A round pipe of varying diameter carries petroleum from a wellhead to a refinery. At the wellhead the pipe's diameter is 58.3 cm (0.583 m) and the flow speed of the petroleum is 13.1 m/s. At the refinery the petroleum flows at 5.81 m/s. What is the volume flow rate of the petroleum along the pipe and what is the pipe's diameter at the refinery? Volume flow rate: Number 10 m³/s
Q: 1. The potential energy of a system of two atoms is given by the A relation ( E = В ) a stable…
A:
Q: (b) Copper crystallises as FCC (face centred cubic). Given that the atomic radius and density of…
A:
Q: Problem 3.14. Experimental measurements of the heat capacity of aluminum at low temperatures (below…
A:
Q: Suppose that a liquid of pure component A is in equilibrium with its own vapor at a temperature T…
A: The flux of atoms at a liquid-vapor interface can be described using kinetic theory and the concept…
Q: 3.66. Show that the density-series second virial coefficients can be derived from isothermal…
A: in this question we derived the equation from isothermal volumetric data.
Q: 1. The Gibbs function for a certain liquid is given by G(P,T) = AP + BP² + CT In | |+ D In + ET In…
A: Gibbs function of the certain liquid is given by GP,T=AP+BP2+CTlnPP0+DlnTT0+ETlnTT0
Q: Point P is at the center of the Cartesian coordinates (0,0) shown in the first image. If a nitride…
A: Option b is correct answer.
Q: When plotting graphs and performing numerical calculations, itis convenient to work in terms of…
A: The Van Der Waals equation is, (assuming mole is 1) P+av2×v-b=RTP=RTV-b-av2.....................1…
Q: For this question, consider a cylinder filled with a gas, com- pressed by a piston, as discussed in…
A: a) The ideal gas has been compressed using a piston. The system must be in mechanical equilibrium.…
Q: In Section 1.13 it was stated that the van der Waals constant b is approximately four times the…
A: The wander-wall equation is given as P+an2V2V-nb=nRT Here, P is the pressure. V is the volume and n…
Q: (Based on Neaman, Problem 4.54) - Silicon at T = 300K contains acceptor atoms at a concentration of…
A:
Q: 107 A 4L pese cooker has an operaing prese of 175 Pa ay, onehalf of he wolume is edligad and the…
A: Solution: The mass of the vapour and liquid is given as follows: mvap=total volume×%vapour by…
Q: (a) Calculate the volume occupied by 1.00 mol of an ideal gas at a pressure of 1.00 atm (1.01 10^5…
A:
Q: (a) Obtain total partition function for an Ideal di-atomic gas and use it to drive the expression of…
A:
Q: A diffusion couple of two metals, A and B, was fashioned as shown: X= A mm Diffusion of A atoms A-B…
A:
Q: 2121 log p= A-: T, being p the vapour pressure in The vapour pressure of water can be given by: nHg…
A: The expression for the vapor pressure be defined as, logp=A-2121T Here, p is the vapor pressure. T…
Q: Calculate the G, free energy for the following reaction taking place at 280K: 2NO + O2 → 2NO2. The…
A: The following data are given: The given reaction is: 2NO+O2→2NO2 Temperature of the reaction,…
Q: For the Clapp oscillator circuit shown below: (show the Vo and Vf) a. Calculate the operating…
A: Given Data The capacitance 1 is:C1=500 pF The capacitance 2 is:C2=75 pF The capacitance 3 is:C3=30…
Q: What is the temperature of 9.86 mol of a monatomic ideal gas having an internal energy of 42700 J?
A: Number of moles (n) = 9.86 Internal energy (U) = 42700 J Gas is monatomic.Thus, degree in freedom…
Q: Calculate the transistor’s Collector current if it is driven by a small Base current of 1.96mA with…
A: Given data : Base current , IB = 1.96 mA Emitter current , IE = 100 mA
Q: If You Know That aspecific Sol inside acell whose width is (1 cm) and The molav absorption…
A: The answer is explained below with a proper explanation.
Q: In the circuit below, we would like to bias the transistor such that it operates in the active…
A: We are given that: IC=1 mA= 1×10-3A VBE=0.7 V β=100
Q: The carrier distributions in the conduction and valence bands were noted to peak at energies close…
A: carrier distributions for the valence and conduction electron is given in the figure.For n-type…
Q: 4.) (Based on Neaman - Problem 5.47). A germanium sample is doped with a concentration of 5 x 10¹5…
A:
Q: 9.) (Based on Neaman, Problem 4.58) - Determine the Fermi energy level with respect to the valence…
A: Solution:-
Q: Prove that d -e² = e² dz Hint: expansion e? with taylor series.
A:
Q: Use the measured specific heat of ice [c = 0.49 cal/g K] at temperatures somewhat below freezing to…
A: We have igven an ice, So, in case of ice solid Each degree of freedom has two contributions to the…
Q: To mixer design, estimate the power requirement (kw/m³), agitation type for homogenous reaction…
A: Given : Mixture type, tank diameter and shaft power is given as, Re=105 ρ/D=1.8 D/Dt=0.3 k=0.025…
Q: Consider thin dimensional rod one- Sources of thermal energy whose lateral are a is not b) and…
A: The quantity of thermal energy per unit volume is known as thermal energy density, or e(x,t).The…
Q: Quickly estimate the change in enthalpy (/mol) to go from CO2 at 223K and 10 bar to 298K and 84 bar.
A:
Q: Reynolds 02 Show that in the high temperature limit, both the Einstein model heat capacity hwE where…
A:
Q: An ideal gas occupies a volume of 6.4 L at STP. What is its gauge pressure (in kPa) if the volume is…
A:
Q: Qu A therno.couple junction of area A, mass m, heat cmpacityC, and emissivity e in a furnace these…
A: Write the given values of this problem. m=0.1 gC=0.12 cal/g.C°e=0.7A=0.1 cm2Ti=1100°Cσ=1.363×10-12
Q: The fundamental frequency is 2230 cm−1 for the molecule 1H127I. If the H atom is replaced with D (an…
A:
Q: Determine the Seebeck coefficient and your error, using the data the table below. Must be expressed…
A: Solution: The Seeback coefficient can be defined as the voltage rise due to temperature gradient.…
Q: find Afgo A Carrf for the reverrible T juthermal expenoions and sU of lideal) from ideal) from a gen…
A: The work done in an isothermal process is given by,
Q: Briefly answer this question. (a) What is its specific heat (at constant volume) for a diatomic gas?…
A: (a) The specific heat of gases are usually written in molar specific heats. In case of the…
Q: a) Calculate the mean free path in meters of a nitrogen molecule (with a mass m=4.68×10-26 kg)…
A: a) Radius of the molecule is, r=3V4π13=3nNA4πnV13=34.68×10-26 kg28×10-3 kg/mol6.023×10234π1025…
Q: The mass density of water vapor at 327.6 atm and 776.4 K is 133.2 kg/m³. Given that for water Tc =…
A: Given Water vapor = 327.6 atm Temperature = 776.4 K Density = 133.2 kg/m3 TC…
Q: a Solid element Containing NA atoms , where NA is Avegadiods Number If each atom is Considend to…
A: The energy of a free particle at temperature T is given by…
Q: (a) Consider nodal configuration shown below. (a) Derive the finite-difference equations under…
A: In this question we have to find the value of T(m,n). Please give positive feedback if the answer…
Q: The pressure P and volume V of an expanding gas are related by the formula PV^b =c, where b and C…
A:
Q: A cylinder in a car engine takes Vi = 4.5 x 10-2 m³ of air into the chamber at 30C and at…
A: Write the given values with the suitable variables. Vi=4.5×10-2 m3Ti=30 °CVf=0.111ViPf=20Pi Here, Vf…
Q: Question 1:- Consedes perfectly insulated thin sod of asbitrary Enete length, cod is heated with…
A: a) A perfect insulated thin rod of finite length, rod is heated with external heat source qo(t).…
Q: In a given fluid, positive ions, each with three excess protons, move towards right at a steady rate…
A:
Q: 5. nc, ƏT show that it is. II
A: Given, H=E+PV E= Internal energy P= pressure V= volume
Q: An ESP is to he designed to treat 9000 m3/min of gas to remove particles at 98% efficiency. Using…
A: Given: The volume rate of treatment of gas is, V=9000 m3/min. The efficiency for removing the…
Solve part (B) only
To find the value of the pipe's diamater at the refinery.
Step by step
Solved in 4 steps