A screw-jack is used to lft a load of 4 kN. The screw of the screw-jack is square threaded with two threads to 1 cm. If the co-efficient of friction between the nut and screw is 0,095 and outer diameter of screw s 6 cm, find the force required atthe end of the handle of length 50 cm to ift the load

Q: 2. Four identical rigid bars each of length a are connected to a spring of stiffness k to form a…

A:

Q: A plate inside a microwave is rotating by a motor that is connected to it's center. the plate is…

A:

Q: The figure shows a mechanism that raises packages in a transfer mechanism. A 300-N package sits on…

A:

Q: 41 63 3. The traffic light hangs from the cables as shown. Draw a free-body diagram on a coordinate…

A: Given data weight of traffic light (W) = 200 N To determine  value of T1 , T2 , and T3 respectively…

Q: calculate the  forces on PQ and QG  use sections  method .

A:

Q: Solve it please

A: Step 1: Step 2: Step 3: Step 4:

Q: M, M2 R friction The figure above illustrates a system comprising a rigid support structure having a…

A: Given Two blocks of mass M1 & M2 are tied to the rope and placed over a wedge  Left side of the…

Q: I need a handwritten solution, Don't use chatgpt. Wrong solution will get downvote so carefully…

A:

Q: Evaluate the force in member CF and mention if it is in compression or tension A 3 m B 3 m 45° 23 m…

A: Evaluate the force in the member CF and mention if it is in compression or tension.

Q: A block (A) weighing 1 kN rests on a rough inclined plane whose inclina- tion to the horizontal is…

A: Draw the FBD for the given question and write the given values along with suitable variables.

Q: Determine the force F required to lift a 300 N load F, with each of the pulley systems shown in…

A: Given data is

Q: 6.10. What minimum force F is needed to start body A moving to the right if u = .25 for all…

A: Dear Students

Q: A cylinder is moving a 6000 lb load up a 20° slope as shown in the figure below. The friction…

A: Given: Angle of inclination→θ=20° Friction coefficient between the surfaces→μ=0.4 Mass of the…

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.