A single stage impulse rotor has a blade ring diameter of 57.5 cm and rotates at a speed of 10,000 r.p.m. The nozzles are inclined at 20o to the direction of motion of the blades and the velocity of the issuing steam is 1,050 m/sec. Determine the inlet blade angle. Assume a friction coefficient of the blading equal to 0.85 and that the inlet and outlet angles are equal. Find also: (a) the power developed at the blades for a steam supply of 1,350 kg per hour (b) the diagram efficiency, and (c) the loss of kinetic energy due to blade friction

Q: The last blade row of a turbine has a relative outlet flow angle of 70 degrees. if the relative…

A:

Q: Turpomachinery   A multi-jet Pelton turbine of 1.47 m wheel diameter operates under a head of 200…

A: A pelton turbine is a tangential flow runner in which water entry and exit is in tangential…

Q: D1/ The folle and a fixed r blade speed angle of the fa factor for all Using a suitat (i) Developed…

A: INTRODUCTION : Steam turbines are the prime movers in which the heat energy of the steam is…

Q: The compression efficiency is fairly constant at 82%. A compressor in this line has two cylinders,…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub parts for…

Q: The velocity of steam existing the nozzle of the impulse turbine is 400m/s. The blades operate close…

A:

Q: 4. A bladed fan rotor with an outside diameter of 12 in. and a 5 in. inside diameter runs at 1725…

A: Step 1: Step 2: Step 3: Step 4:

Q: The first compressor blade pair in a turbojet is to be designed with symmetric blading. If the…

A:

Q: Please answer my quistion. The indicated efficiency of a steam engine is 65 %. The engine entrance…

A: Given, h1 = 2600 kJ/kg h2 = 2100 kJ/kg m˙=3000 kg/hr  ηI=65%ηM=90%

Q: A Pelton turbine is driven by two jets, generating 5.0 MW at 80 rev/min. The effective head at the…

A: Given: The power generated by the Pelton turbine is, P=5 MW. The effective head of the nozzle is,…

Q: An axial compressor with diameter of 0.8 m is being designed to run at 1500 rpm. The inlet guide…

A: Given:The diameter of a compressor is The revolution is The mass flow rate is The rotor blade angle…

Q: Calculate the displacement, the real power and the real torque of an  hydraulic power engine with a…

A:

Q: 3. For a Pelton turbine the pressure of the flow before the nozzle is 5 bar while the velocity of…

A: As given that the pressure before the nozzle(P) = 5 bar ;the velocity of the flow leaving the nozzle…

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.