A small building has a heat gain input of 4250W. The desire internal temperáture is 21°C and the air can be introduced into the inlet at 18°C. If the pressure difference across the buiding is 15 Pa, and the volumetric specific heat capacity of air 1200 J/m"C. Calculate the area of inlets assuming that the totalinlet and outlet areas are the same

Q: Unit of convection heat transfer coefficient is, 1. W/m2k 2. W/mk 3. j/mk 4. None of the above

A: Heat transfer coefficent is defined as the proportionality constant between the heat flux and the…

Q: (3.4) The gas heater shown below in cross-section consists of a square sheet-metal duct insulated on…

A: a) given = Heat transfer fluid data T1 = 500 K T2 = 450 Kh1 = 200 W/m2K f1 = 0.00035 m2K/w Process…

Q: 7-2, Losses by Natural Convection from a Cylinder. A vertical cylinder 76.2 mm in diameter and 121.9…

A: The radiation heat loss is neglected. The mean of the given two temperatures will be the film…

Q: Consider the cylindrical pipe shown in the figure. Heat is being generated in the pipe wall at a…

A: To find:i. The expression for the temperature distribution in the pipe wall.ii. The heat transfer…

Q: Steam at 140 ° C flows in a pipe having an inner radius of 45 mm and an outer radius of 55 mm. The…

A: The rate of heat transfer through a pipe is calculated as, Q=Ti-To1Aihi+ln(ro/ri)2πkwL+1Aoho Where,…

Q: 3. An array of 10 silicon chips, each of length L = 10 mm on a side, is insulated on one surface and…

A: If the temperature of each chip may not exceed 80 degree C, the maximum allowable power per chip is…

Q: A petrochemical storage tank is cylindrical in shape with a diameter of 6 m and a height of 10 m.…

A: Calculate the characteristic length of the cylinder as shown below:

Q: - Hot water at 60 °C is routed from one 3. External flow (cylinder in cross flow with tube walls,.…

A: Given information:   The initial temperature of the hot water, TH = 60°C Fluid transfer occurs…

Q: 1. A flat plate of width 1 m is maintained at a uniform sur- face temperature of T, = 150°C by using…

A: a.The required power generation, q (W/m3), in a module positioned at a distance 700 mm from the…

Q: A process stream is cooled from 80C to 40C in a shell-and-tube heat exchanger using cooling water in…

A: Part (a) For the given shell and tube heat exchanger, the amount of heat released from the hot…

Q: 5. A two-pass shell-and-tube heat exchanger cools a hot liquid process stream (120 to 140 C inlet…

A: Given: Process fluid in at 120 to 140 °C Process fluid out at 70 °C Cooling water available at 20 °C…