A speech signal, band limited to 4 kHz, is sampled at 1.25 times the Nyquist rate. The speech samples, assumed to be statistically independent and uniformly distributed in the range -5 V to +5 V, are subsequently quantized in an 8-bit uniform quantizer and then transmitted over a voice-grade AWGN telephone channel. If the ratio of transmitted signal power to channel noise power is 26 dB, the minimum channel bandwidth required to ensure reliable transmission of the signal with arbitrarily small probability of transmission error (rounded off to two decimal places) is kHz.

A speech signal, band limited to 4 kHz, is sampled at 1.25 times the Nyquist rate. The speech samples, assumed to be statistically independent and uniformly distributed in the range -5 V to +5 V, are subsequently quantized in an 8-bit uniform quantizer and then transmitted over a voice-grade AWGN telephone channel. If the ratio of transmitted signal power to channel noise power is 26 dB, the minimum channel bandwidth required to ensure reliable transmission of the signal with arbitrarily small probability of transmission error (rounded off to two decimal places) is kHz.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

4
If in a communication system BPSK, QPSK, QASK-8 are used for transmission and reception of digital data. (a) Determine the bandwidth B for each modulation scheme for a bit rate of 2kbps (b) Determine the symbol distance for each modulation scheme providing its complex plain presentation in terms of bit energy E (c) Determine the number of symbol and the symbol rate for each modulation.
Exxplain the rellation between BER and E/N_0, where E is the energy per bit,N_0 is the noise spectral density, BER is the bit error rate. What is the reason for usign channel coding?
Type your question here A DSB - SC receiver shown in figure below. The channel noise PSD is 7/2 with 7 = 10-7. The PSD of the modulating signal f(t) is shown in the other %3D figure: (a) Determine the receiver output noise power S. (b) Determine the receiver noise output power No. (c) If the output SNR is required be at least30dB, determine the minimum value of (x) and corresponding power of (t).
i need the answer quickly
A 3 kHz bandwidth signal is sampled at rate of 1.5 nyquist rate. if the maximum quantization error is 1% of the peak mp. Find the minimum channel bandwidth to transmit the encoded signal.
[Q2] Sixteen signals, the bandwidth of each one is 8kHz, are to be transmitted simultaneously by TDM-PCM. The average SN,R is at least 43dB. Determine the output data rate, and the minimum Dandwidth required for the transmitted signal.
What is meant by the envelope of the AM signal? How can it be described mathematically? M SUVA
A certain sampled-data system operates at a sampling rate of 10,000 sample/s. For Each case below, draw the sampled signal's spectrum up to the 2nd translated component with the corresponding appropriate frequency values.a. Determine the theoretical highest frequency in a baseband signal such that the signal could be reconstructed from samples taken by the system.b. Repeat part (a.) if a guard band of 4 kHz is to be established between the upper range of the baseband signal and the lower range of the first translated component. c. If for the same sampling rate a 6 kHz signal sampled, what range of frequencies will there be spectral overlapping?
Telecommunications 2
A signal xi(t) is band-limited to 4.5 kHz and the three other signals x2(t), x3(t), and x4(t) are band-limited to 1.5 kHz each. Assume these signals are transmitted by TDM. A. Set up a scheme TDM for realizing this multiplexing requirement with each signal sampled at the Nyquist rate. B. Identify the required speed of the commutator in samples/sec. C. Identify the minimum bandwidth requirement of the channel.
Q4) A-Ten telephony signals that have the same limited Bandwidth frequency of 2000Hz are sampled equally by the Nyquist rate, then TDM multiplexed and transmitted simultaneously in one channel. Calculate 4 a The time spacing between adjacent samples. b. The minimum required Bandwidth for TDM transmission. c. The minimum required sampling rate (Nyquist rate) of the resultant TDM signal. (06