A structural beam is built from steel with a yield strength of 345 MPa. The structure has a minimum service temperature of 5 oC, where the fracture toughness of the steel KIC = 60 MPam. What is the minimum surface crack lengths that must be detected by quality control to ensure that the full yield strength of the steel is available in the beam? Assume geometric parameter Y = 1 and plain strain conditions. Answer in millimeters.

Q: For steel, the energy to produce tensile failure is 105Jm 2 (i.e. fracture energy), modulus of…

A:

Q: A plate with width w = 90 mm and thickness t = 5 mm carries a uniformly distributed tensile force P…

A: Given data:To determine:The minimum required critical stress intensity factor (KIc) for mode I (in…

Q: A stress-strain diagram for a tension test of an alloy steel sample is shown in the diagram below.…

A: Stress-Strain curve describes the relationship between stress and strain under a certain load in…

Q: An 820 MPa (145,000 psi) stress is applied to a specimen of 4341 steel alloy, which has a plane…

A: Given Data

Q: Crack Strain Energy Release Rate in Cracked Tension Rod. In the below, the crack growth in an…

A:

Q: You are given a 10-cm-diameter cylindrically shaped extruded bar (length = 50 cm) of an aluminum…

A: The anisotropic fracture toughness behavior should be an exhibit by the extruded bar with the lowest…

Q: What is the magnitude of the having a radius of curvature o tensile stress of 140 MPa is ar 4.

A: 4. Given              Normal stress = 140 MPa            Crack length, a = 3.8 x 10-2 mm Radius of…

Q: Consider a solid bar with 1.00 in diameter subjected to a bending moment, M, and a twisting moment,…

A: The diameter of the solid bar is .The moment and twisting moment are equal in magnitude..The failure…

Q: A hot rolled steel tension test sample has a diameter of 6 mm and the original gage lenght of 30 mm.…

A: Original diameter of the specimen, Do=6mm Original Length of the specimen, Lo=30mm Fracture…

Q: Consider the tensile stress-strain diagram below. If samples 1 and 2 are identical except that they…

A: From given stress strain diagram,it is required to determine which sample tested at lower…

Q: A material has a yield strength of 1150Mpa and a fracture toughness of 47 Mpa m^1/2. If the applied…

A: Data Given : We need to find the internal crack that can lead to failure.

Q: Will fracture occur for a material exposed to a tensile stress of 900 MPa if the material has a…

A:

Q: A machine component is made of Aluminium alloy having an ultimate tensile stress Ou = 350MPa, a…

A: Given data:Ultimate tensile stress = Fracture toughness = Geometry factor = Cyclic tensile stress =…

Q: Q1. A typical graph of strain (e) versus time for a metal under creep conditions is shown below. င်…

A: DISCLAIMER FOR MULTIPLE Since you have asked multiple question, we will solve the first question for…

Q: A ceramic part for a jet engine has a yield strength of 66,215 psi and a plane strain fracture…

A: GivenYield strength=66215psiplane strain fracture toughness=5000psiin12

Q: A tensile test specimen of stainless steel alloy having a diameter of 0.495 in. and a gage length of…

A:

Thermal Properties of Materials

In mechanical engineering, the thermal property is represented as the physical quantity that is relevant to the application of heat. The thermal properties are evaluated by variations in any specific material due to low heat or high heat. The quantities that influence the thermal property of the materials are mass, density, temperature, and many others.