A sample of powdered milk weighing 1.450 g was mixed with a buffer of pH 11.5. A few drops of Calmagite indicator were added and the solution required 31.62 mL of 1.538 x 10-2 M EDTA to reach the end point color change. Calculate the percentage of calcium in the milk. In the reaction of EDTA and calcium, one mole of EDTA reacts with one mole of calcium.

Q: To study the effects of a weakly acidic medium on the rate of corrosion of a metal alloy, a student…

A:

Q: 2. What is the solubility of lead (in pM) for solid Pb(OH)2 in a sample of water containing 2.4 x…

A:

Q: A 0.7352g sample of ore containing Fe3+, Al3+ and Sr2+ was dissolved and made up to 500.00 mL. The…

A: Given: mass of ore = 0.7352 g Concentration of EDTA = 0.02145 mol/L At pH = 1.0, the volume of EDTA…

Q: 0.8153 g of a sample containing Pb(NO3)2 was taken, dissolved in water, and 40.20 mL of 0.06 M EDTA…

A: A multiple choice question based on EDTA titration, which is to be accomplished.

Q: after dissolving in 50.0 ml of good water, the zinc in a 0.3232 gram sample of foot powder was…

A: The percentage of Zn can be calculated asThe weight of zinc = 0.3232 gramsMolar mass of Zn2P2O7 =…

Q: 5) The oxides and hydroxides of gallium exhibit both acidic and basic behaviors B) What is pCa for a…

A: Gallium metal is stable in dry air. It gradually oxidizes in moist air to form a protective film…

Q: The average daily dose recommended by hematologists for drugs is no more than 200 mg in terms of…

A: The average daily dose of elemental iron in the term of moles is determined as follows.…

Q: A 0.9352g sample of ore containing Fe³+, Al³+ and Sr²+ was dissolved and made up to 500.00 mL. The…

A: A numerical problem based on concentration terms that is to be accomplished.

Q: An acidic solution of copper (.35 M Cu+2) was treated with KOH until Cu(OH)2 precipitated. At what…

A: Given : Concentration of Cu2+ = 0.35 M Using appendix, the solubility product of Cu(OH)2 is 1.6 X…

Q: 6mL of 125mM EDTA was added to 244mL of water.  The resulting solution was added to 219mL of water…

A: MW of EDTA =292.24 g  initial molarity of EDTA = 125mM

Q: A 0.0450 M Ca(X)2 has a pH of 11.079. Ca(X)2 is composed of a Ca2+ cation and an unknown anion X-,…

A:

Q: A 1.000-gram sample of NaOH (39.997 g/mol) which has been exposed to the air for some time (NaOH…

A: In the quantitative analysis, the unknown amount of the substances in the sample is determined by…

Q: An unknown solution containing 25.00 mL of Ni2* in dilute HCI is treated with a known excess of…

A: Introduction :  This question is basically based on back titration concept . Given :  Molarity of…

Q: For the complexometric titration

A: The method uses a very large molecule called EDTA which forms a complex with calcium ions. EDTA…

Q: If you have a sample of 100 mg/L of calcium, and you have two standardized EDTA solutions of 0.005 M…

A: the balanced equation for the reaction between EDTA and Ca is  Ca+2 + EDTA–4 ----------->…

Q: A 0.3674 g powdered milk sample was analyzed for calcium by igniting in a crucible at 1000°C, the…

A: Analysis of sampleMass of sample = 0.3674 gTemperature = 1000oCVolume of EDTA required = 15.62…

Q: A chemist is given a piece of limestone and told that 50.00% of the sample exists as calcium oxide…

A: EDTA forms 1:1 complex with Ca+2.The balanced equation is     Ca+2 + EDTA–4 ------->…

Q: what Is the ZnBrat Na,s→ precipitate fo

A: In chemical reactions, Solid product form in the reaction is known as precipitate.

Q: How much 0.0500 M EDTA is needed to titrate the Mg and Ca in a 0.2385-g sample that is 92.5%…

A: Given,  Molarity of EDTA = 0.0500 M  Mass of the sample = 0.2385 g  Mass percent of dolomite = 92.5%…

Q: 20. Assume you are using 0.1 M EDTA to titrate a 0.2 M Ca* solution (25 mL) at pH 10.0. V molarity…

A: Calculation of no. of mol of Ca2+: n=Molarity×Volume=0.2 mol/L×25×10-3 L=5×10-3 mol Calculation of…

Q: Calculate the nickel ion concentration of a solution prepared by shaking Ni(OH)2 with water until…

A:

Q: A 1.963-g sample of an alloy is dissolved in HNO3 and diluted to volume in a 100-mL volumetric…

A: Answer: This question is based on stoichiometric calculation where moles of SCN- needs to be…

Q: After seeing Blake Lively's Met Gala 2022 look, a chemist was inspired to determine the copper…

A: We need to determine the copper content in a rock sample.

Q: A solution was prepared by dissolving about 30.00m g of EDTA  in approximately 1 L of water and…

A: The solution is given below -

Q: Calcium in powdered milk is determined by dry ashing a 3.00g sample then titrating the calcium with…

A: Concentration of Ca can be figure out by calculating concentration of EDTA solution.

Q: 0.7682 g MgCO3 is dissolved in 1000 mL water, 50 mL of this solution is taken and titrated with…

A: • Since, here is given that MgCO3 is taken as 0.7682 gm and its aqueous solution has been made in…

Q: The cumulative formation constants for the reaction of Co21 with ammonia are log b1 5 1.99, log b2 5…

A: Concentrated ammonia reacts with cobalt (II) ion forming a metal complex. The reaction takes place…

Q: As part of a geological team that studied a local cave, you brought with you a bunch of 1.00 g rock…

A: The reaction taking place will be, MgOH2+EDTA4-  → MgOH2EDTA4- Calculate number of moles of EDTA: 1…

Q: The landfill manager suggested using HI with NaI as a buffer to minimize pH changes. Do you agree…

A: A buffer solution is a solution whose pH does not change by adding small amount of acid and base.

Q: The DO of a water sample used in a steel industry was tested by Winkler’s method. The following…

A: A question based on introduction to chemistry that is to be accomplished.

Q: To analyze the amount of iron (Fe; Mw =  55.85 g/mol) contained in an ore sample, the sample was…

A: Given in the question, Volume of EDTA = 25 ml Molarity of EDTA = 0.2922 M Total moles of EDTA =…

Q: 0.4545 g CaCO3 was dissolved in HCl and the resulting solution was diluted to 0.25 L. Twenty-five mL…

A: Mass of CaCO3 = 0.4545 g Molar mass of CaCO3 = 100 g/mol Number of moles of CaCO3 = mass/molar mass…

Q: Calculate the activity of 103 in a saturated solution of La(103)3 with 0.15 M AI(NO3)3. 11

A: The objective of this question is to calculate the activity of IO3 in the solution required to…

Q: Describe the preparation of 2 L of 85 mM phosphate buffer, pH 6.5, using 120 mM  NaH2PO4·6H2O and…

A: Given: total volume of buffer solution = 2 L Concentration of buffer solution = 85 mM Concentration…

Q: 0.7682 g MgCO3 is dissolved in 1000 mL water, 50 mL of this solution is taken and titrated with…

A:

Q: 10.00 mL of aqueous NaOCl is treated with excess potassium iodide, KCl, in an acidicsolution. The…

A: The objective of this question is to determine the molarity of the NaOCl solution. This can be done…

Q: A cyanide solution with a volume of 13.72 mL was treated with 25.00 mL of Ni2+ solution(which…

A: 4CN- + Ni2+ ----> Ni(CN)42-

Q: What is the color of the complex formed from the reaction of Co2+ and quercetin? Does the complex…

A: The reaction between Co2+ and  Quercetin yields a brownish yellow coloured complex at pH 6.4 using…

Q: As part of a geological team that studied a local cave, you brought with you a bunch of 1.00 g rock…

A: Given that -  Mass of sample of rock = 1.00 g  Molarity of EDTA Solution used = 0.050 M  Volume of…

Q: calculate the concentration of free Zn2+ in 0.020M Zn(EDTA)2 at pH 10.00

A: The solution of the question is given below:

Q: 6.00 mL of 0.0100 M EDTA is mixed with 5.00 mL of 0.0100 M Ca2+. The pH is adjusted to 10 and DI…

A:

Q: 0.0322 M EDTA solution is used as the titrant in the titration of a 50.00 mL solution that is 0.0129…

A: EDTA titration is a type of complexometric titration that uses ethylenediaminetetraacetic acid…