A sinusoidal voltage is 20 V has a time of 5 ms. peak-to-peak, between consecutive peak and trough, and at t = 0 is -3.6 V and decreasing. Find the equation for the instantaneous value of the voltage.

A sinusoidal voltage is 20 V has a time of 5 ms. peak-to-peak, between consecutive peak and trough, and at t = 0 is -3.6 V and decreasing. Find the equation for the instantaneous value of the voltage.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.27P: An industrial load consisting of a bank of induction motors consumes 50 kW at a power factor of 0.8...

See similar textbooks

Related questions

Q: 1. Construct the logic gates and obtain its final output stream. B. (rO f)s + (5 +t)r

A: Given: The logic expression is Y=r⊕ts¯+s¯+tr¯

Q: Two point charges (C₁ and C₂) are fixed as shown in the setup below. Now consider a third test…

Q: Use Source Transformation to solve for Vo. V. 4 mA 6 kN 2 kn 4 kn 5V ww

Q: Consider a periodic signal g(t) as shown in Figure Q3 (a). Find the trigonometric Fourier series.

A: The given signal g(t) isWe need to find the trigonometric Fourier series of g(t).

Q: 3.1 Find in From the circuit in Figure 3. 3.2 Find Q b ww Σ10 Ω ข้อที่ 3 รูปที่ 3 10 mH 3.3 If a…

Q: The impulse response of the system is given as c(t) = -4e-²¹ +6e 4. The step response of the same…

A: Given:The impulse response of the system To determine: The unit step response of the system

Q: Consider the LTI system defined by Eq. (1) y/n] + 2y[n- 1] = z{n] +2r[n-2). (a) Sketch the block…

A: Difference equation

Q: hi please answer. thanks

A: 3) a) Break even point=Total fixed costRevenue per unit-Variable cost per unit Revenue per unit,…

Q: 24.31 Faraday's law characterizes the voltage drop across an in- ductor as di V = L dt where V =…

A: The voltage across the inductor and capacitor can be calculated by using the general expression and…

Q: Q26 a). An alternating valtage is given by v=200 sin(350 nt +0.45) volts. Find (i) Peak to Peak…

Q: Question: A capacitive displacement sensor, which works by measuring change in capacitance from the…

Q: Q2/A- Starting from Ampere's law in magnetostatic, prove that: 1+ OD aD (V x H = J + at

Q: 4. Find I, and V.. O' 20-15 V ( -j25a vo 3 j 20n

A: In this question, Find the voltage vo and current io? We are solving this problem using the nodal…

Q: Consider the circuit in Figure 20 V 2002 www í Find I1, I2 ↑ I₂ ww 100 Q2 13 www 40 22 using nodal…

Q: 5. Two 10 - 2 parallel resistors are connected in series with a 5 -2 resistor. The combination is…

Q: 2. Consider a wire ribbon made from a 2-dimensional conductor with reciprocal mass tensor with…

A: It is given that: bxx=3,byy=4,bxy=byx=0

Q: Key =93 Consider the circuit shown below. Here, R = 2092, R2 = 1092, ZL = +jKEYN and Zc = -j102. The…

Q: 4. a) Calculate the value of R for maximum power b) What is the maximum power absorbed by R? All the…

A: In this question we will find R for maximum power....And maximum power...

Q: 1. Explain the difference between earth ground and a common reference point ground. 2. Explain how a…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: 7.4.8 Circuit analysis. Give the number of switches in each of the following. a. Register bit b.…

A: Note: Considering a switch that has 2 states - ON/OFF a. The function of the register is to hold…

Q: An FM broadcast-band receiver tunes to 88-108 MHz. Calculate the range of local oscillator…

Q: only code is required no software is used Question 4. For the gate-level circuit shown below, write…

A: Fir gate level modling we use primitives like and or xor xnor not etc

Q: 1. Which of the following methods is not used for starting an induction motor? a) Adding a…

A: There are various methods of starting induction motor. resistance start, capacitor start, rotor…

Q: For a system whose Bode diagram (magnitude) is shown below Bode Plot 80 60 40 20 -20 -40 -60 -80 101…

A: We need to find out phase angle for given input and given bode plot

Q: Use source transformation to convert the circuit to a thevenin equivalent: R1 R2 A 1 32 V1 R3 6V А в…

A: Given:

Q: Find the Thevenin's equivalent across terminals A and B in the figure below when i(t) = 10 cos(wt +…

Q: Switch S was open for a long time. What total amount of charge goes through switch S after the…

A: When the same charge is present in all capacitors, they are said to be in series connection. When…

Q: Calculate the electric field intensity in mV/m. 20 km from a 1-kW source. How many decibels down…

A: Given, Range (r) = 20km, Pt = 1kw, To calculate, Electric field intensity in mV/m, Calculate dB for…

Q: Question 2 Find the gain value for: a) vo/vs (V/V) b) volis (V/A) in the circuit below given that:…

Q: 4.6 Work (a) and (b) with the following truth table: B C 0 0 0 1 1 0 1 1 0 0 0 1 1 0 1 1 A 0 0 0 0 1…

Q: 1. A majority circuit is a combinational circuit whose output is equal to 1 if the input variable…

Q: Key = 93 ohm • Consider a single phase three wire power supply as shown in the figure below. This is…

A: In the circuit, 2 independent voltage sources are supplied to the three resistive load. Find the…

Q: I have 2 VRF heat recovery units with specs as follows: RLA = 0.2 %3D V = 208 PH = 1 HZ = 60 How…

A: As from given data, VRF heat recovery units are working on 208 V, single phase Therefore no.of poles…

Q: Question 25 Think of a way to re-wire the electrical system of this old automobile (with 6-volt…

A: Given circuit is,

Q: A continuous-space signal se is given by Sc(x1, x2) = 100+20cos67x₁ + 40sin (107x1 + 67x2) for -00 ≤…

Q: (c) Given X(z) = (z-0.6)(z-0.2)² a=0. Assume the signal is right-sided. Use the partial fraction…

A: To determine the value of x(n) at n = 0 using the given transfer function X(z), we need to find the…

Q: Q2 (a) Explain the steps required to do analysis using the Superposition theorem

A: Superposition theorem: In any linear, active,bilateral network consisting more than one energy…

Q: PLEASE ANSWER QUICKLY

A: The main differences between AC and DC motors are, 1. The AC(Alternating Current) motors works on AC…

Q: 3. Apply SUPERPOSITION principle to compute current in the 2-ohm resistor. 2 Ohm 24 A 6 Ohm 6A 4 Ohm

Q: P 11.9-11 Determine the coil voltages, V₁, V2, V3. and V4, for the circuit shown in Figure P…

Q: Determine the power and energy for each of the following signals. (a) x[n]=(0.5n +0.2n)u[n] (b)…

A: In this question, Two signals are given. Find the energy and power of the given signals.

Q: Q2 /Answer the following questions Q2/A/ Implement the logic circuit that has the expression below…

Q: Partial shading is a problem that affects the performance of solar modules. Let's imagine a solar…

A: GivenCell open circuit voltage =0.60 VCell short circuit current = 6.2 Atotal cell= 16 (4 x 4)

Q: - EXAMPLE : Design FS by using HS blocks and any gate depending on the Boolean expressions of the…

Question

Please answer. TY.

A sinusoidal voltage is 20 V
peak-to-peak, has a time of 5 ms
between consecutive peak and
trough, and at t= 0 is -3.6 V and
decreasing. Find the equation for
the instantaneous value of the
voltage.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A sinusoidal voltage has a value of 100 volts at 2.5 milliseconds and completes one cycle.It takes 20 milliseconds. Then find the maximum cost and the time to reach it for the first time
A sinusoidal voltage has a value of 100 volts at 2.5 milliseconds and takes 20 milliseconds to complete one cycle. Then find the maximum cost and the time to reach it for the first time.
Draw the sinusoidal waveform of the AC voltage and current for the given loads below. Describe the characteristics of the waveform for each load. A. Pure resistor B. Pure inductor C. Pure capacitor
A capacitor "C", an inductor "L" and a switch "S" are connected in series. When the switch is open, the plate to the left of the capacitor has charge "Qo". The switch is closed the load and current vary sinusoidally with time. Represent graphically the load "Qo" and the intensity of current "I" as a function of time "t", and explain why the current leads the load by a phase difference of 90°.
Find the capacitance if correct will upvote otherwise i will dislike...
A sinusoidal alternating voltage has an r.m.s. value of200 V and a frequency of 50 Hz. It crosses the zero axis in apositive direction when t = 0. Determine (i) the time when volt-age first reaches the instantaneous value of 200 V and (ii) thetime when voltage after passing through its maximum positivevalue reaches the value of 141.4 V.
For the phasor diagram in figure 6 express the voltages in sinusoids for a period of 5ms. Im Re )e,=45° e,=20 Vz=10 V2=8 Figure 7 a. Va(t)=. b. V2(t)=. c. What is the rms voltage of V1 = d. What is the rms voltage of V2=_ e. What is the frequency in Hz = f. What is the angular frequency =. In terms of lagging and leading what is the exact phase relationship between V, (t) and V2(t) g.
The current through the 20-Ohm inductive reactance is given. What will be the sinusoidal expression for voltage.i=-6 sin(wt-30°)
A sinusoidal voltage is given by 20V peak to peak, and has a time of 5 ms between consecutive peak and through, at t = 0 is -3.6 V and decreasing. Find the equation for the instantaneous value of the voltage.
An alternating current varying sinusoidally with a freq. of 50 c/s. has a r.m.s. value of 35 A. Write down the equation for the instantaneous value and find this value at (i) 0.0035 sec. (ii) 0.0135 sec. after passing through a positive max. value.
The single phase AC sinusoidal voltage then the rms value of the voltage v is .........
Electrical generator has coil rotating in a magnetic field to generate sinusoidal voltagewaveform. Sketch and label the sinusoidal voltage waveform when the coil at 0°, 90°,180° and 270° position. Name and briefly describe the physic’s law related to this voltagewaveform generation.