A sample of soil is 5cm height and 7cm in diameter. Itwas tested in a constant permeameter. Water perculates through the soil under a constant head of 45cm for 8min.The water is collected and weight. Its weight was recorded as 460gms.On oven drying sample of soil the weight was recorded as 420gms.If Specific gravity is 2.65,Calculate coefficient of permeability, whiteratio, porosityand dry density, seepage velocity

A sample of soil is 5cm height and 7cm in diameter. Itwas tested in a constant permeameter. Water perculates through the soil under a constant head of 45cm for 8min.The water is collected and weight. Its weight was recorded as 460gms.On oven drying sample of soil the weight was recorded as 420gms.If Specific gravity is 2.65,Calculate coefficient of permeability, whiteratio, porosityand dry density, seepage velocity

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter6: Hydraulic Conductivity

Section: Chapter Questions

Problem 6.7P

See similar textbooks

Similar questions

Afalling-head permeability test is performed on a fine-grained soil. The soil sample has a length of 120 mm and a cross-sectional area of 600 mm2. The water in the standpipe flowing into the soil is 0.60 m above the top of the sample at the start of the test. It falls 50 mm in 30 minutes. The standpipe has a cross-sectional area of 200 mm2. (a) Make a sketch of the described conditions. (b) What is the coefficient of permeability in millimeters per second? (c) What is the coefficient of permeability in feet per minute? (d) On the basis of the calculated value for khyd, what is the probable soil type?
cylindrical sample of soil has a height of 205mm and a diameter of 102.4mm. The sample was found to have an initial "bulk* mass of 3.735kg. After placing in an oven at 105°C for 24hrs the mass was found to be 3.306kg. The specific gravity, Gs of the soil particles was determined as 2.71. Determine each of the following soil properties: Moisture content % (¡i) Bulk Density. kg/m? Void Ratio (iV) Relevant Unit weights
A cylindrical soil sample 50 mm in diameter and 200 mm in height is used as thepermeameter in a falling head permeability test setup. In one minute of observation, thehydraulic head in the 10 mm diameter standpipe through which test water went reducedfrom 900mm to 500 mm. During that time, 1.5 liters of water were collected in the graduate. Calculate the soil sample's permeability coefficient in cm/s.
Q2: A 0.01 m' of saturated soil sample has a unit weight of 1.6g/cm3. After it is dried in the oven, the weight of the soil sample reduced to 13.5kg. Use a phase diagram, determine the following: Weight of water for the saturated soil, Ww Water content, wc Ws WATER Void ratio, e Porosity, n SOLID befare trng W. Va SOLID efter ening
Q1. Undisturbed soil sample was collected from the filed in Melbourne in steel tube for laboratory evaluation. The tube has the diameter of 85 mm, length of 170 mm and the moisture weight of 1600 g. If the oven-dried weight was 1200 g and Gs = 2.69, calculate the followings:a) Bulk unit weight (?) in kN/m3b) Field moisture content (w)c) Void ratio & porosity (e and ⴄ) d) Degree of saturation (Sr)
In falling head permeability test the initial head was 350 mm and the final head was 50 mm. The cross-sectional area of the burette was 200 mm2. The sample was 50 mm in diameter and 100 mm long. If the test took 8 hours and 45 minutes, what was the coefficient of permeability of the soil in m/s? a.7.15 x 10-7 m/s b.6.29 x 10-7 m/s c.7.89 x 10-7 m/s d.8.78 x 10-7 m/s e.5.69 x 10-7 m/s
Don't attempt wrong i will downvote.....A cylindrical soil sample, 7.3 cm in diameter and 16.8 cm in height, is tested in a constant-head permeability apparatus. A constant head of 75 cm is maintained during the test. After 1 minute of testing, a total of 945.7 gm of water was collected. The temperature was 20 oC. The void ratio of the soil was 0.43. Calculate the following: 1. The hydraulic gradient 2. The flow rate 3. The discharge velocity 4. The seepage force per unit volume 5. The coefficient of permeability
soil هفصشبكطودذؤ
2. The soil sample in a test has a diameter of 5 cm and a height of 15 cm, the test is carried out for 10 seconds and the water level is 20 cm, the water flowing through the sample is measured as much as 50 cm3. What is the permeability of the soil? k₂ 9z Ai QL tAh (USE THIS FORMULA)
(iii) A soil sample is 8 cm in height and has cross-sectional area of 60 cm². It is observed that in 12 minutes, 600 ml of water passed down under an effective constant head of 50 cm. On oven drying, the test specimen weighs 750 gm. Taking 2.70 as specific gravity of soil. Calculate: Permeability of soil sample. (i) (ii) Seepage velocity of water during the test.
1
Sand cone equipment is used to perform Field density test on a compacted arth fil. Soil sample dug from the test hole = 19.88 N Dry weight of soil sample = 17.92 N Ottawa sand used to fill the hole weighs 16.05 N and is known to have a density of 15.74 HN/m. Which of the following gives the water content of the tested soil? O a. 15.45% O b. 12.08% O c. 14.96% O d. 10.94% e. 11.12%