A solenoid is positioned with its axis on the y-axis as shown. The current I= 10 A and itsradius is 0.1m. It has 100 turns. Solve for the flux density at point 0.0.1m0.3m0.2m

Given: Current, I=10 A Radius, r=0.1 m No. of turns, N=100 Length of solenoid, L=0.2+0.3=0.5 m…

Answered: A solenoid is positioned with its axis…

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

An infinitely long filament on the x-axis carries a current of 10 mA in the k direction. FindH at P(3, 2,1) m
Suppose in the figure that the four identical currents i = 14 A, into or out of the page as shown, form a square of side 70 cm. What is the force per unit length (magnitude and direction) on the wire in the bottom left hand corner? (N/m) Take the positive y direction as up and the positive x direction as to the right.What is the magnitude of the force per unit length? Check the units for MKS. Incorrect. Tries 2/4 Previous Tries What is the x component of the force per unit length? Tries 0/4 What is the y component of the force per unit length? Tries 0/4
A stream of singly charged ions is ejected from the sun with a number density of 8.70 cm-3. The stream travels at a speed of 470.0 km/s until it strikes the circular face of a spacecraft which has a radius of 1.50 m. How much current flows onto the spacecraft?
A cylindrical wire carries a steady current density modeled as J(r) = Cr², where ris radial distance from 1.5 mm. If 15.0 C of charge flows through the wire in 5.0 s, center of the wire. The radius of the wire is R determine C.
For a solenoid in vacuum of length l = 10 cm with 104 turns per meter calculate the current required to create the field B= 70 μT. Provide your answer in SI units.
The figure below is a cross-sectional view of a coaxial cable. The center conductor is surrounded by a rubber layer, an outer conductor, and another rubber layer. In a particular application, the current in the inner conductor is I, = 1.16 A out of the page and the current in the outer conductor is I, = 3.18 A into the page. Assuming the distance d = 1.00 mm, answer the following. 12 (a) Determine the magnitude and direction of the magnetic field at point a. 2.32 magnitude If you construct an imaginary circle of radius d passing through point a, how much current passes through this circle? uT direction upward (b) Determine the magnitude and direction of the magnetic field at point b. 1.34 magnitude You can approach this problem by finding the field produced by current I, and the field produced by I1, and then adding them vectorially. UT direction downward
A copper wire with a square cross-section (side length 5.00 µm) is next to an iron wire with a rightward current of 3.00 A. The two wires are parallel over a region of 20.0 cm, where they are 1.60 cm apart. The iron wire produces a magnetic field on the copper wire. The copper wire is connected to a 5.00 V power source, with current directed rightward. Data of copper: resistivity = 1.68 x 10-8 Ohm m; free electron number density = 8.50 x 1028/m3
The figure below is a cross-sectional view of a coaxial cable. The center conductor is surrounded by a rubber layer, an outer conductor, and another rubber layer. In a particular application, the current in the inner conductor is I, = 1.16 A out of the page and the current in the outer conductor is I, = 2.90 A into the page. Assuming the distance d = 1.00 mm, answer the following. d d (a) Determine the magnitude and direction of the magnetic field at point a. magnitude HT direction -Select--- (b) Determine the magnitude and direction of the magnetic field at point b. magnitude UT direction ---Select---
The figure below represents a section of a circular conductor of nonuniform diameter carrying a current of I = 4.90 A. The radius of cross-section A, is r = 0.250 cm. Az (a) What is the magnitude of the current density across A1? A/m2 The radius r, at A2 is larger than the radius r, at A1. (b) Is the current at A, larger, smaller, or the same? The current is larger. O The current is smaller. The current is the same. (c) Is the current density at A2 larger, smaller, or the same? O The current density is larger. The current density is smaller. O The current density is the same. Assume A2 = 2A1. (d) Specify the radius at A2. mm (e) Specify the current at A2. A (f) Specify the current density at A2. A/m2
The two wires shown in the figure below are separated by d = 10.4 cm and carry currents of I = 5.40 A in opposite directions. Two vertical, parallel wires are separated by a distance d. To the left of the left wire is an arrow labeled I pointing up. To the right of the right wire is an arrow labeled I pointing down. A point P2 is a distance 2d to the left of the left wire, and a point P1 is a distance d to the right of the right wire. (a) Find the magnitude and direction of the net magnetic field at a point midway between the wires. magnitude ?T direction (b) Find the magnitude and direction of the net magnetic field at point P1, 10.4 cm to the right of the wire on the right. magnitude ?T direction (c) Find the magnitude and direction of the net magnetic field at point P2, 2d = 20.8 cm to the left of the wire on the left. magnitude ?T direction
A cube has two rings on opposite faces of the cube. The rings carry equal currents i. The rings are sized such that their diameters are equal the side length of the cube s. What is the field strength in the center of the cube if the currents run such that the field strength is as big as possible? Start with a derivation of B from a ring. Please include a diagram for the problem.
Two VERY LONG wires are placed along parallel lines as shown below in the picture. The wire ON THE LEFT (at X:= 0) has a current going out of the page of value, I1 ='4 A. The current on the RIGHT (at X2= d) has a current going into the page of the page of value, l2 = 6 A. The point "P" is at the location (x=6.00cm, z=10.4cm) Wire 1 Wire 2 a. Find the magnitude of the magnetic field due to wire 2 at the location of wire 1 The Biot-Savart law say the direction of the magnetic field at a field point located in a direction (from source to field point) where a source wire carries a current in the î is Pxi the direction of the magnetic field due to wire2 at the location of wire1. c. Using the formula format find the force per unit length in "I.j,k" 1, 1, x B, d. Find the magnitude of the magnetic field due to wire2 at the location of field point P e. Find the unit directions for f and î and perform the cross product to determine the direction of the magnetic field due to wire2 at the…

SEE MORE QUESTIONS

Recommended textbooks for you

College Physics

Physics

ISBN:

9781305952300

Author:

Raymond A. Serway, Chris Vuille

Publisher:

Cengage Learning

University Physics (14th Edition)

Physics

ISBN:

9780133969290

Author:

Hugh D. Young, Roger A. Freedman

Publisher:

PEARSON

Introduction To Quantum Mechanics

Physics

ISBN:

9781107189638

Author:

Griffiths, David J., Schroeter, Darrell F.

Publisher:

Cambridge University Press

College Physics

Physics

ISBN:

9781305952300

Author:

Raymond A. Serway, Chris Vuille

Publisher:

Cengage Learning

University Physics (14th Edition)

Physics

ISBN:

9780133969290

Author:

Hugh D. Young, Roger A. Freedman

Publisher:

PEARSON

Introduction To Quantum Mechanics

Physics

ISBN:

9781107189638

Author:

Griffiths, David J., Schroeter, Darrell F.

Publisher:

Cambridge University Press

Physics for Scientists and Engineers

Physics

ISBN:

9781337553278

Author:

Raymond A. Serway, John W. Jewett

Publisher:

Cengage Learning

Lecture- Tutorials for Introductory Astronomy

Physics

ISBN:

9780321820464

Author:

Edward E. Prather, Tim P. Slater, Jeff P. Adams, Gina Brissenden

Publisher:

Addison-Wesley

College Physics: A Strategic Approach (4th Editio…

Physics

ISBN:

9780134609034

Author:

Randall D. Knight (Professor Emeritus), Brian Jones, Stuart Field

Publisher:

PEARSON

SEE MORE TEXTBOOKS

A solenoid is positioned with its axis on the y-axis as shown. The current I= 10 A and its radius is 0.1m. It has 100 turns. Solve for the flux density at point 0. 0.1m 0.3m 0.2m