A surveyor made 4 different routes of level from Point A to Point B. The elevation at A is 250 m and is lower than Point B. DISTANCE (km) ROUTE DIFF IN ELEV (m) 1. + 0.85 + 0.70 + 0.55 2 7 3 4 4 + 0.80 What is the most probable elevation at B?

A surveyor made 4 different routes of level from Point A to Point B. The elevation at A is 250 m and is lower than Point B. DISTANCE (km) ROUTE DIFF IN ELEV (m) 1. + 0.85 + 0.70 + 0.55 2 7 3 4 4 + 0.80 What is the most probable elevation at B?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Complete the following level notes. Show your detailed solution and checking. Differential Leveling…

A: We know that,Height of instrumentHI=Elevation of Bench mark+Back sightBSandEleavation of a…

Q: The following consecutive reading were taken with a level and 4m leveling staff ground at common…

A: Here they ask to calculate the reduce level of points and calculate the gradient of line AB

Q: Complete the following level notes. Show your detailed solution and checking. Double Rodded…

A: Objective: To complete the given leveling observation table and perform the checks. Given:…

Q: The process of determining relative elevations of points on the surface of the ground is known as a.…

A: Surveying may be defined as the method of making measurements of relative position on the surface of…

Q: 1. Determine the slope correction for steep slope and the horizontal distance AB if two lines AC and…

Q: PROBLEM The baseline AB of a Triangulation system is equal to 400 m long Stations C and D are the…

Q: 1.1 how to use a level 1.[Calculation] To calculate the elevation of some points, a leveling route…

A: surveying : The technique, profession, art, and science of identifying the two-dimensional or…

Q: Work out the following problems regarding points and stations along a profile-level route. A. A…

Q: Q.3 A level circuit is shown in figure. The survey, needed for local engineering project, commenced…

A: Find the error in elevation of BM 35 Error in elevation of BM 35=118.933-119.010Error in elevation…

Q: 4-) Complete the benchmark-leveling field notes by computing and recording the HI and elevation for…

A: Solving for first table1. (2.367-1.277)=1.09Elevation at 1=200.00+1.09=201.09

Q: Given the following data, calculate the elevation of hilltop point B. Slope dist., S Zenith angle…

A: Given data: S=2935.260mZenith angle (Z)=108°43'37''BM EA=308.420m Figure:

Q: The data of a closed traverse is shown below. Create a table (in your solution sheet) showing all…

A: To compute the area of the traverse using the Double Meridian Distance (DMD) and Double Parallel…

Q: For the given traverse, do the following: 1. Find the distance of CD and DE. 2. Find the Area of the…

A: We have to find the length of line CD and DE

Q: The area of a triangular lot is to be computed, given the following trials for the stadia interval…

A: Given, Stadia interval factor=102, 95, 98, 97, 104, 107 Rod intercept and angle at A =1.265, 0° Rod…

Q: SITUATION 1: The data for a closed traverse are as follows: Course Bearing Distance АВ S W 126.00 m…

A: To Determine Distance of course CD Area of the traverse

Q: Differential leveling between BMS A, B, C, D, and A gives elevation differences (in meters) of…

A: To determine the adjusted elevation of BMs for B, C and D.

Q: 2. The elevation of junction point X has been detemined by differential levelling from benchmarks A,…

A: Given data Set ups Elevations Difference in Elevations

Q: Find the elevation of all the stations, determine the misclosure, and adjust the elevations in the…

A: Bench Mark : Bench Mark is a point of reference that is used as the basis for measuring the…

Q: Q.3 A level circuit is shown in figure. The survey, needed for local engineering project, commenced…

A: Calculate the error in elevation of BM 35 Error in elevation of BM 35 = Last RL - first RL =…

Q: Given the closed traverse data. Lines Bearing Distance AB N20o E 20.35…

Q: Benchmark A has an elevation of 437.596 m. What are the most probable values for B, C, D?

A: Solution:

Q: ?What is the elevation of point BM1 in the below table if you know that the elevation of BM2 is…

Q: A slope distance of 465.82m is measured between two points with a slope of 12 35'. Fine the…

A: Given: The slope distance is 465.82 m. The slope angle is θ=12°35'.

Q: Based on the level loop problem. What is the calculated elevation of BM_10 ?

A: Given: The reduced level of BM10 is 701.32'. To Determine: The calculated elevation of BM10.

Q: The Designed point Elevation can be picked off grading plans or could be calculated as in following…

A: Given data- Known elevation (KE) = 130.518 m Horizontal distance (H) = 50.4 m Gradient (g) = +0.5%…

Q: 0.725 on A,0.935,2.845,3.745,3.935,0.965,1.135,1.785,2.625,3.845,0.965,1.575 and 2.015 on B. The…

A: Here they ask to find RL's, Also calculate the gradient of line AB.

Q: Determine the slope correction for steep slope and the horizontal distance AB if two lines AC and…

Q: 8. This method of traverse adjustment does not conform to any mathematical equations it simply…

Q: A6) Answer the following situations; a) A 50-m course, AB, on a level ground was placed by a…

Q: The baseline AB of a triangulation system is equal to 400 m long. Stations Cand D are other points…

Q: The cross section notes of the ground surface at a given station of a road survey shows that the…

A: A1 (area at 1st station) = 32m2 A2 (area at 2nd station) = 64m2

Q: BC (m) 8.26 FS (m) Elevation (m) 458.45 STATION 1 2.39 2.26 9.98 12.87 8.65 3. 11.36 5.32 45

A: To find the solution, I have used Rise and Fall method. Please refer the below mentioned table

Q: A docs.google.com =6 To establish a new benchmark on point B using a levelling instrument. The work…

Q: Problem 2. A parcel land has been surveyed in the field and the lengths and bearings of the various…

Q: GIVEN: G.=-3.5% ELEV V = 71.50 L= 800 m G. = + 4.5 % STA V= 10 + 00

A: PVCSTATION=PVISTA-L2L=1000-L2=6+00PVCELV=PVIELV-g1L2PVCelv=71.5+0.035×8002PVCelv=85.5mEquation of…

Q: Q.3 A level circuit is shown in figure. The survey, needed for local engineering project, commenced…

A: Given Data: At BM 35 the fixed elevation is 185.00 m At BM 35 the measured elevation is 184.933 m…

Q: .5 Prepare a set of profile leveling notes for the survey in Figure 2-34. In addition to comput- ing…

Q: At Station A reading the leveling rod at point B 1.762, rod reading of 2.165 m, and an angle of is…

A: Hi, Solution as follows: Step 1: Calculation of average stadia interval factor: Step 2: Calculation…

Q: STA 8+50 elevation = 132.74 %3!

A: According to given datafor STA 8+50 Elevation=132.74STA 12+ 50 Elevation = 246.29To calculate the…

Q: ROD AT B 1.600m ROD AT C 0.300m Compute the stadia interval factor.

A: Solution : Given, For point B, D=150 m and S=1.600m For point C, D=30m and S=0.300m

Concept explainers

State Plane Coordinate Systems

The state plane coordinate system (SPCS or SPS) is a collection of 124 coordinate systems or geographic zones prepared for particular regions of the U.S. Every state consists of one or more than one state plane zone, the boundaries of which generally follow the county lines. Inside the U.S., there are 110 zones in total, 10 more zones in Alaska, 5 in Hawaii, and 1 for Puerto Rico and US Virgin islands. The system is extensively used for geospatial and geographic data assembling by the state and local governments.

Question

A surveyor made 4 different routes of level from Point A to Point B.
The elevation at A is 250 m and is lower than Point B.
DISTANCE (km)
ROUTE
DIFF IN ELEV (m)
+ 0.85
+ 0.70
+ 0.55
1.
2
7
3
4
4
+ 0.80
What is the most probable elevation at B?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Q3. If the known benchmark elevation is 102.5 ft. When surveying you find the rod reading at PT. A is 4.89 ft, PT. B is 3.65 ft, PT. C is 7.18 ft, and the rod reading at the benchmark is 5.32. What is the elevation of PT. A, B and C. 1IP age
A close traverse has the following data: COURSE BEARING DISTANCE (m) N 9.27° E S 88.43° E N 86.78° E S 5.2° E 1-2 58.7 2-3 27.3 3-4 35.2 4-5 35 5-1 3. Determine the length of course 5-. A. 62.5m B. 24.3m C. 75.1m D. 78.9m 4. Determine the bearing of the course 5-1. A. N 17.943° E D. N 72.057° E B. S 72.057° W C. S 17.943° W
8. A civil Engineer proceeded to do the stadia survey work to determine the topography of a certain area. The transit was setup at a point A, with the line of sight horizontal, took rod readings from the rids placed at B and C which is 200 m and 60 m from A respectively. Compute the stadia interval factor. Stadia intercept at 8 = 2.001 m and the stadia intercept at C is 0.600 m. a. 100.00 -b. 101.28 C. 99.93 d. 110.17
Geometric space, i need solutions in 15 minutes please. MCQ/ To establish a new benchmark on point B using a levelling instrument. The work had been done between B.M1 and B.M2 to the required point B, and the surveys were recorded as in the tables below. Calculate the best. Value of elevation for point B. A-39.97m B-40.95m C-45.98m D-44.37m E-46.97m F-41.97m G-43.67m
FIGURE 2-33 2.5 Prepare a set of profile leveling notes for the survey in Figure 2-34. In addition to comput- ing all elevations, show the arithmetic check and the resulting error in closure. 5.11 4.66 3.98 1.20 1.80 VA 4.42 4.30 2.01 TP 2 4.72 Known Elevation is 402.78 TP 1 BM 61 Elevation = 396.74 FIGURE 2-34 Leveling 57 T=ם בהבה - GL + I 09 + 1 00 + 0+50 00 +
Draw a free body diagram; Topic Surveying Trigonometric leveling A trigonometric leveling was performed in the field, the two points A and B of a certain rough terrain are each distance 1500 m from a third point C, from which measured vertical angles to A is +4°30' and to B is +1°30'. Elevation at C is known to be 125.75 m above sea level. Point C is in between A and B. a) Compute the difference in elevation between A and B considering the effect of the earth's curvature and refraction., b) Compute the difference in elevation between B and C. c) Compute the elevation of A.
3. A closed traverse has the following data. Find the bearing of line AB and the length of line BC. Solve for the Area of this traverse using the DPD Method. LINE AB BC CD DE EA DISTANCE 44.47 ? 12.83 64.86 107.72 BEARING ? N57°11'W N1°45'E N72°10'E S 48°13'E
Triangulation stations A,B,C and D has the following observation angles. Angles: ACB=50° BAD=20° BCD=30° ABC=50° CAD=60° a. Find the angle CBD. b. Find the angle BDA. C. Find the angle BCD.
Layout by coordinates method: Given are the coordinates of two points P1 and P2. It is required to layout point P2 from an instrument set up at Point P1. P1 P2 Northings (m) Eastings (m) 456.34 567.45 398.12 485.70 6. Determine the bearing to layout point P2. a) S 60°55' W b) N 60°36' W 7. Compute the distance to layout point P2. a) 140.45m b) 100.36m c) N 70°10' W c) 129.90m d) S 54°33' W d) 110.30m
20. Determine the area of the given traverse using DPD and DMD Method. LINE BEARING DISTANCE S 36°46'W N 57°11'W AB 44.84 BC CD 136.56 N1°45'E 12.03 N 72°10'E S 48°13'E DE 64.80 EA 106.72
2. Given the following data of a closed traverse. LINE BEARING DISTANCE АВ N 38°29' E 33.00 BC S 54°23' E 31.55 CD S009' W 34.20 DE S 77°19' W 26.39 EA a. Compute the bearing of line EA. b. Solve for the distance of line EA. c. Compute the area of the traverse using DPD Method.