Answered: A steel ring with a hole having area of… | bartleby

Related questions

Question

100%

A steel ring with a hole having area of 3.990 cm^2 is to be placed on an aluminum rod with cross-sectional area of 4.000 cm^2.Both rod and ring are initially at a temperature of 31°C .At what common temperature can the steel ring be slipped onto one end of the aluminum rod?

Expert Solution

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

Suppose you have a ring of a metal with a1 = 2 x 10° (C0)-1. You wish to put it around a pipe made of metal with az = 3 x 10-6 (C)1. If at 25 Co the inner radius of the ring is 10.0 cm and the outer radius of the pipe is 10.001 cm, what is the temperature that will allow you to slip the ring around the pipe?
Older railroad tracks in the U.S. are made of Part A 12-m-long pieces of steel. When the tracks are laid, gaps are left between the sections to prevent buckling when the steel thermally expands. If a track is laid at 16° C, how large should the gaps be if the track is not to buckle when the temperature is as high as 50° C? The coefficient of linear expansion of soft steel is 1.1 × 10-5 °C-1. Express your answer with the appropriate units. HẢ .... Value %3D Submit Previous Answers Request Answer
A bubble having a diameter of 62 cm is re- leased from a depth of 4.6 m from the bottom of a swimming pool. The temperature of the water at the surface is 21°C, whereas it is 15°C at the point of release. What will the diameter of the bubble be when it reaches the surface? The acceleration of gravity is 9.8 m/s² and the density of water is 1000 kg/m³. Answer in units of cm.
A pair of eyeglass frames are made of an epoxy plastic (coefficient of linear expansion = 1.30 10-4°C-1). At room temperature (20.0°C), the frames have circular lens holes 2.40 cm in radius. To what temperature must the frames be heated if lenses 2.41 cm in radius are to be inserted into them?
Two rods, one made of brass and the other made of copper, are joined end to end. The length of the brass section is 0.200 m and the length of the copper section is 0.800 m. Each segment has cross-sectional area 0.00700 m^2. The free end of the brass segment is in boiling water and the free end of the copper segment is in an ice-water mixture, in both cases under normal atmospheric pressure. The sides of the rods are insulated so there is no heat loss to the surroundings. What mass of ice is melted in 6.00 min by the heat conducted by the composite rod?
At a temperature of 22.00°C the hole in a steel plate has a diameter of 1.040 cm. If a steel rod with a diameter of 1.049 cm has to just slip through this hole, to what temperature should the plate be heated? The coefficient of area expansion of steel is 24 ✕ 10−6/°C. ________________________ °C
Warm air flows through a rectangular, uninsulated heating duct in your cold attic during the winter. The air has a mass flow rate of 0.47 kg/sec, and the heating duct has dimensions of 20.0cm by 28.0cm with a length of L = 9.60m. The inlet temperature of the air is 42.0°C, at a pressure of 1.00 atm. Your cold attic keeps the surface temperature of the duct at a temperature of 8.0°C. Find the heat transfer rate.