A steam power plant shows in Figure Q2 operating on the ideal reheat Rankine cycle. Steam enters the high-pressure turbine at 15 MPa and 600 °C and is condensed in the condenser at a pressure of 10 kPa. If the moisture content of the steam at the exit of the low-pressure turbine is not to exceed 9.55 percent, determine: a) The pressure at which the steam should be reheated, and b) The thermal efficiency of the cycle. 15 MPa High-P Low-P T, °C A turbine turbine Reheating 5 600

A steam power plant shows in Figure Q2 operating on the ideal reheat Rankine cycle. Steam enters the high-pressure turbine at 15 MPa and 600 °C and is condensed in the condenser at a pressure of 10 kPa. If the moisture content of the steam at the exit of the low-pressure turbine is not to exceed 9.55 percent, determine: a) The pressure at which the steam should be reheated, and b) The thermal efficiency of the cycle. 15 MPa High-P Low-P T, °C A turbine turbine Reheating 5 600

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

B- Consider a steam power plant operating on the simple ideal Rankine cycle. Steam enters the turbine at 3 MPa and 350 °C and is condensed in the condenser at a pressure of 75 kPa. Determine the thermal efficiency of this cycle.
Consider a steam power plant operating on the ideal Rankine cycle. Steam enters the turbine at 3 MPa and 350°C and is condensed in the condenser at a pressure of 10 kPa. Determine
There is a simple real rankine cycle, in which the steam enters the turbine with a pressure of 5MPa and a temperature of 500°C. The working pressure of the condenser is 20kPa. The mass flow of steam 35.4 kg/s. The Isoentropic efficiency of the turbine is 88% And the isoentropic efficiencyof the pump is 84%. Determine: a) The thermal efficiency of the cycle b) The net power produced by this cycle
In a steam plant operating according to an ideal Rankine cycle, water vapor enters the turbine at a pressure of 3.0 MPa and a temperature of 600 oC and exits the turbine with a dryness of 100 kPa and 0.8. By removing heat from the condenser to the surrounding environment, the water is provided to be saturated liquid at 100 kPa. In this case, what would be the amount of heat released from the Condenser to the surrounding environment per unit mass?
Consider a steam power plant operating on a simple ideal Rankine cycle. Steam enters the turbine at 15 MPa and 650°C and is condensed in the condenser at a pressure of 15 kPa. Determine the thermal efficiency (%). (Use 2 decimal places for the final answer.)
Consider a steam power plant operating on a simple ideal Rankine cycle. Steam enters the turbine at 15 MPa and 650°C and is condensed in the condenser at a pressure of 15 kPa. Determine the Qin (kJ/kg). (Use 2 decimal places for the final answer.)
Thermodynamics question Consider a steam power plant operating on the simple ideal Rankine cycle. Steam enters the turbine at 3 MPa and 350 °C and is condensed in the condenser at a pressure of 10 kPa. If line number 1 is saturated liquid and assuming 100% isentropic efficiency of the turbine and the pump. Determine: A-work produced in the turbine per unit mass, B-The thermal efficiency of this cycle, C-The heat lost from the condenser, D-maximum possible efficiency of the cycle.
A simple steam power plant uses water as the working fluid and operates on the simple ideal Rankine cycle. The boiler operates at 15000 kPa and the condenser at 30 kPa. Show the cycle on a T-s diagram with respect to saturation lines and determine the phase change in each state, the minimum temperature required at the turbine inlet such that the mixture at the exit of the turbine is not lower than 80 percent and the thermal efficiency of the cycle
Consider a 210-MW steam power plant that operates on a simple ideal Rankine cycle. Steam enters the turbine at 10 MPa and 500C and is cooled in the condenser at a pressure of 10 kPa. Determine the Qout (kJ/kg).(Use 2 decimal places for the final answer.)
This is thermodynamics 2
A steam power plant operates according to the reheat Rankine cycle between the pressure limits of 15 MPa and 10 kPa. The mass flow rate of the steam circulating in the cycle is 12 kg/s. The steam enters both stages of the turbine at a temperature of 500 °C. The dryness fraction of the steam at the exit of the low-pressure turbine is 90%. Show the cycle on a T-s diagram, including the saturated liquid and saturated vapor lines. Also, determine: a) The pressure at which reheat occurs, b) The amount of heat supplied to the steam per unit time in the boiler, c) The thermal efficiency of the cycle. Note: This is a question from the thermodynamics course. Please provide a clear and quick solution.