A sample of an ideal gas is allowed to escape reversibly at constant temperature into a vacuum. Which of the following statement(s) is(are) correct? O W = Q = AU = 0 O W = PAV + VAP OW= 0, AU = Q (positive number) O W = PAV, AU = 0, Q = PAV (negative number) O N

A sample of an ideal gas is allowed to escape reversibly at constant temperature into a vacuum. Which of the following statement(s) is(are) correct? O W = Q = AU = 0 O W = PAV + VAP OW= 0, AU = Q (positive number) O W = PAV, AU = 0, Q = PAV (negative number) O N

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A balloon containing an ideal gas is initially kept in an evacuated and insulated room. The balloon ruptures and the gas fills up the entire room. Which one of the following statements is TRUE at the end of above process? (a) The internal energy of the gas decreases from its initial value, but the enthalpy remains constant. (b) The internal energy of the gas increases from its initial value, but the enthalpy remains constant. (c) Both internal energy and enthalpy of the gas remain constant (d) Both internal energy and enthalpy of the gas increase
Termodynamic question I NEED ANSWER RARIDLY PLEASE!!! Water vapor enters the steam turbine at 4000 kPa pressure, 500 ° C temperature and 6 m3 / h volume flow, shown in the figure below. 0.2 times the mass flow rate of the incoming water comes out of the outlet no. 2 with 500 kPa pressure and 200 ° C temperature. 0.8 times the mass flow rate of the water comes out of the outlet no.3 with 30 kPa pressure and 0.85 dryness degree. Since the heat transfer from the turbine to the environment is 5000 kW, Find the mass flow rate of the incoming water. Find the volume flow of water at outlet no. 3. Find the power (kW) produced by the turbine. (Changes in kinetic and potential energies are negligible)
I need help with the diagnrams for this thermo practice problem 2 kg of air in a piston cylinder initially at P1=101 kPa, T1= 300 K undergoes a cycle made up of three processes: 1-2 Isothermal compression until the volume is (1/15) of its original value.2-3 Constant Pressure heating3-1 Isentropic Expansion back to the initial state Assume air is an ideal gas with constant specific heats with the following values: Cpo=1.027kJ/kgK; Cvo= 0.740 kJ/kgK; R=0.287 kJ/kgK; ɣ=1.388 Sketch this cycle on a P-v diagram and on a T-s diagram, clearly indicating all state points and the three processes.
Air (R-0.287 kJ/kg.K, c_=1.005 kJ/kg.K) is contained in a piston cylinder device, it expands first isothermally (1=>2) thẹn isobaric expansion takes place (2=>3), given the following: v,-0.2 m /kg, v,- 0.53 m /kg, v,-0.74 m /kg, P K. What is the Work output (kJ/kg) during process 1-2? 600 kPa, T min = 673 Imax
Q2: A mechanically reversible process in closed system for an ideal gas undergoes an adiabatic compression at 1bar from an initial state of x °C to y °C then cooled from y °C to x °C at constant pressure. Calculate w,Q, AU and AH if Cv= 3/2R and Cp=5/2R.
A condensing steam turbine is used to expand HPS (high pressure steam) polytropically from a pressure of 60 bar at 450 C to 2 bar at 150 C. Estimate a. turbine output steam temperature when the expansion is isentropic! Use the steam table in the Smith-Van Ness-Abbott book as a guide!b. Calculate the ideal and actual specific steam consumption! Use the steam table in the Smith-Van Ness-Abbott book as a guide!
Show that for perfect gas, Cp,m - Cv,m =R
I need answer within 20 minutes please please with my best wishes
I am getting lost in this practice problem for thermodynamics - thank you! Air at 100 kPa and 280K is compressed steadily to 600 kPa and 400K in an air compressor. The mass flow rate of air through the compressor is 0.02 kg/s and the compressor a heat loss of 16 kJ/kg from the compressor occurs. Assuming steady state steady flow conditions and ideal gas behavior (with constant specific heats, Cp=1.009 kJ/kgK, R=0.287 kJ/kgK, determine: a) The necessary power in put to the compressor(kW).b) The volumetric flow rate of air at the exit of the compressor (m3/s).
Can you provide the step-by-step solution how to get the answers? Steam flows adiabatically through a nozzle from 1517 KPaa, 290 °C, to 965 KPaa. Sketch the pV and Ts diagram and for m=454 gm/sec, Determine delta s, delta u, delta v, delta h, work nonflow and work steady flow. the first three (delta s, delta u, delta v, delta h) were already answered. Can you continue the bold part
I need help with this thermo practove problem that I do not understand- thank you! 2 kg of air in a piston cylinder initially at P1=101 kPa, T1= 300 K undergoes a cyclemade up of three processes: 1-2 Isothermal compression until the volume is (1/15) of its original value.2-3 Constant Pressure heating3-1 Isentropic Expansion back to the initial state Assume air is an ideal gas with constant specific heats with the following values: Cpo=1.027kJ/kgK; Cvo= 0.740 kJ/kgK; R=0.287 kJ/kgK; ɣ=1.388 Fill out the processes table below. Calculate Processes 1-2, 2-3, and 3-1 clearly