A solenoid with an air gap of 1-10 (cm) has a radius a and a winding number N Since the self inductance of this solenoid is L-134 (HL. the radius x number of turms a Nis how many meters x tums). 6-4n 10 H/m)

Q: 4i R1 ww 58(1) V =1F ER2 Remark1: 0nly numeric values must be entered. Do not enter the units. (ex:…

A:

Q: please write the solution on paper.

A: In this question we need to find a inductance and phase angle between the current and the source…

Q: An air-core toroidal ring with a mean diameter of 4 cm is wound uniformly with 500 turns of a wire…

A:

Q: Inductance of the coil is given by O a. L= 10/N O b. L = NO /T en O c. L= NOI O d. L= NO /I If the…

A:

Q: How many turns must be wound to obtain an air-core toroid with an average radius of 10 mm and a…

A: Difference between Solenoid and Toroid:  A large no of turns are wound in a core. The wire is…

Q: 9. [(2260)/(15Z-75)]+[(1.2+j1.2)/(4.2+j2.4)]

A:

Q: 6- Let S = 120 cm², d = 4 mm, and ER = 12 for a parallel-plate capacitor. a) Calculate the…

A:

Q: Two coupled coils of L1=0.8 H and L2=0.2 H have a coupling coefficient K=0.8. What will their mutual…

A: Given: L1=0.8 HL2=0.2 HK=0.8

Q: root locus

A:

Q: Q1) A parallel plate capacitor with separation between plates is 3mm, contain a two dielectric with…

A: The solution can be achieved as follows.

Q: . An ideal conductor of 50mH is connected in series with 175 micro farad capacitor. The combination…

A: 6) Given: An ideal conductor of 50mH is connected in series with 175 micro farad capacitor. The…

Q: Inductance is often described as . (circle all that apply) The ability of a component to oppose a…

A: 1) The ability of component to opposes a change in current

Q: An air filled parallel plate capacitor is arranged such that the upper plate carries surface charge…

A: Given data is- Upper plate surface charge density ρs1=1 C/m2  lower plate surface charge density…

Q: V1 + V₁ = 33, 80/0° L₁ = 2je C₁ = -5jN L1 R1 10 www I Vx www R2 392 C1 ww R3 20 0,75 VX

A:

Q: 1. The inductance of a single layer solenoid is 5 mH. Find the value of inductance when the number…

A: We need to find out inductance for given number of turn and length

Q: Self inductance of an inductor with toroidal geometry is 268 mH. The total number of turns of this…

A: Inductance Total number of turns Current flowing through inductor

Q: A non magnetic medium has an intrinsic impedance 360Z30° Q. The loss tangent is

A: Wave is function of space and time. Frequency below which attenuation occur and above which…

Q: 5. 15cis60+35cis210

A: It is given that: I=15cos60°+35cos210°

Q: shunt

A: In this question, we have to find out which element accounts for losses due to leakage current...

Q: Inductance of a solenoid of N turns varies as 1 (d) 7/² (b) N² (c) √ N (a) N (b) N²

A: The inductance of solenoid is directly proportional to the square of the solenoid turns (N).…

Q: What is the magnitude of the moment done by the force about the "z-axis" in the following figure. A…

A: Given:F=60i-80j-20kN

Q: EX for finding the capacitance of Coaxial cable Let the potential between the two conductors is Vo…

A:

Q: Find the mutual inductance between an infinitely long wire and a rectangular wire with dimensions…

A: Suppose current in wire is I and Given diagram is –

Q: Determine the mutual inductance of the following geometry.

A: To find mutual inductance Flux (flux linkage) expression is where

Q: HW.sA long solenoid that has loo0 turns distributed overalenyth of a-4 m producesanaguetic field of…

A:

Q: CONVERT THE GIVEN COMPLEX NUMBERS: 1. A = 6+ 7i POLAR FORM 2. B = 5230 → RECTANGULAR FORM 3. C = 15…

A:

Q: Noise due to inductive coupling can be reduced by twisting the wires carrying a signal. True False

A: In radio frequency when disturbance in external source affects the electrical circuit by…

Q: For the circuit shown in Figure 1, determine the value of inductor, L, if the total inductance, Lris…

A:

Q: Q4. Drive a format the aapacilance of infiniti lenth Coaxial cable and then find the Capacilance of…

A: Given,The length of the cable is,L=8mandεr=3a=1mmb=3mmc=4mm

Q: (6) A parallel-plates capacitor with plate area of 100 cm? has a separation of 3mm between the…

A: Solution A Given ;Each slab distance (d)  =1mm d =10-3 m Area (A )= 100 cm2A =100x10-4 m2A = 10-2…

Q: A symmetrical toroidal coil is wound on a plastic core (μr ≡ 1) and is found to have an inductance…

A: Given Relative permeability of plastic and Relative permeability of ferrite μrp≅1μrp=200 Inductance…

Q: Three identical capacitors of 10 micro farad are connected in delta across a 410 volts, 50HZ,…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: If a 19 m/s wind is blowing on a wind turbine and the tips of its blades are rotating at 62 m/s,…

A: Need to find tip speed ratio

Q: A. For the following figure, the diameter of each conductor is 2.5 cm. Find the inductance and…

A:

Q: A parallel plate capacitor has plates of area 2 m' speed by three layers of differrent dielectric…

A:

Q: Give the reason why a dielectric material increases capacitance compared with what it would be with…

A: The solution is given below

Q: Determine the capacitance of the given spherical cross section as shown in figure below with the…

A:

Q: B. Determine the value of the following capacitor: No. Barrier Value Capacitance

A: The tolerances of capacitors can be found by the last Alphabet on label. a) so the value of…

Q: Step 1 : Show that the voltage division rule for two capacitors in series as in the figure Step 2:…

A: In this question We need to determine the voltage across the capacitors. If they are connected in…

Q: What is the angle between (-2.5 + j4.33) and (4.33 - j2.5)?

A:

Dielectric Breakdown

A dielectric is a material with low electrical conductivity and so is classified as an insulator. Dielectric materials are used to block the flow of electricity through them, allowing them to behave as an insulators. They can also be used to store electric charge or improve capacitance.Dielectrics have no free electrons for conduction because electrons are tightly bound to the nucleus. Because dielectrics contain a small number of electrons for electrical conductivity, they have a dipole. The two primary roles of dielectrics in electrical devices are insulation and electrical energy storage. An electric field polarizes the dielectric, and the polarization of the molecules allows dielectric materials to store charge.