A series of solutions containing NaOH, Na 2c03 and NaHCO3, alone or in compatible combinations, were titrated with 0.1202 M HCI. Given are the volumes of acid required to titrate 25.00 mL portions of each solution each to a (1) phenolphthalein and (2) methyl red endpoint. Which of the following contains NaOH?

Q: Question 1 Air in a certain area has the following molar composition: N2 74.1% O2 15.3% H20 3.2% CO2…

A:

Q: 19. How many milliliters of 2 M HNO, must be diluted to 400 ml so that 2.00 g silver acetate will…

A: Dilution is defined as the process of decreasing the concentration of a solute in a solution,…

Q: Indicate the concentration of each ion present in the following solutions: a) 0.35 M NaOH b) 0.55 M…

A:

Q: Calculate the molecular weight of sulfur if 35.5 grams of sulfur dissolve in 100.0 grams of CSz to…

A:

Q: Name the reagent if any, that you would add to aq solution of iron (III) chloride to precipitate.…

A: 1 )The precipitation of iron (III) hydroxide occurs when an aqueous solution of iron (III) chloride…

Q:

A: Given: Weight of HA = 1.90 g Volume of Ca(OH)2 =  38.6 mL Cocentration of Ca(OH)2 = 0.253 M

Q: Define the terms “dilution” and “dilution factor”. Calculate the volume of the original sample…

A: 1) Dilution is the process of diluting or mixing two or mores substances or compounds ; it also…

Q: Find the molal concentration of Au when 1.0 mol of Au is dissolved in 3.0 mol of HNO; and 6.0 mol of…

A: Molal concentration is the concentration expressed in terms of moles of solute dissolved per…

Q: Calculate the percent ionization of propionic acid 1C2H5COOH2 in solutions of each of the following…

A: The percent ionization of the propionic acid is to be calculated for the given concentration.

Q: Question 11 A 100.00 mL aqueous solution s prepared with 74.8 mg of indigo dye, 25.00 mL of 1.00 mol…

A: Given:- Volume Solution is =100.00 ml             Mass of Indigo blue = 74.8 g…

Q: You have a 1 g sample of an alloy containing Al and Mg dissolved and treated to prevent…

A: Given: Weight of Alloy = 1 g Weight of all precipitates = Al(C9H6NO)3(g)+ Mg(C9H6NO)2(g) = 7.98 g…

Q: If 0.300 mol of an unknown acid, HY, is dissolved in enough water to make 1.00 L of solution, find…

A: Write the reaction for the ionization of HY as follows: HY → H+ + Y-   Ionization constant, Ka =…

Q: EG 1 0.9 0.8 0.7 06 0.5 04 0.3 02 0.1 0 4. A feed solution of ethylene glycol (EG)-water containing…

A: A mixture of ethylene glycol (EG) and water is separated with the help of pure furfural in a…

Q: Iron(II) oxide is nonstoichiometric. A particular sample was found to contain 76.55% iron and 23.45%…

A: Iron(II) oxide is non stoichiometric Mass percentage of iron = 76.55%  Mass percentage of oxygen =…

Q: EXAMPLE 4-4 Calculate the analytical and equilibrium molar concentrations of the solute species in…

A:

Q: An Erlenmeyer flask contains 41.40 mL of a hydrochloric acid. The solution is titrated and reaches…

A: Given  Volume of hydrochloric acid = 41.40 mL…

Q: Table 1. Answers in Item (a). Point Phases present Compositions (more volatile) Temperature, °C 2 3…

A: Given graph is T-x-y for butane-pentane system. The graph consists of three phases. They are liquid…

Q: A vapor-liquid equilibrium system of benzene and toluene has a bubble point equal to 100 degC at 750…

A:

Q: Biochar is believed to be a good absorbent for various contaminants. In an isotherm experiment, a…

A: The Freundlich Adsorption isotherm is given as:  KF is adsorption capacity or constant and n is…

Q: A mixture of dichloromethane (1) and ethyl acetate (2) and is separated in a flash drum at 1 bar. a)…

A:

Q: A stock solution of 70% v/v ethanol was diluted with distilled water to prepare 1L of 21% v/v…

A: Initial concentration=70%v/v Density of ethanol=0.789h.mL Molecular weight of ethanol=46g/mol TO…

Q: A solution containing 50 weight % methanol and remaining water at 300 K is admitted to a…

A:

Q: Question 10 A glass is to be manufactured with the composition by weight given in the table below –…

A:

Q: Sodium Cyanide is the salt of the weak acid HCN. Calculate the concentration of H3O+,OH,HCN and Na+…

A:

Q: Using the ternary phase diagram below, determine if the following mixture falls on the single-phase…

A: Given data: Composition of ternary mixture is, B = 20 % C = 80 %

Q: 5. A ChE student aiming to lose weight for health reasons decided to purchase 15 tablets of a…

A: Given that: Number of dietary supplement tablets = 15 The tablet is expressed as grams of ferrous…

Q: You dissolve 4.000 g solid ammonium chloride in 100.0g of water inside a Styrofoam coffee cup. You…

A: When a chemical reaction occurs in the Styrofoam coffee cup calorimeter, the heat of the reaction is…

Q: Using the ternary phase diagram below, determine if the following mixture falls on the single-phase…

A: Ternary phase diagrams represent the equilibrium of the mixture containing three components. The…

Q: A feed stream containing 15% wt solids and 85% wt water is introduced in a certain process where the…

A: Here it is given that feed having 15 %wt solid and 85  % wt water residue has 13 water by mass

Q: Find the molal concentration of Au when 1.0 mol of Au is dissolved in 3.0 mol of HNO, and 6.0 mol of…

A:

Q: Compound A (Kow = 100) is dissolved in the 1L water, and its concentration is 50 mg/L. What is…

A: Kow is the partition coefficient of the compound that subjected to the solution containing n-octanol…

Q: Time remaining: 00 :09 :37 Chemistry Please show steps and formula: 6a. How grams of Sodium…

A: 6.a.  Given, Volume of solution, V=100 mL Molarity of solution, M=1.00 M

Q: - A mixture of benzene and toluene contains 40% wt benzene. a. Determine the g-moles of benzene in…

A: A mixture contains contains benzene and toluene Weight (%) of benzene =40% Calculate: (a) The…

Q: How many moles of MgCl₂ are present in 54.0 mL of 0.135 M MgCl₂ solution?

A:

Q: 2.16. Use an anion-cation balance to determine if the following sample analysis for waters 1 and 3…

A: First of all the anion acceptance range is- ∑(anion) meq./L Acceptable Difference 0-3.0 ±0.2%…

Q: Using the ternary phase diagram below, determine if the following mixture falls on the single-phase…

A: Any point within the curve represents mixture of two phases (Raffinate and extract phases) Any point…