A soil sample is of 300 cc volume having void ratio 0.6. Calculate the weight in the given soil sample if specific gravity of solid is 2.7 506.25 gm 187.5 gm 256.94 gm 69.44 gm

Following results are obtained for a liquid limit test using a fall cone device. Estimate the liquid limit of the soil and the flow index.

The subsurface characteristics for a highway pavement rehabilitation project in the southeastern United States are shown in a boring log in Figure 5.13. The highway structure consists of the asphalt pavement underlain by four different soil strata up to a depth of 20 ft, after which the boring was terminated. Some data on the grain size and plasticity characteristics are also provided for each stratum. Perform the following tasks: 1. Determine the AASHTO soil classification and the group index (GI) for each layer. 2. Determine the most probable group symbols and group names for the various layers according to the Unified soil classification system. Use Table 5.3 and the soil characteristics given in the boring log.

How is the plasticity index of a soil determined?

The properties of seven different clayey soils are shown below (Skempton and Northey, 1952). Investigate the relationship between the strength and plasticity characteristics by performing the following tasks: a. Estimate the plasticity index for each soil using Skemptons definition of activity [Eq. (4.28)]. b. Estimate the probable mineral composition of the clay soils based on PI and A (use Table 4.3) c. Sensitivity (St) refers to the loss of strength when the soil is remolded or disturbed. It is defined as the ratio of the undisturbed strength (f-undisturbed) to the remolded strength (f-remolded)) at the same moisture content [Eq. (12.49)]. From the given data, estimate f-remolded for the clay soils. d. Plot the variations of undisturbed and remolded shear strengths with the activity, A, and explain the observed behavior.

Refer to Problem 2.C.1. Results of the sieve analysis for Soils A, B, and C are given below. To obtain a more representative sample for further geotechnical testing, a ternary blend is created by uniformly mixing 8000 kg of each soil. Answer the following questions. a. If a sieve analysis is conducted on the mixture using the same set of sieves as shown above, compute the mass retained (as a percentage) and cumulative percent passing in each sieve. b. What would be the uniformity coefficient (Cu) and the coefficient of gradation (Cc) of the mixture?

For a soil, given: D10 = 0.08 mm D30 = 0.22 mm D60 = 0.41 mm Calculate the uniformity coefficient and the coefficient of gradation of the soil. 2.4 Repeat Problem 2.3 for the following: D10 = 0.24 mm D30 = 0.82 mm D60 = 1.81 mm

In AASHTO, which group are the following soil likely to fail into? a. A well-graded gravel with approximately 10% fines b. A well-graded sand with approximately 10% fines c. A uniform fine sand d. A high plastic clay

The particle characteristics of a soil are given below. Draw the particle-size distribution curve and find the percentages of gravel, sand, silt, and clay according to the MIT system (Table 2.3).

Repeat Problem 2.11 with the following data. 2.11 The grain-size characteristics of a soil are given in the following table. a. Draw the grain-size distribution curve. b. Determine the percentages of gravel, sand, silt, and clay according to the MIT system. c. Repeat Part b using the USDA system. d. Repeat Part b using the AASHTO system.