A simply supported beam of length “L” is subjected to linearly varying load distribution. The magnitude of the left end of the linearly varying load distribution is Zero and the magnitude of the right end of the linearly varying load distribution is Q. Draw the shear force diagram (SFD) and bending moment diagram (BMD) over the span length and also find the magnitude of maximum bending moment and its position.

Q: A propped cantilever beam is loaded by a bending moment of the magnitude M_B at the point B as shown…

A: For the solution refer below images.

Q: The simply supported beam shown below has distributed load that increases linearly from OkN/m at the…

A: let reaction at A

Q: Draw shear force (V-x) and bending moment diagrams (M-x) for beams and loads in Figure 3.

A:

Q: see the image attached for the diagram thank you :) Determine the values and draw the diagram for…

A:

Q: Calculate the bending moment at point B and upload your file in the next question where you draw the…

A:

Q: A simply supported beam has a span of 10 m and carries loads as shown in figure 1. Neglecting the…

A:

Q: Maximum bending moment: A simply supported rectangular beam that is 3000 mm long supports a point…

A: Write the given data. P=5000 NL=3000 mmb=127 mmh=254 mmd=254 mm

Q: Ore is to be transported along a conveyor belt in a refinery. Figure Q1 shows an idealised beam…

A: Apply force equilibrium in horizontal direction.Apply moment equilibrium about point C.Apply force…

Q: Find Shear force and Bending Moment value at each respective junction. Draw shear V and moment M…

A: Given  over hangin  beam

Q: A thin beam with a solid rectangular cross-section is loaded as shown in Figure Q7 below. W W L/3…

A:

Q: The beam shown below is subjected to a point load of 10kN and a uniformly distributed load of 3kN/m,…

A:

Q: 1. The cantilever beam in Figure 1 is fixed at A, and is loaded with a distributed load from A to B…

A:

Q: Cantilever beam is loaded by three concentrated forces. F, F, F, 2 3 Given: 11 = 10cm; 1 2 = 25cm; l…

A:

Q: Diagram of axial force, shear forces and bending moments for the beam shown in the attached figure…

A:

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.