A smooth thin plate 5 m long and 1 m wide is placed in air streamed moving at 3 m/s with its length parallel with the flow. Analyse the drag force on each side of the plate. The density of the air is 1.2 kg/m³ and the kinematic viscosity is 1.6 x 10-5 m²/s.

A smooth thin plate 5 m long and 1 m wide is placed in air streamed moving at 3 m/s with its length parallel with the flow. Analyse the drag force on each side of the plate. The density of the air is 1.2 kg/m³ and the kinematic viscosity is 1.6 x 10-5 m²/s.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: Consider the geometry sketched. The velocity of the upper plate is 200 ft/s, and the two plates are…

A: Given data Viscosity of air at the given temperature is

Q: Calculate thickness of the boundary layer (in metre) under laminar flow condition when distance from…

A: Calculate thickness of the boundary layer (in metre) Given dataX=2.61mRe=3000

Q: ninar flow o ver a flat plate thickness at the end of th for the same free stream v watcr and air…

Q: A 0.75 m by3m flat plate is towed at 5 m/s on a 2.5-mm-thick layer of SAE-30 oil at 38°C, with…

Q: The local atmospheric pressure of Karabuk is 98.39 kPa. Air at this pressure and at 25°C flows with…

A: To determine the friction coefficient for the flow of air over a flat plate, we can use the concept…

Q: Air at 30oC (density=1.165 kg/m3, kinematic viscosity = 16x10-5 m2/s) flows over a flat plate at a…

A: Given:Air temperature, T=30oCAir density, ρ=1.165 kg/m3Kinematic viscosity, ν=16*10-5 m2/sFree…

Q: 3-Air flows over the flat plate at velocity 3 m/s and ambint temperature 15 C.The plate is maintaned…

Q: Consider laminar boundary layer flow over a flat plate as shown in the figure (top view). Ignoring…

Q: the boundary layer

A: given:dynamic viscosity μ =1.79 x 10-5 kg/msvelocity V=37m/slength L=1.6m

Q: Q5-Air at 27-C and 1 atm flows over a flat plate at a speed of 2 m/s. The viscosity of air at 27-C…

A: Step 1: Step 2: Step 3: Step 4:

Q: A 20 °C water flows to 50cmx60cm flat plate with velocity of 6m/s . The flat plate surface…

Q: Experimental studies have shown that the rate of the decay of kinetic energy for homogeneous…

A: Experimental studies have shown that the rate of the decay of kinetic energy for homogeneous…

Q: A 1 m wide and 3 m long flat plate, held stationary, parallel to the flow direction of a uniform on…

A: find the drag coefficient on the plate.

Q: A flat plate with surface area of 3.4 m2m2 is sliding on a horizontal table with 4.2 mmmm thick oil…

Q: IS ading edg

Q: A 0.8-m-outer-diameter spherical tank is completely submerged in a flowing water stream at a…

A: Write the expression of the Reynold number. From the corresponding Reynold number, the coefficient…

Q: d determine the boundary layer thickness and re the values with values calculated using laminar flo

Q: 5. The local atmospheric pressure in Denver, Colorado (elevation 1610 m) is 83.4 kPa. Air at this…

A: To find: (a) The drag force acting on the top surface of plate, if the air flows is parallel to the…

Q: Assume the critical Reynolds number for the flow to be considered as laminar over a flat plate is 5…

A: Step 1: Step 2: Step 3: Step 4:

Q: Q4 : Air is flowing over a long flat plat velocity 8 m/s . Determine the distance from the leading…

A: Let x = distance from leading edge U =Velocity=8m/s ν =Kinematic viscosity =1.798X10-5 m2/s…

Q: Wind flows over a flat plate of length L = 25 mm and width W = 8 mm. The plate is maintained at a…

Q: Air flows over a stationary flat plate at speed of 4,3 m/s. Plate has a width of 1 m. Air has a…

Q: A 20 °C water flows to 50cmx60cm flat plate with velocity of 3m/s . The flat plate surface…

Q: 2. You are working for a glider manufacturer and have been asked to analyse the laminar boundary…

A: For the solution refer below images.

Q: Water at a velocity of 1.0 m/s flows along the length of one side of a flat plate that is 2 meters…

Q: 4. During a cold winter day, wind blows parallel to a 4 m high and 10 m long wall of a house. If the…

A: Given: The height of wall is h=4 m The length of wall is L=10 m The temperature of air is T∞=5°C.…

Q: A flat plate ( 1.5 m ) long and ( 1.5 m ) wide is towed in water ( ρ = 1000 kg/m3 and ν=1.31 * 10 -6…

A: Given data:

Q: In your own words, list at least three “red flags” to look out for when performing laminar boundary…

A: Red flags while performing laminar boundary layer calculations: 1). Boundary layer calculations are…

Q: Air flows over a stationary flat plate at speed of 4,3 m/s. Plate has a width of 1 m. Air has a…

Q: Local boundary layer effects, such as shear stress and heattransfer, are best correlated with local…

A: From the turbulent flat plate theory, the relation between the momentum thickness to the boundary…

Q: ing statements given about the laminar boundary layer on a flat plate are true or false. a) when…

A: given: Write in the boxes on the side that the following statements given about the laminar boundary…

Q: Explain the 'flow separation phenomena' for flow over a cylinder in cross flow. Can flow separation…

A: When a fluid flows over the surface of a body it will remain attached to the body surface. But…

Q: ted by the simple linear expression, u = Uy/ displacement thickness and momentum thic e values of…

A: The displacement thickness is-The expression for the momentum thickness -

Q: (a)kinematic viscosity for air 17,6*10-6 m2/s (b) kinematic viscosity for CO2 9,07*10-6 m2/s (c)…

Q: You are working for a glider manufacturer and have been asked to analyse the laminar boundary layer…

A: The objective of the question is to analyze the laminar boundary layer on a glider's wing. We are…

Q: Define a Newtonian Fluid, and with the aid of a sketch, explain the no-slip boundary condition and…

A: The different phenomenon are explained below with proper diagrams.

Q: Air is flowing at a speed of 5 m/sec between two parallel flat plates. The air temperature is 20o C…

A: Write the given data with suitable variables. v=5 m/sT∞=20 °CP=1 atmT=90 °Cd=60 cm=0.6 m100 cm1 mb=1…

Q: The thickness of the laminar boundary layer over a flat plate at two different sections Pand Q are…

Q: ution in the boundary la elocity V was observed hen the power loss pe

Q: A flat plate has been placed longitudinally in a stream of crude oil which flows with a velocity of…

A: Length of the plate, L=500 mm=0.5 mWidth of the plate, w=250 mm=0.25 mVelocity of crude oil, U=6…

Q: Wind flows over a flat plate of length L = 25 mm and width W = 8 mm. The plate is maintained at a…

Q: Light oil at 75°F flows over a 22-ft-long flat plate with a free-stream velocity of 6 ft/s.…

A: Given data: Length of plate, L = 22 ft Stream velocity, V = 6 ft/s Temperature, T = 75°F

Q: Water at 25°C is flowing over a flat plate creating a turbulent boundary layer. A distance of 1 cm…

A: Given:The flow over plate is turbulent.So,Reynold's number is greater than 5×105Distance marked as…

Q: Engine oil at 40°C flows over a 20-m-long & 3-m-wide smooth flat plate with a free-stream velocity…

Q: a) Air at 30°C (density=1.165 kg/m³, kinematic viscosity = 16x105 m²/s) flows over a flat plate at a…

A: According to question:- density of airρ=1.165kg/m3kinematic viscosity of airν=16×10-5m2/sfree-stream…

Question

b.
A smooth thin plate 5 m long and 1 m wide is placed in air streamed moving at 3 m/s
with its length parallel with the flow. Analyse the drag force on each side of the plate.
The density of the air is 1.2 kg/m3 and the kinematic viscosity is 1.6 x 10-5 m²/s.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

You are working for a glider manufacturer and have been asked to analyse the laminar boundary layer at a certain point on the smooth wing. The velocity profile at this point, ?(?), is given by:? =3A?C" −2A?C# +?A?C+? ?! δ δ δwhere δ is the boundary-layer thickness and ?$ is the velocity at the edge of the boundary layer. ? and ? are constants.Determine the values of ? and ? such that the primary boundary condi9ons for the velocity profile are sa9sfied. Is it necessary to apply any auxiliary boundary condi9ons?Evaluate the boundary-layer shape factor, H.At the point of separa9on, the wall shear stress goes from posi9ve to nega9ve. Thus, show that the boundary layer at this loca9on is on the point of separa9ng.Show that the pressure on the wing surface is increasing with downstream distance. Is this consistent with your calcula9ons showing that the boundary layer is approaching separa9on? Explain your reasoning.
None
A 1.5-m-long and 0.5 m wide flat plate is immersed in water flow with velocity of kg 5 m/s. (F = 1000 =1.02 x10- m Determine; (a) The boundary layer thickness at leading edge of the plate, (b) The drag coefficient and the drag force, (c) the drag coefficient and force, if the flow is laminar at the entrance (Rex, ait= 106), (d) the drag force, if the roughness height & is 0.2 mm on the plate.
Show that the pressure on the wing surface is increasing with downstream distance. Is this consistent with your calculations showing that the boundary layer is approaching separation? Explain your reasoning.
5. The local atmospheric pressure in Denver, Colorado (elevation 1610 m) is 83.4 kPa. Air at this pressure and at 25°C flows with a velocity of 9 m/s over a 2.5-m x 5-m flat plate. Determine the drag force acting on the top surface of the plate if the air flows parallel to the (a) 5-m-long side and (b) the 2.5-m-long side.
Q1- Air at 27°C and 1 atm flows over a flat plate at a speed of 2 m/s. Calculate the boundary- layer thickness at distances of 20 cm and 40 cm from the leading edge of the plate. The viscosity of air at 27°C is 1.85×105 kg/m. s. density of air 1.177kg/m³
Describe (i) Navier-stokes equation (ii) turbulent flux
Evaluate the boundary-layer shape factor, H.
Assume velocity distribution in laminar boundary layer over flat plate to follow the law. u/U= sin(ny/28) obtain expressions 8/0 and 8/x. 25
f5
From Table the drag coefficient of a wide plate normalto a stream is approximately 2.0. Let the stream conditionsbe U∞ and p∞. If the average pressure on the front of theplate is approximately equal to the free-stream stagnationpressure, what is the average pressure on the rear?