Answered: A solid sphere, a ring, and a solid… | bartleby

Related questions

Question

100%

A solid sphere, a ring, and a solid disk start rolling down an incline plan at θ=20 degrees simultaneously. All three start a the same height of h= 3.0 m relative to the ground. All three of them have a radius, R= 0.5 m and a mass, m= 2.0kg. Calculate the acceleration of each object and determine which reaches the ground first.

Expert Solution

Trending now

This is a popular solution!

Step by step

Solved in 6 steps

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

A gyroscope has a disk of mass mm and radius of 31 cm that spins at 34 rev/s. The center of mass of the disk is a distance of 15 cm from the point where axis is in contact with the surface of a table. What is the precession angular velocity of the gyroscope in radians per second?
A compact disk on a CD player rotates clockwise. The disk completes one revolution in 0.332 s. (a) Find the angular velocity of the disk. Magnitude? (b) Find the speed of a point on the disk 4.73 cm from the axis of rotation.
A box of unknown mass is suspended from the end of a strong, thin wire. The other end of the wire is wrapped around the outer rim of a solid disk whose massis 11.0 kg and radius is 54.0 cm. The disk turns on a frictionless axle through its center. The box travels a distance 12.0 m during a time interval of 3.40 s starting from rest.Find the mass of the box.
An object is traveling around a circle with a radius of 12 centimeters. If in 10 seconds a central angle of 17 radian is swept out, what are the linear and angular speeds of the object?
A can of juice rolls down a ramp with angle 65 degrees. If the slope were frictionless the can would slide down the incline without rolling. Calculate the minimum coefficient of static friction needed for the can to roll down the incline. Model the can as a cylinder of mass 1100 g, radius 20 cm and length 22 cm. Hint: Use Newton's Second Law
You visit a friend in Grand Rapids, MI, where – in the middle of the night, you decide to construct a pendulum consisting of a heavy metal stick of mass 2 kg and length 1 m with a solid silicon sphere at the end. The mass of the sphere is 0.4 kg, and its radius 20 cm as shown below. If the pendulum is released from rest at an angle of 30°, what is the angular velocity at the lowest point? 5. Axis 1 m, 2 kg 30° 0.3 kg, 20 cm radius
A 234 kg boat is negotiating a circular turn (radius = 33.1 m) around a buoy. During the turn, the engine causes a net tangential force of magnitude 995 N to be applied to the boat. The initial tangential speed of the boat going into the turn is 20.6 m/s. Find the angular velocity after 2.5 seconds. Use g=9.8
John wanted to measure the objects angular speed at the bottom of the hill. He built the inclined frictionless ramp of height d, release the object from the top, and measure the angular speed at the Bottom. First, John released a hollow sphere [Ip(2/3) mr^2] from the rest. The diameter and the mass of the sphere were 317 cm and 45.2 kg, respectively. How much was the angular speed John measures at the bottom of the incline he built. Tip: the object rotates down the incline without slipping. Use following values: d=3.57 m and g=9.80 m/s^2
What is the linear speed due to the Earth’s rotation of a point on the Earth (latitude 36.0 N)? The mean radius of the Earth is RE = 6.38 × 106 m, T = 24 hours.
Your grandmother enjoys creating pottery as a hobby. She uses a potter's wheel, which is a stone disk of radius R = 0.540 m and mass M = 100 kg. In operation, the wheel rotates at 45.0 rev/min. While the wheel is spinning, your grandmother works clay at the center of the wheel with her hands into a pot-shaped object with circular symmetry. When the correct shape is reached, she wants to stop the wheel in as short a time interval as possible, so that the shape of the pot is not further distorted by the rotation. She pushes continuously with a wet rag as hard as she can radially inward on the edge of the wheel and the wheel stops in 6.00 s. You would like to build a brake to stop the wheel in a shorter time interval, but you must determine the coefficient of friction (?k) between the rag and the wheel in order to design a better system. You determine that the maximum pressing force your grandmother can sustain for 6.00 s is 65.0 N. What If? If your grandmother instead chooses to press…
The motion of spinning a hula hoop around one's hips can be modeled as a hoop rotating around an axis not through the center, but offset from the center by an amount h, where h is less than R, the radius of the hoop. Suppose Maria spins a hula hoop with a mass of 0.72 kg and a radius of 0.65 m around her waist. The rotation axis is perpendicular to the plane of the hoop, but approximately 0.43 m from the center of the hoop. (a) What is the rotational inertia of the hoop in this case?(b) If the hula hoop is rotating with an angular speed of 13.1 rad/s, what is its rotational kinetic energy?
An object is traveling around a circle with a radius of 9 feet. If in 20 seconds a central angle of 13 radian is swept out, what are the linear and angular speeds of the object?

SEE MORE QUESTIONS