A ship is 150 m long and has a wetted area of 5000 m2.If it is encrusted with barnacles, the ship requires 7000 hpto overcome friction drag when moving in seawater at 15 kn and 20°C. What is the average roughness of thebarnacles? How fast would the ship move with the samepower if the surface were smooth? Neglect wave drag.

Q: Required information A delivery vehicle carries a long sign on top, as in the image. The sign is…

A:

Q: d = 1.49 kg/m-s. For steel, take p≈ 7800 kg/m³.

A: To determine the constant fall velocity of the steel sphere in glycerin using the modified…

Q: a stone is thrown from top of 35m tall bilding. The stone is thrown with an initail speed of 15 m/s…

A: givenheight of the buiding H=35minitial speed U=15m/sAngle makes with horizontal axis θ=53o

Q: Q1 A car is traveling at sea level at a constant speed. It weighs 2500-lbs, has a frontal area of 20…

A:

Q: A space of 25 between tWo surraces th SAF west lubricating oil at 250C (u = 0.18 Ns/m?). Plot the…

A:

Q: 000 rev/min, producing 168 ft-lb of torque. The drive axle slippage of 2%, 14-inch-radius wheels,…

A:

Q: A 1-m-diameter sphere is being towed at speed V in freshwater at 20°C as shown in Fig. Assuming…

A: Write the properties of water at 20°C. Cavitation will occur at the lowest-pressure point, which is…

Q: A surface buoy is located in 180 ft of water and is moored with a wire rope weighing 3 lb/ft. The…

A:

Q: A flagpole 20m high with a cross section shape of a square with 1000mm sides is exposed to sea level…

A: Given:flagpole height=20 mv=50 m/sTo=30+273=303 KSide, a1=1000 mm or 1 mPo=101325 Paμ=1.78×10-5…

Q: Find the drag force applied by the wind blowing at

A: Given: U= 80 km/h To determine: The drag force due to wind blowing

Q: Required information A torpedo 8 m below the surface in 20°C seawater cavitates at a speed of 21 m/s…

A:

Q: celeration and deceleration. (The effects of friction and aerody- travels from the North Pole to a…

A:

Q: A smooth aluminum sphere hangs in air on a 0.5 m-long cable. The sphere has a diameter of 10 cm and…

A: (a) To find: The magnitude of drag force. Given: The weight of the sphere is W=1.5 N. The radius of…

Q: The velocity profile for boundary layer over a 73 1 y 3 Ux flat plate is given by, u. y 2 8x 2 8x…

A: The solution is given below

Q: A truck carrying fully-filled water container that is 2.5m long, 2.5m wide, and 2m high the entire…

A:

Q: A boat is equipped with two retractable rudders of width 0.75m and length 1m. The speed of the boat…

A: (3.1) Write the given data. A=lb=1 m0.75 m=0.75 m2v=120 km/h=120518=33.33 m/s Calculate the…

Q: Kindly give me both right solutions with clear calculations  The drag polar of a glider is given by…

A:

Q: An airplane is flying at sea level at a speed of 100 mps. Calculate the free-stream dynamic pressure…

A:

Q: Hoerner states that the drag coeffi -cient of a flag of 2:1 aspect ratio is 0.11 based on the…

A: Two flags are present of which one is state flag and the other one is national flag of same area 2H…

Q: What is his terminal speed if he falls feet first? Use p = 1.2 kg/m³ for the density of air at room…

A: Given data as per the question Mass of the skydiver=81 kgArea =0.24×0.47=0.1128 m2drag cofficient…

Q: A truck experiencing drag is able to reach a maximum velocity of v₁ = 30.5 m/s. It has…

A: Given:Maximum velocity of truck for area A1=1.6 m2, v1=30.5 m/sDrag coefficient for A1=1.6 m2,…

Q: The sphere of diameter of 5.0 cm is moving in still water at a velocity of 2.0 m/s. The drag…

A:

Q: Q1/ Boeing 737 - 60 flies at altitude 15000m above sea level with speed 85 m/s and total drag…

A: Given data: -  The speed of the Boeing 737 - 60 is v = 85 m/s. The density of air at this condition…

Q: _A- Airbus 320 fly in steady level flight with altitude 11000m, find the lift force required to…

A: For the steady level of flight, the lift force is equal to the weight force then the plane is in…

Q: The drag equation for the Gofaster 172 is: D = 0.0003v2A. D is drag in pounds; v is airspeed in…

A:

Q: The drag polar equation of a light airplane in clean configuration can be written as Cp = 0.358 +…

A: The drag equation, CD = 0.358 + 0.0405CL2The weight, W = 18681 NThe wings area, A = 14.41 m2

Q: A flagpole 16 m high has the shape of a cylinder 100 mm in diameter. The air temperature is 30°C and…

A: Please first draw the free body diagram and proceed further

Q: The air with temperature T. 20°C, speed U. = 20 m/s flows over the plate with length L = 1 m, width…

A:

Q: In the vertical wind tunnel used in paratrooper training, find the wind tunnel free speed required…

A:

Q: A bridge over a river is supported by a pylon that is a vertical cylinder with diameter of 1.5 m and…

A:

Q: Answer correctly. Here is the Translation. "A luxury sports car has an area of 2 m² and there is a…

A:

Q: For those who think electric cars are sissy, Keio University inJapan has tested a 22-ft-long…

A: To find  The percentage of power expended against the air drag η. Given  The power generated by 8…

Q: The drag equation for the Gofaster 172 is: D = 0.0003v2A. D is drag in pounds; v is airspeed in…

A: For the solution refer below images.

Q: A wing has an elliptical load distribution across its wingspan that totals a lift of 2,500.0 N.…

A: To find: The induced drag of the wing in Newton. Given: The total lift is L=2500 N. The wing lift…

Q: What is the power per unit area of a 10 knot uniform wind (in W/m²)?

A:

Q: (Drag) A 300-N rock (roughly spherical in shape) of specific gravity SG-1.93 falls at a constant…

A: Given,

Q: A hydraulic lift shaft of 500mm dia moves in a cylindrical sleeve the length of engagement being 2m.…

A:

Q: A 30-cm-diameter smooth ball of dėnsity Ppall = 210 kg/m³ is tied to an object on the bottom of a…

A: Given: The diameter of smooth ball, d = 30 cm The density of ball, ρball = 210 kg/m^3 The density of…

Q: A sky diver jumps from a plant. Estimate his terminal Speeds by estim arting the mass of the sky…

A: Given: Body surface area =A= 0.4 m ×1.8 m=5.2  m2Drag coefficient =C= 0.5

Q: desired to equip this airplane with turboprop engines with available power such that a maximi 602.6…

A:

Q: A supertanker is 300 m long, 80 m wide (beam), and 25 m deep (draft). The ship mov at 14 knots…

A:

Metrology of surface finish

In general terms, the application of scientific principles in the study of measurements is known as metrology. When speaking about measurement, it could be of time, length, microstructures, grain structures, internal crystal discontinuities, surface roughness, measurements of angles, height, width, and so on. While coming to the domain of mechanical engineering, metrology is considered the science of measurements of surface finish, length, surface texture, and angles.