A straight 100 m long raw water gravity main is to carry water from an intake structure to the jack well of a water treatment plant. The required flow through this water main is 0.21 m³/s. Allowable velocity through the main is 0.75 m/s. Assume f = 0.01, g = 9.81 m/s2. The minimum gradient (in cm/100 m length) to be given to this gravity main so that the required amount of water flows without any difficulty is

A straight 100 m long raw water gravity main is to carry water from an intake structure to the jack well of a water treatment plant. The required flow through this water main is 0.21 m³/s. Allowable velocity through the main is 0.75 m/s. Assume f = 0.01, g = 9.81 m/s2. The minimum gradient (in cm/100 m length) to be given to this gravity main so that the required amount of water flows without any difficulty is

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A triangular shaped channel having a slope of 0.0001with a depth of 1.215 m..It is made of timber with n=0.012.Calculate the discharge of the channel using the best hydraulic or the most economical triangular section Select one: O a. 0.4371 cu m/s O b. 0.6982 cu m/s O c. 0.5892 cu m/s d. 0.6434 cu m/s O e. 0.3092 cu m/s
Water discharges in too wide rectangular channel slope =0.01 Just apstream the weir where the water depth is 2.5m the flow rate is 5m ^ 3/s As per meter width as shown below Assume n = 0.015 and neglected losses. 1. Find the normal depth, the critical depth and the critical slope? 2. Use the specific energy equation to find the weir height such that the flow over the wer is critical? 3. What water surface profile exists upstream the weir and locate the distance upstream the weit where the water depth equals the normal depth ?
C1
a rectangular section 3 meters wide carries a flow of 5.60 m3/sec. calculate the critical slop if n = 0.010
2
1- Uniform flow passes through a rectangular channel having a width of 4 m. The channel carriers a discharge of 12 m³/s with a depth of 3 m at section 1. The bed is raised in section 2 by 20 cm and the velocity distribution changes due to bed roughness. Note: The energy loss is 10% of the velocity head at section 2. Velocity profile in section 2 can be expressed by a linear equation as v ky2. a) Write the energy equation b) Calculate the flow depth at section 2 c) Calculate the Froude number at sections 1 and 2 of Side vehw Y/₂ Az
A 3m wide rectangular channel carries a flow of 6m³/s. The depth of flow at a section P is 0.5 m. A flat-topped hump is to be placed at the downstream of the section P. Assume negligible energy loss between section P and hump, and consider 'g' as 9.81 m/s². The maximum height of the hump (expressed in m) which will not change the depth of flow at section Pis mm.
Solve fast like within 30 minutes.
A trapezoidal channel has a bottom width of 6 m and a side slope of 1:1. The depth of flow is 2 m at a discharge of 24 m3/s. What would be the specific energy? Consider g=10 m/s2.
e10
2. For an incompressible and Newtonian flow, show that: