A separately-excited DC motor has lap-wound armature with 100 slots and 2 turns per coil. It is rotating at 120 rpm and flux per pole is 0.1wb. Armature resistance is 12 and armature loss is 10W. Determine: (i) (ii) Source voltage Starting armature current

Q: The BEST choice electronic device to turn a device at a particular voltage is a/an _____. A. PUT B.…

A: the correct option would be SCS. Particular voltage can be obtained by adjusting firing angle of scs…

Q: Differentiate between MCB and kit kat fuse

A: MCB : MCB stands for miniature circuit breaker it is a electrical device in such way that it…

Q: With neat sketch explain the types and operation of oil circuit breaker

A: Types of the circuit breaker, 1. Low oil circuit breaker 2. Bulk oil circuit breaker Plain break…

Q: CRO  __________________ generates the saw tooth sweep voltage.   Y plates control grid…

A: In CRO  Y plates generates the saw tooth sweep voltage

Q: What is the meaning of semiconductors? Are the diodes can be counted as semiconductors?

A: Semiconductors are materials which have a conductivity between conductors (generally metals) and…

Q: 1. In a transistor amplifier circuit's circuit board. Which circuit blocks can be configured as two…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Determine the following: Ic, VF , VR , R1

A: BJT (bipolar junction transistor) A transistor having a three terminal made up of semiconductor…

Q: brownout is defined as: a slightly decreased voltage lasting from seconds to minutes or more

A: In this question we will define brownout in power system....

Q: can i series my led chip even though i don't put any fuse. Is it safe?

A: Most of circuit does not contain fuse for LED Chip Reason behind not putting fuse for LED Chip is…

Q: What is the condition of a one-way switch if it has no resistance between terminals at both toggle…

A: As per Bartleby's guidelines, we are allowed to solve only one question, please ask the rest of the…

Q: Describe ring counters in detail and how they are used.

A:

Q: Which among the following is NOT a power system load? Select one: O a. Circuit Breaker O b. Motor O…

A: Power system load is a physical unit /device that consumes power. Refrigerator fan and motor…

Q: Explain the operation of a full wave bridge-type rectifier circuit. STEP BY STEP ANSWER NEEDED…

A: In this question,  Explain the operation of the full wave bridge rectifier.  Assume all diodes are…

Q: Answer the following Hexadecimal to decimal conversion problem: Convert the HEX NUMBER DE2B. FBFB to…

A: To convert the hexadecimal number into decimal number we will use expansion method given as:

Q: Name two nationally recognised electrical testing laboratories in the United States.

A: In the following section, two nationally recognized electrical testing laboratories present in the…

Q: a) Define the term "Switching Circuit". State the application area that the switching circuits are…

A: Solve the first question, unless the student has asked for a specific question to be solved, subject…

Q: Differentiate/Compare the designs of conventional power supplies with the “newer” designs of power…

A: Power supply The power supply is a device that supplies power to the electrical loads that are…

Q: What type of circuit does PLL look like over its lock range?

A: PHASE-LOCKED LOOP (PLL): 1. In the frequency demodulation technique, frequency synthesisers, and…

Q: Can I get help drawing the circuit for 3 pleease like the 2nd one

A:

Q: An AC voltage v(t) = 248 sin 314 is applied to an SCR half-wave rectifier if the SCR has a forward…

A:

Q: How to turn-off a voltage source? A) Set it to zero. B Replace it with a short-circuit. C) You can't…

A: This is a basic problem of circuit. The solution is given in the next step.

Q: Write the names and functions of the three devices used for circuit laboratory experiments and…

A: In this answer we will discuss about any three devices that are used in the laboratory for…

Q: for what purpose the adders are used in digital systems i.e. full and half adders?

A: Firstly We need to Know What is an ADDER:- In Digital Electronic Adder is a Combinational Circuit…

Q: The JFET terminals that are connected to thechannel are the A. Gate and sourceb. B. Drain and…

A: Drain and source are the  JFET terminals that are connected to the channel.…

Q: What is the device address used by the instruction OUT A4, AL?

A:

Q: included with the kitchen small appliance branch circuits?

A: There are many devices that can be included with the kitchen small appliance branch circuits

Q: Stroombaan/Circuit Tipe/Type Orde/Order A) B)

A:

Q: fill the blank: 555 timer ,if vcc=60, the lower comparator triggers when the trigger input(pin2)…

A: It will trigger when input at pin 2 reaches to 2Vcc/3. Given that : Vcc=60.

Q: Describe and discuss what is a panelboard and describe circuit breaker connections on a typical…

A: We need to discuss what is a panelboard and also need to discuss the circuit breaker connections on…

Q: What does the circuit work like?

A: The above question is based on the firing circuit of a TRAIC.

Q: DAC's could be implemented using current switches. Explain the operation and characteristics of such…

A: Digital to Analog Converter (DAC) - It is a data converter that converts a digital input into an…

Q: The names of the companies that use the pulse: the signal processor in the manufacture of electronic…

A: Please find your answer below

Q: In controlling the frequency of the waveform, _____________ must be adjusted in CRO display.…

A: The horizontal scale of the beam is produced by input (voltage) applied to the horizontal deflecting…

Q: Question 1 A microcontroller is used to control three LEDS in series (Blue, Red and White). Assume…

A: Here, we have asked to design an interfacing circuit to control three LEDs connected in series,…

Q: How exactly does one go about clearing an EPROM for the very first time?

A: EPROMs (Erasable Programmable Read-Only Memory) are non-volatile memory devices that can be…

Q: Q. No. 7: Determine the output of the following instructions and set/reset the values of the status…

A:

Types of Thyristors

With four layers of alternating P- and N- materials, a thyristor is a solid-state semiconductor device. It acts as a type of bi-stable switch and it conducts when the gate receives a current trigger and continues to conduct until the voltage is reverse biased across the device or by some means until the voltage is removed. The silicon-controlled rectifier is considered synonymous with thyristors by some sources. Thyristors are defined as more complex by other sources as it contains at least four-layer of alternating N-type and P-type substrate. They find large applications in the control of electrical power supplies, electric motor speed control, and ranging of light dimmers because thyristors can control large amounts of power supplies and voltage with a small device. The circuit symbol of the thyristor is given below.