A separately excited DC generator is used to pump the water to paddy field. The generator ratings are 1500 kW with 2kV voltage and rotating with 3500 r/min. Find the induced voltage, the constant and torque of the machine if the armature resistance is 0.5 ohm and flux per pole is 0.5 Wb.

A separately excited DC generator is used to pump the water to paddy field. The generator ratings are 1500 kW with 2kV voltage and rotating with 3500 r/min. Find the induced voltage, the constant and torque of the machine if the armature resistance is 0.5 ohm and flux per pole is 0.5 Wb.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 4. A three-phase A-connected six-pole winding is installed in 36 slots on a stator. There are 150…

A: Introduction A three-phase delta-connected system is a type of electrical power distribution…

Q: In a DC machine, the air gap flux density is 4 Wb/m2. The area of the pole face is 2 cm x 4 cm. Find…

Q: d.c. motor has 774 armature conductors. If In a 4-pole rmature current is 50 Amp. and flux per pole…

Q: A 440 V d.c. Armature resistance of shunt motor is 0.25 Ω and field winding resistance is 220 Ω. A…

A: Solution: Given data; V =440 v, Armature resistance Ra=0.25 Ω, shunt resistance Rsh=220 Ω, Load…

Q: A dc 4 pole lap wound generator is running at 10o00 rpm having 1200 conductors and flux density is…

A: Given Pole P=4 lap A= P=4 N=1000 rpm Z=1200 φ= 10mwb

Q: A DC generator with 8 pole, duplex lap winding excited with a flux of 3mWb/ pole. The number of…

A: Given: A DC generator with number of pole, P=8. Multiplexity of lap winding, m = 2 (duplex winding).…

Q: An 8 pole, lap connected armature has 500 conductors has the flux per pole is 20 mWb is driven at…

A: For lap connected armature, Number of parallel path ( A ) = number of pole

Q: Write an article describing the DC Generator. Provide applications of DC generator. Provide the…

Q: There are two distinct electronic devices: the microprocessor and the microcontroller. How can you…

Q: An 8-pole lap-connected armature has 40 slots with 12 conductors per slot generating a voltage of…

A: The voltage supplied to the motor by an external power source is known as EMF or electromotive…

Q: 1. A 500 V, 250 kW, long shunt compound generator induces an e.m.f. of 480 V when running at 1000…

A: Given that: Terminal voltage Vt=250 V Full load armature current Ia=40 A Friction windage loss,…

Q: The hysteresis loop occurs because: Select one: a. The machine is full-loaded b. some eddy current…

A: consider the given circuit;

Q: In a certain magnetic circuit, the core is represented two reluctances as shown below. Assume a…

A: The magnetic circuit diagram is shown below, Number of turns, N=640 turns.Current, I=2.2 A.

Q: .A 230 V dc series motor has Ra=0.22, Rf=0.12. The motor draw 40A at rated speed and 1000 RPM. Find…

Q: Determine the power output of a DC armature having 1152 lap connected conductors carrying 150 A and…

Q: A series generator having a combined armature and field resistance of 0.4 ohm us running at 1000 rpm…

Q: A 6-pole, wave-connected armature has 831 conductors and is driven at 612 RPM. If the flux per pole…

A: We know direct formula for generated emf

Q: The DC shunt generator with the terminal voltage 350 V, armature drop 7 V and the each brush drop 2…

Q: A 3-phase, 60 Hz, Y-connected, AC generator has a stator with 60 slots, each slot contains 12…

A: AC generators are used to generate electrical energy. It converts mechanical energy in the shaft to…

Q: 16 A 2-pole d.c. shunt generator has a useful flux per pole of 0.03 Wb. The armature winding consist…

A: DC shunt generator No of pole 2 Speed N= 1200 rpm Flux per pole 0.03 No of turns 200 No of…

Q: A long shunt compound generator supplies a load consists of 172 shunt lamps each rated at 48 W, 235…

A: Long shunt compound generator Shunt field winding connected to the after series field winding.…

Q: The number of parallel paths and the number of series conductors required for a given kW rating of…

A: In this question , we will write about the number of parallel paths in dc machine depends hoon which…

Q: A short shunt compound generator supplies a load of 20 kW at 500 V. The armature, series and shunt…

A: Load current = power delivered to load/ terminal voltage voltage. Power developed = armature…

Q: The DC shunt generator with the terminal voltage 300 V, armature drop 7 V and the each brush drop 4…

A: In this we will find emf..

Q: A 3-phase, 6-pole, Y-connected, AC generator has a stator with 48 slots, each slot contains 60…

A: In this question we will find synchronous generator electrical and mechanical frequency in rad per…

Q: 6 pole, wave connected armature has 520 conductors and its generated e.m.f is 125 V. If the machine…

Concept explainers

DC Generator

An electromechanical machine which converts input mechanical energy to respective output electric energy is called a generator.

Question

A separately excited DC generator is used to pump the water to paddy
field. The generator ratings are 1500 kW with 2kV voltage and rotating
with 3500 r/min. Find the induced voltage, the constant and torque of the
machine if the armature resistance is 0.5 ohm and flux per pole is 0.5 Wb.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

128. The hysteresis loss of a dc machine is 300 W when the flux per pole is 30 mWb and the machine is driven at 1000 rpm. How much Is the loss If the field is adjusted to produce 50 mWb per pole whlle the speed Is reduced to 900 rpm? A. 420 W B. 510 W C. 450 W D. 500 W
A four pole, 1200 rpm DC lap wound generator has 1520 conductors. If the flux per poles is 0.01 Wb. Find the generator emf ?
Please quick solution
Please help me solve this asap
A six-pole generator develops 250 volts when running at 1800 rpm. The armature has 84 slots and a flux per pole of 1,653,000 maxwells. If the armature is wound with simplex lap. Find all the unknowns
Kindly solve what is ask with complete solution so that I can understand. I want a handwritten solution. Thank you very much pois!!
please help
A shunt generator delivers 1,000 W at 149 V to a load. If the armature resistance is 0 ohm, and the shunt field resistance is 56 ohms, calculate the shunt field current in ampere.
Urgent need.
A 6 pole DC lap wound generator has 38 armature conductors with flux per pole is 42 mWb and the e.m.f generated is 78 V, then the speed of the machine is 48.87 rps O 3.87 rps O 0.39 rps O 48.87 rps When the load on a series generator is decreased, then the flux produced will be increased. Select one: O True O False
ASAP, answer now please..
Question No.4 A dc generator has an armature emf of 100 V when useful flux/pole is 20 mWb, and a speed of 800 rpm. The generated emf at a speed of 1000 rpm and same flux is