A simply-supported beam carries a uniform load, w = 143 kN/m at its middle third. If L = 15 m, determine the absolute value of the maximum bending moment in kN-m. A H L/3 + W L/3 + År L/3 Next >

Q: A solid circular cross-section is subjected to a tangential force of 20 kN. Radius of cross-section…

A:

Q: 20 kN/m 30 kN

A:

Q: A beam of span 5 m is simply supported at both ends. It carries a uniform load of 6 kN/m throughout…

A: Length of beam = 5 mUDL on entire span = 6 kN/mSimply supported at both ends.The illustration of the…

Q: W ^^ 3m 6m 3m W 6m 6m

A:

Q: What are the support reactions at points A and B? What is the maximum bending moment and where does…

A: Step 1:Step 2:Step 3:

Q: A solid 200-mm long, 40-mm diameter circular shaft has a modulus of rigidity of 70 GPa and is fixed…

A: Length of shaft L=200mmDiameter of shaft=40mmModulus of rigidity = 70 GpaTorque = 200N-mIt required…

Q: in a real beam, at an end, the boundary condition of zero slope and zero vertical displacement…

A: Conjugate beam method is suitable for both prismatic and non - prismatic beam.

Q: The arched beam in the following figure carries the concentrated vertical forces shown. Determine…

A:

Q: Q3: The beam shown in Figure 3 is subjected the moving load shown. Determine (a) the maximum…

A:

Q: 10' 10' B 30 kips A 14' w = 2 kips/ft + -14'- C

A:

Members with compression and bending

Compression members are structural elements that carry compressive axial force. They are the vertical members of a building that support beams and their design, which is governed by buckling and strength. Columns are known as struct or compression members, which are subjected to compressive forces. These members provide stiffness to the building and avoid any imperfection regarding the transfer of axial load. For instance, webs in a truss, braces in a framed structure, tiers, and so on.