A Stereo (i.e., two channels) audio signal with each channel having a bandwidth of 20 kHz needs to be sampled at a rate equal to 1.1 their Nyquest rate, and then quantized using 16 bits for transmission of a channel. Determine the following: Minimum data rate (in bits/s) that the transmitter must have to be able to transmit this stereo audio signal. Amount of data (in bits) that will be generated from this signal over a duration of 1 hour and 8 minutes (Note: this is approximately the capacity of a standard Audio CD).

A Stereo (i.e., two channels) audio signal with each channel having a bandwidth of 20 kHz needs to be sampled at a rate equal to 1.1 their Nyquest rate, and then quantized using 16 bits for transmission of a channel. Determine the following: Minimum data rate (in bits/s) that the transmitter must have to be able to transmit this stereo audio signal. Amount of data (in bits) that will be generated from this signal over a duration of 1 hour and 8 minutes (Note: this is approximately the capacity of a standard Audio CD).

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

7) Suppose we have a message signal that is a sinusoid and we quantize it using a quantizer of L levels. Assuming that the quantization error for each sample is uniformly distributed in the interval , determine the signal to quantization noise ratio (SNR) in terms of L. Determine the SNR in terms of L if the message is changed to a triangular wave, again assuming that the errors are uniformly distributed.
9) An analog signal contains frequencies up to 10 kHz. (a) What range of sampling from its samples? frequencies allows exact reconstruction of this signal om t (b) Suppose that we ample this signal with a sampling frequency fs = 8 kHz. Examine what happens to the frequency f₁ = 5 kHz. (c) Repeat part (b) for a frequency f2 = 9 kHz.
To put it another way: A BTS broadcasting information with 10 W of output power at 1800 MHz can only cover half the area as a BTS transmitting at 900 MHz. Describe the benefits and drawbacks of using the 1800 MHz BTS to cover the same area as the 900 MHz BTS.
What are the similarities and differences between the information signal m (t) obtained as a result of demodulation and the original information signal m (t) on the modulation side? (first one is original signal)
4. A modulated signal (AM) varies between the maximum values of +18V and -18V, if the carrier has an amplitude of 12V, a) What is the modulation index? b) What is the maximum magnitude of the modulator? c) Sketch the envelope of the modulated wave
An AM signal is provided below. The carrier frequency is 500 Hz, and the modulating signal is a single-tone sinusoidal signal. The x-axis is in time while the y-axis is the amplitude of the AM signal. Answer the following questions with appropriate solutions if applicable. Determine the type of AM signal in the figure. Determine the frequency of the message signal in Hz. Determine the peak voltage level of the carrier in V. Determine the peak voltage level of the modulating signal in V. Determine the modulating index. Determine the power of the unmodulated carrier in W. Assume the load resistance to be 1-ohm. Determine the power of sidebands in W.
determine the basic concept of radar transmission and detection of rf signal. Illustrate with labels
P4/ Calculate the approximate bandwidth (in Hz) for the modulated signal of an FM modulator whose message signal, m (t), is a 4 V and 20 Hz test tone. The deviation constant of Modulator frequency is 25 Hz/V.
Frequency spectrum of a signal is given as the following: a) Write an equation for the signal x(t) defined by this frequency spectrum. b) What is the minimum sampling frequency to sample this signal? c) Write x[n] after the signal digitized by an ADC with a sampling frequency of 2 Hz.
An analog signal having a maximum frequency of 10 kHz is being transmitted through a PCM system with a uniform quantizer having 256 levels. What will be the minimum transmission bandwidth of the transmitted PCM signal?
Obtaining broadband FM signal from narrowband frequency modulated (FM) signal is shown below. The narrowband FM signal has a maximum frequency deviation of 100 Hz. The frequency of the local oscillator is f0=100 kHz. Obtaining broadband FM signal from narrowband frequency modulated (FM) signal is shown below. The narrowband FM signal has a maximum frequency deviation of 100 Hz. The frequency of the local oscillator is f0=100 kHz.Since the broadband FM signal has a carrier frequency of fc=80 MHz, find the N value.