A shunt reactor of 100 MVAR is operated at 98% of its rated voltage and 96% of its rated frequency. The reactive power absorbed by the reactor is ?

Q: For the given circuit below, a step down transformer gives an RMS voltage of 230 V/ 11.6-0-11.6 V…

A: Given data:

Q: A single phase full converter feeds power to RLE load with R=10 ohm, L=10 mH and E=50 V, the ac…

A: Given, A single phase full converter feeds power to RLE load with R=10 ohm L=10 mH E=50 V The ac…

Q: Required information Problem 03.093 - The dc output voltage in the half wave rectifier The half-wave…

A:

Q: Eripplepk-pk = 0.75V Standard average current diode rating : 1A, 2A, 3A, 4A, 5A Standard peak…

A:

Q: A single phase half wave rectifier is used to supply power to a load of impedance 12 from 230 V, 50…

A: We are authorized to answer three sub-parts at a time, since you have not mentioned which part you…

Q: $5.9 The loop shown in Fig. P5.9 consists of radial lines and segments of circles whose centers are…

A: We need to find the value of magnetic field.

Q: Q5. For the following center tapped transformer, show the waveform across each half of the secondary…

A: The given circuit diagram is a center-tapped transformer-type rectifier. the input voltage is 100 V.

Q: AC Circuit : For the series RLC circuit shown here, calculate i) impedance, ii) total current, ii)…

A: As per Bartleby guidelines, we can answer only three subparts please ask for the rest of the parts…

Q: A 3-phase, half-wave thyristor rectifier with an inductive load is supplied by a three-phase source…

A: The solution can be achieved as follows.

Q: What is the importance of the charecteristic curve in PN Junction

A: Characteristics of pn junction diode

Q: A single phase full converter feeds power to RLE load with R=10 ohm, L=10 mH and E=50 V, the ac…

A: Given: single Phase Full ConverterV=230 VR=10 ΩL=10 mHE=50 Vα=60°Continuous conduction i.e Output…

Q: a) Draw the circuit diagram of a simple negative clamper with input and output wave forms for an…

A:

Q: Q1 Figure Q1(a) shows a single phase half-wave controlled rectifier has a resistive load of R = 100,…

A:

Q: what is the use of DC/DC tension converter DC/DC booster MT3608

A: Types of mostly used DC DC Converter Step up Converter ( Boost converter) Step Down Converter (…

Q: I a thyristor - controlled reactor, the conduction angle is: A. Directly proportional to twice…

A: To determine :  The conduction angle  of Thyristor - controlled reactor,

Q: The Circuit Below shows a basic Buck-Boost Converter with a highly inductive Load. With a Deliberate…

A: In the given circuit firstly we have to find the duty cycle Duty cycle = 0.55+17×0.2100Duty cycle…

Q: Q5/ What is static VAR Compensator? Draw its schematic diagram. What are the two tasks of Thyristor…

A:

Q: The equation of a standing wave is y(x,t) = 0.8 cos(0.05Ttx) sin(200rt) where x and y are in cm and…

A: Standing wave: It also called as a stationary wave. It is wave that oscillates in time but peak…

Q: State and explain the two parameters that characterise the design core thermal performance of a…

A: It is asked to state two parameters that characterize the design core thermal performance of a power…

Q: A single-phase half wave uncontrolled rectifier circuit is operating with a purely inductive load…

A: Given data :The given source voltage The given ammeter reading

Q: riefly explain environmental issues in regard to thermal power plants

A: A thermal power station is a power plant with a steam-driven primary mover. Water is heated, then…

Q: For the given circuit below, a step down transformer gives an RMS voltage of 230 V/ 19.1-0-19.1 V…

A: PIV of diode is 2 times of input

Q: Briefly explain the temperature dependence of conductivity of a p-type semiconductoi

A: The detailed answer is solved below according to the given parameters and instructions in the…

Q: Q5. For the following center tapped transformer, show the waveform across each half of the secondary…

A: The waveform across each half of the secondary winding is shown by Vac & Vbc waveforms in the…

Q: reactive power calculation.

A:

Q: In the circuit of figure Nº A, the secondary voltage Vs is 15 volts rms with a frequency of 60 Hz, R…

A: Given data: Frequency f=60 Hz Resistance R=100 Ω Capacitance C=1000 microfarads Secondary RMS…

Q: In half wave rectifier with filter, if the capacitance is increased, the ripple factor increases.…

A: Choose the correct option In the half wave Rectifier with fliter,  If the capacitance value increase…

Q: Q8. The importance of the fault analysis in a power system is, to determine O Transient conditions…

A: Fault analysis in power system is to determine both transient and sub transient conditions.

Q: What is the effect of applying reverse voltage on a pn junction?

A: According to question answer rule of Bartleby we have to solve only one question so I solve (a)…

Q: Q5. For the following center tapped transformer, show the waveform across each half of

A: The given circuit diagram is a center-tapped transformer-type rectifier. the input voltage is 100 V.…

Q: Q5. For the following center tapped transformer, show the waveform across each half of the secondary…

A: Consider the circuit given in the figure: When we treat transformer with input terminal A as…

Q: Write a technical report about the application of reactors and capacitors in power and distribution…

A: Inductor in power power distribution has many applications like storing energy and something the…

Q: In the circuit of figure Nº A, the secondary voltage Vs is 15 volts rms with a frequency of 60 Hz, R…

A: Given data, Secondary RMS voltage Vs=15 V Frequency f=60 Hz Resistance R=100 ohms Capacitance C=1000…

Q: For the given circuit below, a step down transformer gives an RMS voltage of 230 V/ 10.2-0-10.2 V…

A: