Answered: A single phase transformer has 500… | bartleby

Related questions

Question

100%

A single phase transformer has 500 turns in the primary and 1200 turns in the secondary. The cross-sectional area of the core is 80 sq. cm. If the primary winding is connected to a 50 Hz supply at 500 V, calculate: (i) Peak flux-density, and (ii) Voltage induced in the secondary

Expert Solution

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

The delta-connected primary of a 5:1 step-down transformer has a delta-connectea secondary and a balanced resistive load. If the line voltage and line current into the primary is 30 V and 5 A, find the secondary line voltage and line current OVLS 3.46 V VLS 10.39 V ILs = 43.30 A ILS - 14.43 A OVLS 6V ILS 25 A VLS=10V ILS-15 A
A transmission line that has a resistance per unit length of 4.20 ✕ 10-4 Ω /m is to be used to transmit 5.00 MW over 400 miles (6.44 ✕ 105 m). The output voltage of the generator is 4.50 kV. (a) What is the line loss if a transformer is used to step up the voltage to 430 kV? kW(b) What fraction of the input power is lost to the line under these circumstances?
A V = 86-V source is connected in series with an R = 1.8-kΩ resistor and an L = 26-H inductor and the current is allowed to reach maximum. At time t = 0 a switch is thrown that disconnects the voltage source but leaves the resistor and the inductor connected in their own circuit. 1) How much time, in milliseconds, is needed for the current in the circuit to drop to 12 % of its value at t = 0? 2) How much energy, in millijoules, does the circuit dissipate during that time?
A step-up transformer is designed to have an output voltage of 2 200 v (rms) when the primary is connected across a 110-V (rms) source. (a) If the primary winding has exactly 70 turns, how many turns are required on the secondary? turns (b) If a load resistor across the secondary draws a current of 1.40 A, what is the current in the primary, assuming ideal conditions? A (c) If the transformer actually has an efficiency of 94.0%, what is the current in the primary when the secondary current is 1.20 A?
A step-up transformer connected to a 190 V line is used to supply a hydrogen-gas discharge tube with 5.6 kV (rms). The tube dissipates 78 W of power. (a) What is the ratio of the number of turns in the secondary winding to the number of turns in the primary winding? N. Np (b) What are the rms currents in the primary and secondary windings (in A)? Ip A Is A (c) What is the effective resistance (in 2) seen by the 190 V source? Ω