A sealed container of gas contains nitrogen gas at 1.00x10³ kPa pressure and a temperature of 20°C. When the cylinder is left in the sun, the temperature of the gas increases to 50°C. What is the new pressure in the cylinder? What is the name of this law?

A sealed container of gas contains nitrogen gas at 1.00x10³ kPa pressure and a temperature of 20°C. When the cylinder is left in the sun, the temperature of the gas increases to 50°C. What is the new pressure in the cylinder? What is the name of this law?

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

A 7.00 L tank at 6.54 °C is filled with 17.3 g of sulfur tetrafluoride gas and 17.7 g of chlorine pentafluoride gas. You can assume both gases behave as ideal gases under these conditions. Calculate the mole fraction and partial pressure of each gas, and the total pressure in the tank. Be sure your answers have the correct number of significant digits. mole fraction: х10 sulfur tetrafluoride partial pressure: | atm ? mole fraction: chlorine pentafluoride partial pressure: atm Total pressure in tank: atm
Boron trifluoride gas is collected at 6.0 °C in an evacuated flask with a measured volume of 15.0 L. When all the gas has been collected, the pressure in the flask is measured to be 0.140 atm . Calculate the mass and number of moles of boron trifluoride gas that were collected. Be sure your answer has the correct number of significant digits. mass: g x10 mole: | mol ?
A sample of an ideal gas at 1.00 atm1.00 atm and a volume of 1.07 L1.07 L was placed in a weighted balloon and dropped into the ocean. As the sample descended, the water pressure compressed the balloon and reduced its volume. When the pressure had increased to 15.0 atm,15.0 atm, what was the volume of the sample? Assume that the temperature was held constant.
7.) A glass bulb contains an unknown gas. The gas is either CO2, SO2, C2H6, or CH3F. Here is some data that was collected for this gas sample. Use the data to identify the unknown gas. Mass of glass bulb with the unknown gas: 14.402 g Volume of glass bulb: 670. mL Mass empty bulb 12.232 g Pressure 1751. torr Temperature 21.oC
Some N, gas is mixed with some O₂ gas, and the sketch below shows a representative sample of the mixture. The total pressure of the mixture is measured, and found to be 0.090 kPa. gas N₂ 0₂ Calculate the mole fraction and partial pressure of each gas in this mixture. Round your answers to 2 significant digits. You may assume each gas behaves as an ideal gas. key carbon nitrogen oxygen mole fraction partial pressure 0 kPa kPa 0 O hydrogen sulfur chlorine o.f
11. (a) In a 20.0 L steel container, we have only 77.7 g of CO2(g), 66.6 g of N2(g), and O2(g). The temperature is 25.0 ◦C and the total pressure is 8.88 atm. What mass of O2(g) do we have, and what is its partial pressure? The molar masses of C, N, and O are 12.01, 14.01, and 16.00 g/mol. (b) The density of a sample of pure CH4(g) at a constant pressure of 1.00 atm is 0.666 g/L. What is the average speed, or root mean square speed, of the CH4(g) molecules in this sample? The molar masses of C and H are 12.01 and 1.01 g/mol.
For many purposes we can treat ammonia (NH,) as an ideal gas at temperatures above its boiling point of –33. °C. Suppose the temperature of a sample of ammonia gas is raised from – 25.0 °C to 17.0 °C, and at the same time the pressure is changed. If the initial pressure was 0.15 kPa and the volume decreased by 50.0%, what is the final pressure? Round your answer to 2 significant digits. kPa 1 Don't Know Submit etv DII esc %23 24 6 7 09 2 4 OP E T Y.
A student obtained a mass of 0.266 g CO2 during his experiment. The atmospheric pressure was 751.6 mmHg and the laboratory temperature was 24.1 °C. The flask used in the experiment had a volume of 146.5 mL. Calculate the molar mass of CO2 from the data. Hint: You cannot use the molar mass of CO2 in your calculation since this is what you are looking for... You need to used the ideal gas law to determine the number of moles of CO2, then do the ratio of grams of CO2 over moles of CO2 to determine the experimental molar mass of CO2.
The ideal gas law, PV = nRT is independent of the kind of gas. In other words, the pressure exerted by a given number of ideal gas particles is the same whether the sample consists of all one type of particle or a mixture of different kinds of particles. Air is about 78.0% nitrogen molecules and 21.0% oxygen molecules. Several other gases make up the remaining 1% of air molecules. Therefore, the pressure exerted by a mixture of gases can be expressed as follows: Part A Tota RT Ptotal = V What is the partial pressure of nitrogen in air at atmospheric pressure (101 kPa)? Assume ideal behaviour. A partial pressure is the pressure exerted by just one type of gas in a mixture. A partial pressure is calculated using only the number of moles of that particular gas, instead of the total number of moles: Express your answer to three significant figures and include the appropriate units. • View Available Hint(s) RT P = V P = nRT P= nRT etc. The sum of the partial pressures is equal to the total…
The air all around us is a mixture of gasses containing nitrogen, oxygen, carbon dioxide, argon and water vapor. If the partial pressure of nitrogen is 5.6 atm, the partial pressure of oxygen is 828 mmHg, the partial pressure of carbon dioxide is 652 torr, the partial pressure of argon is 0.017 atm, and the partial pressure of water vapor is 98.64 kPa. What is the total pressure in units of atmospheres (atm)?