 kg/m 3 and theacceleration due to gravity equals 9.806 m/sec2
The figure below shows a container filled with a liquid of density p up to a height of 4R. The container is of unit width into the plane of the screen and AB is half a parabola with a height of kR and a base of R. Determine the magnitude and direction of the vertical component Fy of the hydrostatic force acting on the curved surface AB if k = 2, R = 0.5 m, p = 1000 kg/m³ and the gravitational acceleration g = 9.81 m/s². Note that Fy is positive if it acts upwards and is negative if it acts downwards. Geometric properties of a half-parabola are also given below. Fy= 1. [-6.7362, -6.3438 kN. 4R h ထမ 35 b Liquid Р X Half-Parabola BR KR A = 3bh 1xc=²bh³ |yxc=hb³ |yy,c=²7/531 2 h63
The 2-m wide gate ab depicted on the right retains water 3 m deep. Determine the horizontal and vertical forces on the gate, then calculate magnitude and direction of the resultant force on the gate.
A full cylindrical tank having a diameter equal to its height contains water with a total mass of 545 lbm. Estimate the radius of the tank.
Consider the pressure and force acting on the pool retaining a reservoir of water. Suppose the pool is 50m wide and the water is 8m deep, as illustrated below. (a) What is the Gauge pressure on the dam due to the water? (b) What is the absolute pressure at10m depth of the dam? (C) Calculate the force exerted against the dam. Density of water is 1000kg/m3.
Consider two tanks filled with water. The first tank is 8 m high and is stationary, while the second tank is 2 m high and is moving upward with an acceleration of 5 m/s^2. Calculate the pressure of each tank at the bottom.
A vat contains a mixture of oil and water. The water forms a lower layer which is 0.8 m deep, and above it there is an oil layer 0.3 m thick. The density of water is 1000 kg/m³, and the density of oil is 800 kg/m³. Find the force on a flat door at the bottom of the vessel that has a cross-sectional area of 0.5 m². The acceleration due to gravity is 9.81 m/s². Oil, P. = 800 kg/m³ h, = 0.3 m %D Water, pw= 1000 kg/m3 h, = 0.8 m A = 0.5 m² O a. 5.1 kN O b. 5.4 kN Ос. 1.28 kN O d. 4.32 kN е. 10.2 kN