A sample of nitrogen monoxide, NO, was placed in a sealed, rigid container at 200.K. The vessel washeated to 400.K. What changes will occur and why? (Consider changes to volume, temperature,pressure, moles, particle speeds)

A sample of nitrogen monoxide, NO, was placed in a sealed, rigid container at 200.K. The vessel washeated to 400.K. What changes will occur and why? (Consider changes to volume, temperature,pressure, moles, particle speeds)

World of Chemistry, 3rd edition

3rd Edition

ISBN:9781133109655

Author:Steven S. Zumdahl, Susan L. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan L. Zumdahl, Donald J. DeCoste

Chapter13: Gases

Section: Chapter Questions

Problem 33A

See similar textbooks

Similar questions

Given that a sample of air is made up of nitrogen, oxygen, and argon in the mole fractions 0.78 N2, 0.21 O2, and 0.010 Ar, what is the density of air at standard temperature and pressure?
In the discussion on the composition of air, mention is made of the fact that water vapor may have a concentration as high as 40,000 ppm. Calculate the partial pressure exerted by water vapor at this concentration. Assume that this represents a situation with 100% humidity. What temperature would be needed to achieve this value? (See Appendix G.)
How would the use of a volatile liquid affect the measurement of a gas using open-ended manometers vs. closed-end manometers?
perform stoichiometric ca1cu1uions for reactions involving gases as reactants or products.
93 The complete combustion of octane can be used as a model for the burning of gasoline: 2C8H18+25O216CO2+18H2O Assuming that this equation provides a reasonable model of the actual combustion process, what volume of air at 1.0 atm and 25°C must be taken into an engine to burn 1 gallon of gasoline? (The partial pressure of oxygen in air is 0.21 atm and the density of liquid octane is 0.70 g/mL.)
A sample of a smoke stack emission was collected into a 1.25-L tank at 752 mm Hg and analyzed. The analysis showed 92% CO2, 3.6% NO, 1.2% SO2, and 4.1% H2O by mass. What is the partial pressure exerted by each gas?
Exhaled air contains 74.5% N2, 15.7% O2, 3.6% CO2, and 6.2% H2O (mole percent). (a) Calculate the molar mass of exhaled air. (b) Calculate the density of exhaled air at 37C and 757 mm Hg and compare the value you obtained with that of ordinary air (MM=29.0g/mol) under the same conditions.
You have a gas, one of the three known phosphorus-fluorine compounds (PF3, PF3, and P2F4). To find out which, you have decided to measure its molar mass. (a) First, yon determine that the density of the gas is 5.60 g/L at a pressure of 0.971 atm and a temperature of 18.2 C. Calculate the molar mass and identify the compound. (b) To check the results from part (a), you decide to measure the molar mass based on the relative rales of effusion of the unknown gas and CO2. You find that CO2 effuses at a rate of 0.050 mol/min, whereas the unknown phosphorus fluoride effuses at a rate of 0.028 mol/min. Calculate the molar mass of the unknown gas based on these results.
The density of air 20 km above Earths surface is 92 g/m3. The pressure of the atmosphere is 42 mm Hg, and the temperature is 63 C. (a) What is the average molar mass of the atmosphere at this altitude? (b) If the atmosphere at this altitude consists of only O2 and N2, what is the mole fraction of each gas?
You have two pressure-proof steel cylinders of equal volume, one containing 1.0 kg of CO and the other containing 1.0 kg of acetylene, C2H2. (a) In which cylinder is the pressure greater at 25 C? (b) Which cylinder contains the greater number of molecules?