A sign for a pizza restaurant hangs from a 2.60-m long rod extended out from a building. A cable, attached to the building, is attached to the rod at a point that is 2.10 m from the hidge. (See the figure.) The mass of the rod is 5.10 kg. The mass of the sign is 7.30 kg. The angle between the building and the rod is 75.0 degrees. The angle between the cable and the horizontal is 24.0 degrees. The tension in the cable is 183.4 N. What is the horizontal component of the reaction force from then hinge on the rod?

A sign for a pizza restaurant hangs from a 2.60-m long rod extended out from a building. A cable, attached to the building, is attached to the rod at a point that is 2.10 m from the hidge. (See the figure.) The mass of the rod is 5.10 kg. The mass of the sign is 7.30 kg. The angle between the building and the rod is 75.0 degrees. The angle between the cable and the horizontal is 24.0 degrees. The tension in the cable is 183.4 N. What is the horizontal component of the reaction force from then hinge on the rod?

Similar questions

A block of mass MB=2.5 kg is attached to a pulley of mass MP=2MB and R=10.0 cm (Icyl = 1/2MR2) and is pulled from the other side with force F=30.6 N with a massless string as in Figure 3. A. Write an expression for Newton's 2nd Law for the block. B. Write an expression for Newton's 2nd Law (for torque) for the pulley. C. Calculate the acceleration of the system and indicate the direction.
The figure below shows a claw hammer being used to pull a nail out of a horizontal board where ? = 27.3°. The mass of the hammer is 1.00 kg. A force of 165 N is exerted horizontally as shown, and the nail does not yet move relative to the board. Assume the force the hammer exerts on the nail is parallel to the nail. A hand uses a hammer to pull a nail out of the ground. The head of the hammer is curved and touches the ground at a single point of contact at the center of the head. The nail in the ground makes an acute angle ? clockwise from the vertical. The nail is hooked in the hammer claw 5.00 cm horizontally to the left of the hammer head's point of contact to the ground. The hand pulls the hammer handle horizontally to the right 30.0 cm above the ground with a force vector F.(a) Find the force exerted by the hammer claws on the nail.magnitude kNdirection ° above the horizontal (b) Find the force exerted by the surface on the point of contact with the hammer head.( î + ĵ)…
Please ASAP
A 7.1 N weight is attached 5.0 cm from the fulcrum of a balance beam. What weight should be placed 1.4 cm away from the fulcrum on the other side of the beam in order to balance the system?
Rachel and Sally are on a seesaw. Rachel, who is older, weighs 80 pounds and sits 4.0 feet from the seesaw’s fulcrum. If Sally weighs 50 pounds, how far from the fulcrum must she sit for the seesaw to balance?
A sign for a pizza restaurant hangs from a 2.60-m long rod extended out from a building. A cable, attached to the building, is attached to the rod at a point that is 2.10 m from the hidge. (See the figure.)The mass of the rod is 4.80 kg. The mass of the sign is 7.10 kg. The angle between the building and the rod is 50.0 degrees. The angle between the cable and the horizontal is 38.0 degrees. The tension in the cable is 90.27 N.What is the vertical component of the reaction force from then hinge on the rod?
A bolt is turned by a force of 54 N which is applied perpendicularly at the end of the handle of a wrench. The wrench is 0.30 m long. What is the torque applied by the wrench?
The uniform seesaw shown below is balanced on a fulcrum located d1 = 3.5m from the left end. The bigger boy on the left end has a mass m1 =75 kg. The smaller boy on the right end has a mass of m2 = 55 kg and is a distance d2 = 4.5 m from the fulcrum. The mass of the board is mb. Draw all forces acting on the seesaw board showing their directions and locations. Where would you draw the weight of the board? Identify and show the direction of rotations caused by the torques provided by all forces about the fulcrum. If the seesaw is in static equilibrium, write down the two conditions of static equilibrium symbolically using the forces and distances in the figure. Solve for the mass of the board. Calculate the force of fulcrum on the board.
The wow expert Hand written solution is not allowed.
A 50 N weight is located 20 cm from the fulcrum of a balance beam. At what distance from the fulcrum should a 20 N weight be placed to balance the system?
Jack and Jill want to balance their seesaw. Where should they set the fulcrum? Jack has a mass of 25 kg, Jill has a mass of 15 kg, and the seesaw board has a mass of 20.0 kg.
Three children are trying to balance on a seesaw. The seesaw is 4.1 m long and pivots about a rock at its center. Louie and Laura are already sitting on opposite ends. If Martha weighs 33 kg, where should she sit so as to balance the seesaw?