A signal generator is programmed to output a voltage waveform, f(t), pictured on the right. Determine the: f(1) 3+ a. Piecewise representation of f(t) using a set of linear 2 equations (??, a

Q: What will be the modified form of the codeword is even parity is used: 011010

A: When parity is used, then the parity bit is added to the left-most position of the bitstream.  In…

Q: Explain the successive approximation

A:

Q: What is the clipped value?

A: Diode- When diode is forward biased it is short circuited in a circuit ideally. When diode is…

Q: difference between measurement uncertanty and measurement error

A: Given : Need to find the difference between measurement error and uncertainty.

Q: Write down the short note on Inter symbol interference.

A: In the telecommunication , Inter symbol interference is a methodology of distrotion,  in which a…

Q: Dot-matrix printers are usually print at speeds of between ________________characters per second. 10…

A: Dot-matrix printers are usually print at speeds of between ________________characters per second. A)…

Q: Electronic resources are always considered untrusted resources TRUE OR FALSE

A: Electronic resources are the ones that can be accessed using internet. These include e journals ,…

Q: When making a flowchart what does this symbol stand for? Select one: a. Decision b. None of the…

A:

Q: Can you type it down how you did it with calculation and stuffs

A: Asked to find vn by calculation method

Q: Electronic What is Polymorphism. What is Mailbox.

A: The System Verilog provide dynamic array construct. In packed array one location and whole location…

Q: Discuss in detail about the evolution of electrical/ non-electrical Communication methods and…

A: Electrical and non-electrical methods if you consider the ancient days they used dove for their…

Q: Draw the Direct Digital Control block diagram and show the Implementation of the Problem using a…

A: The block diagram of the direct digital control is shown below,

Q: Perform the following numbering conversion and arithmetic. Show all the steps clearly. [Laksanakan…

A: i) Given hexadecimal number shown 12BF.FC916

Q: Explain the successive approximation type ADC with neat schematic diagram

A: We need to explain about succesive approximation type of ADC with a block diagram

Q: Please explain how the schematic diagram (NAND) works. I will give thumbs up after

A:

Q: struction is executed two data bytes from HL registers that were previously stored on the stack are…

A: In this question, we have to explain about pop instruction and flags..

Q: What is the purpose of creation of Republic Act 7920?

A: Public act- It is that branch of the law that governs the relationships between individuals and the…

Q: Name the universal gate

A: The universal gates are those gates by which any Boolean or the logic function can be performed.

Q: 5. Who is the tallest? a. 6 feet 2 inches tall b. 187.96 cm c. 1.8796 m d. 74 inches e. All

A: we are given with various options of height, and we have to find out the tallest out of all given…

Q: Explain any four dynamic characteristics of measurement system.

A: The explanation is as follows.

Q: how to convert 257 to Octal numbering system

A: Step 1 Divide the given decimal number successively by 8 until the ‘0’ quotient

Q: Suppose there are 6 digits [0,1,2,3,4,5], please tell me there are how many combinations for…

A: Given, The 6- digits are [0,1,2,3,4,5] Number of combinations of a 3-digit number with distinct…

Q: 4. Which type of message cannot be sent with the help of paging system? a) Alphanumeric message b)…

A:

Q: Digital communication system can handle a) Analog signals b) 1D signals c) 2D signals d) All of the…

A: The correct answer is OPTION D

Q: Explain with a neat block diagram the measurement of displacement using RTD (measuring system

A: RTD (Resistance Temperature Detector) is an electronic device used to detect the temperature by…

Q: Why ar are digital signals more accurately reproducible than analog signals?

A: Why digital signals more accurately reproducible than analog signals?

Q: Could somebody transcribe this in LEGIBLE handwriting?  Or type it?  This is the solution I need but…

A:

Q: Construct a 5-2-2-1 weighted code for decimal digits. What numbers does 1110 0110 represent in this…

A: To do: a) We have to construct 5-2-2-1 weighted code for decimal digits. b) what numbers does 1110…

Q: number 2 also please

A:

Q: Please write my name on the sheet.                    My name is Zaid Nasser Khayat

A: As per guidelines of Bartleby we are unable to write you name

Q: write paragraph about how to concat and installation circuit breaker with socket ,what is…

A: Aim-  To write paragraph about how to connect and installation circuit breaker with socket.

Q: Three 47.1 ohm resistors and three 17.1 H inductors are all in series with a 37 volt battery and a…

A:

Q: Convert the octal NUMBER 7135. 2235 to hexadecimal number showing the steps (Note: The problem…

A: NOTE: Since you have asked multiple questions, we will solve the first question for you. If you want…

Q: 10. An analog system is one in which processed data is in analog form only.

A: we need to find in analog system  processed data is in analog form only.this statement is true or…

Q: Can I get a version of this that can be read?  Maybe a space between equations could help.  Better…

A: It is given that:

Q: differentiate NEUTRAL, EARTHING, and GROUNDING.

A: According to the question we have differentiate NEUTRAL, EARTHING, and GROUNDING.

Q: How many bits are required to numerically represent the temperatures between 0 ° C and 100 ° C with…

A:

Q: Digital information can be copied ______ times before it starts to change the original information.…

A: Digital information generally in the form of 0 and 1. it is necessary to convert the digital signal…

Q: (a) Perform the following conversions (show all workings). (i) (ii) E1D5.C4₁6 to Decimal number…

A: Decimal0123456789101112131415Hexadecimal0123456789ABCDEFHexadecimal to decimal :-(E1D5.C4)₁₆ = (14 ×…

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.