A small box of mass 7 is given a speed of = Figure 419 gr at the top of the smooth half cylinder shown in (Figure 1). 1 of 1 Part A 0 Determine the angle at which the box leaves the surface. Express your answer in degrees using three significant figures ΔΙΑΣΦΩΤ vec 0= Submit Provide Feedback Request Answer

Q: A 1.8 kg solid sphere (radius = 0.10 m ) is released from rest at the top of a ramp and allowed to…

A:

Q: Is the speed of A 2x as fast as B?

A: All points on the tunable rotate through the same angle in the same time, so the angular velocity of…

Q: A rod of length L lies along the x axis with its left end at the origin. It has a nonuniform charge…

A: Linear charge density is defined as charge per unit length and is given by: λ=QL with the unit of…

Q: A 160 lb man carries a 20 lb can of paint up a helical staircase that encircles a silo with radius…

A: The man makes exactly three complete revolutions, therefore the angle is The parametric equation of…

Q: A bowling ball of mass 7.28 kg and radius 11.0 cm rolls without slipping down a lane at 3.00 m/s .…

A: The moment of inertial of the ball about the center is I=25mr2

Q: Two cylinders made of the same material roll down an incline. Both cylinders start at the same…

A: Assume that two cylinders of same material rolls down an inclined plane from same height. Assume…

Q: Q3. A car has a 750-kg body, four 20-kg wheels, and a 70-kg driver. The wheels are 1 m in diameter…

A: Mass of the car=750 Kg Mass of the four wheels=4×20=80 Kg Mass of the driver=70 Kg Total mass of the…

Q: You need to design an industrial turntable that is 67.0 cmcm in diameter and has a kinetic energy of…

A:

Q: C F2 Figure above shows a thin converging lens for which the radii of curvature are R1 =12.0cm and…

A:

Q: Baby Huey rolls a rubber ball (a hollow sphere) of mass M and radius R up a hillside, giving it an…

A:

Q: Charur Part 11 of 11 - Analyze Now Chandra and Darcel decide to try a problem. Suppose that the…

A:

Q: QUESTION 7 A point mass held by the thread revolves around a fixed axis, and the tension of the…

A:

Q: Velocity Task Introduction: The pedal of a bicycle is attached to a crank arm that revolves when the…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub parts…

Q: For the block shown in the figure below, the 40 lb. force is passing through points EF, the 50 lb.…

A: Given: The force passing through the point EF is F1 = 40 lb The force passing through the point JB…

Q: For the following position [r] and force [F], determine the angle and the magnitude of the force…

A:

Q: 8) Consider two vectors A and B where: A = -6.00 î + 3.00 ĵ + 3.00 k B = 6.00 i – 8.00 j+ 4.00 k If…

A:

Q: A small block slides out along the slot in the disk with a speed of † = 4t m/s ( t is in seconds)…

A: we are given radial velocity of block r˙=4t m/s angular velocity of disc θ˙=6 rad/s radial position…

Q: Mark bought a pizza of a radius of 0.5 m. A fly land on the pizza and walks around the edge for a…

A:

Q: Please help: A. Calculate the speed of the disk in conceptual example 10-17 at the bottom of the…

A:

Q: . Determine whether the following linearly independent: f1 are COS X and f2 Cos 2x.

A:

Q: The spool has a mass of 90 kg and a radius of gyration of kg = 0.3 m. Figure 250 mm G A 400 mm 1 of…

A:

Q: The top point on a 64-cm-diameter rolling bicycle wheel has an instantaneous speed of 14 m/s.

A: Required  The number of revolutions in 13 s.

Q: Use the following constants if necessary. Coulomb constant, k = 8.987 × 10° N · m² /C¥acuum…

A: Given, B1=5.8 TB2=8.3 Tq=9.7 μCm=0.037v=41 m/s

Q: travels in a straight line with a constant speed v- 11.6 m/s. For the instant depicted, determine…

A:

Q: A cylinder of weight 5000 N and radius 600 mm is resting against a rectangular block as shown in the…

A:

Q: Velocity Task Introduction: The pedal of a bicycle is attached to a crank arm that revolves when the…

A: Given: The diameter of the wheel is 66 cm, The radius of the crank arm is 18 cm, pedal of the ground…

Q: A car is headed north at 79 km/h. If the car makes a 90° left turn lasting 21 s, determine the…

A:

Q: A circular disc of muss lokg + sadius 0.2m is set into rotation about an axis passing through its…

A: We need to compute-Angular velocity of disc (ω)=?The data given as-Mass of disc (M)=10 kgRadius…

Q: Velocity from position The graph of s = ƒ(t) represents the position of an object moving along a…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: turn In a typical kitchen blender, when it off, its angular velocity decreases you final 220 rev/min…

A: Given:-  The initial angular velocity ωi= 570 rev/min  = 9.5 rev/sec  The final angular velocity ωf=…

Q: Determine the moment of inertia (mm4) of the cross section shown with respect to the y-axis if…

A: Simple problem of Moment of Inertia. Please have a good look

Q: A pendulum swings as pictured. How fast was it moving at the bottom of its travel if at the top it…

A:

Q: What will be the cross product of the vectors 2i + 3j + k and 3i +2j + k? O2i +3j +k Oi+ 2j + k O 2i…

A:

Q: The spool has a mass of 90 kg and a radius ke = 0.3 m. (Figure 1) gyration • Part A If the…

A: This problem is basically from rigid body dynamics. Please have a good look

Q: The angle between two unit vectors is 1.1 radians. What is the dot product of these two unit…

A: Given data:  Two unit vectors Angle (θ) = 1.1 rad Required: The dot product of the these unit…

Q: etermine the omogeneous mm. Give your

A: Given Data The width of the section is:b=5.25 mm The depth of the section is:d=12.75 mm To find:…

Q: Equation of the parabola in (Figure 1) is y= (400-2²). dy = 50 mm. Figure < 1 of 1 Part A Determine…

A:

Q: A 150-lb man carries a 10-lb can of paint up a helical staircase that encircles a silo with radius…

A: The man makes exactly three complete revolutions, therefore the angle is  3×2π=6π The perimetric…

Q: A 220 g block on a 60.0-cm-long string swings in a circle on a horizontal, frictionless table at…

A: Mass of block  m= 220g = 0.22kg Length of string R = 60cm = 0.60m R. P. M = 65 = w

Q: For the section shown, find the second moment of area about axis XX 25.0 mm 3.0 mm 18.0mm 5.0 mm

A:

Q: The member shown below is fixed at O and its dimensions are h1 = 1.10 m, h2 = 0.20 m, and w = 0.50 m…

A: Given h1 = 1.10 mh2 = 0.20 mw  = 0.50 mF  = 51 N

Q: For the dm shown, what is the distance r from the axis of rotation (the y axis) to dm in terms of x,…

A: Given that:

Q: Member AB has the angular velocity WAB = 4.5 rad/s and angular acceleration = 6 rad/s². (Figure 1)…

A:

Q: A bowling ball encounters a 0.760-m vertical rise on the way back to the ball rack, as the drawing…

A: According to the conservation of energy at the top and bottom,…

Q: A hollow spherical ball is let go from the top of a track and goes around a circular loop (R = 60…

A: The radius of the circular loop:

Q: A projectile is shot directly away from Earth's surface. Neglect the rotation of Earth. (a) As a…

A: According to the question, the projectile shot directly away from the earth's surface.   a) The…

Central Force

Central force is the force that acts along the center of mass of one body to the center of mass of another body. Its direction from or away from a point on a body to another is called the center of the force. Such forces include gravitational force between two massive objects or electrostatic forces between two charged particles. So from atoms to planets, the central forces play an important role in shaping our daily lives. One of the remarkable features of central forces is that they are conservative, i.e. the total energy of a central force system can always be expressed as a gradient of a potential energy function.