a Show Transcribed Text G a H 1P₂ NO 2 A H a B P₂ 2 Py P1= forty kN, P2= fifty kN, P3=thirty KN, P4=forty kN a=2m, h=1.5m Find forces in members EH, ED, DC, GH using method of joints. (mention if tension or compression) S

Q: Given a = 5 m, b = 11 m, F₁ = 114 N, F₂ = 319 N, and F3 = 217 N, determine the forces in members CD,…

A:

Q: A wooden beam is fabricated from one 2 × 16 and two 2 × 10 dimension lumber boards to form the…

A: The given data is: A1=16*6=32 in2 y1=10+(2/2)=11 in A2=10*4=40 in2 y2=1/0/2=5 in

Q: A W18 x 40 standard steel shape is used to support the loads shown on the beam. Assume P = 29 kips,…

A: Answer  We know that maximum bending stress occur in a beam at extreme fibres and it can be…

Q: Determine the force in members BC & CD of the truss and indicate whether the members are in tension…

A: Given data:

Q: • Part A Suppose that P = 12 kN and P = 17 kN. (Figure 1) Determine the force in member CF of the…

A: Away from the joint : tension (+ve) Towards the joint : compression (-ve)

Q: For the steel truss and loading shown, determine the deformation (in inches) of member BD, knowing…

A: First calculate the member force in BD using the method of sections. Then using the HOOKES  formula…

Q: A wooden beam is fabricated from one 2 × 10 and two 2 x 8 dimension lumber boards to form the…

A: A wooden beam is given in the question. Which is fabricated by the 2 by 10 and 2 by 8 lumber boards…

Q: nd the stress of each 14 members and identify whether each member is a compression or tension. The…

A: Assumption: Loads in downward direction is positive. Forces in upward direction is positive.…

Q: Problem 2: Method of Joints Inputs: ● ● ● ● h = 3.6 ft L₁ = 6.6 ft L₂= 3.0 ft F₁ = 9 kips There is a…

A:

Q: A truss is detailed in figure below. For the given loading, determine the magnitude and nature of…

A:

Q: 06. The lap joint is connected by three 20-mm diameter rivets. Assuming that the axial load P = 50…

A:

Q: Correct the error and write one to two sentences explaining the error

A: The truss figure is shown in the above figure. We have to find out the member forces of JE, JI &…

Q: The beam is made from southern pine and is supported by base plates resting on brick work. (Figure…

A: Given: Required : Length of base plate at A and B

Q: Using

A:

Crack Detection

Concrete materials are meant for supporting structures, building foundations and they act as several load-bearing structures. Over time, due to environmental conditions, and based on the constituent materials used, concrete materials are subjected to a great degree of distress. Corrosion of the reinforcement bars due to chemical influences, uneven base, earthquake, drying shrinkages, and alkali-aggregate reactions are some of the reasons for concrete distress.