A rope 11m long has its ends fastened to hooks on the ceiling 9m apart. A load of 500N is suspended from the rope dividing it to segments of 7m and 4m. Assuming equilibrium, determine the force exerted by 4 m rope.
Q: The elevator in a vertical mine shaft is supported by a steel cable of cross-sectional area 3.20 x…
A:
Q: An anchor made of cast iron of bulk modulus 60.0 × 109 PA and volume of 0.230 m3, is lowered over…
A: Given Bulk Modulus B=60×109 Pa Change in pressure ∆P=1.75 × 106 Pa. Volume V=0.230 m3
Q: A vertical plate is isolated from its support by two rubber blocks which each have dimensions a =…
A:
Q: 7. A 6.0 m cylindrical steel beam 3.50 cm in diameter supports an overhead walkway. The beam is…
A:
Q: 1. In the system shown, cable A has an Ultimate Stress of 201 MN/m². For this application the cable…
A:
Q: When pushing off horizontally from a pool wall with her legs, the resulting force of the wall on the…
A: compression in length (∆L) = 2.98×10-5 m Length (L) = 36 cm = 0.36 m Radius (r) = 1.82 cm = 0.0182 m…
Q: A short, square timber post supports a load of 115 kips. If the allowable unit compressive stress is…
A: The given data are listed below with appropriate variables. Here, F denotes the applied load and σ…
Q: For safety in climbing, a mountaineer uses a nylon rope that is 65 m long and 1.4 cm in diameter.…
A: In the question given the length of rope , diameter of rope , mass and change in the length and we…
Q: Calculate the force a piano tuner applies to stretch a steel piano wire by 8.00 mm, if the wire is…
A: The cross-sectional area of the wire can be obtained as
Q: At the proportional limit, a 49 mm wide by 13 mm thick bar elongates 2.7 mm under an axial load of…
A: Given: Here are the given data, Width=49 mm Thickness=13 mm…
Q: A) by how much does a 55.3kg mountain climber stretch her 0.890 cm diameter nylon r ope when she…
A:
Q: a)What is the magnitude of the bone shear force acting on the vertebra?Report in N b)what is the…
A: The objective of the question is to calculate the magnitude of the bone shear force and the bone…
Q: he support consists of a solid red brass C83400 copper post surrounded by a 304 ainless steel tube.…
A: Given, A figure with dimensions. We need to calculate, the greatest axial load that can be…
Q: what is the percentage elongation of an elastic with a cross section of 5 cm2 If the force of 15 N…
A: Given- area of cross-sectional of elastic , A = 5 cm2 = 5 x 10-4 m2 applied force , F =15 N Young's…
Q: An 800Kg lift is suspended by a steel cable whose allowable stress is 1.2x10^8N/m^2. What is the…
A: Given that, The mass of the lift, m is 800kg. The allowable stress on the steel cable, σ is 1.2×108…
Q: For safety in climbing, a mountaineer uses a nylon rope that is 65 m long and 1.3 cm in diameter.…
A:
Q: A small rope has a linear mass density of 8.00 g/m and is tied to two vertical walls that are…
A: Question:Given:u = 8 g/mFigure:Find:(a) Velocity of Speed in terms of m equation(b) mass @ 65 m/s…
Q: В The 3-ft length of steel pipe (Est = 29 x 10° ksi) has a cross-sectional area of 2.0 in? and rests…
A: Given: LBC=5ft=60in, LBC=3ft=36in, Est=29×103ksi, Eal=10×103ksi, AAB=2in2, dBC=1in, P=20kip The…
Q: A cube of unknown material is 0.200 m on each side and has a mass of 17.6 kg. It is suspended in a…
A:
Q: A rectangular timber tie 180 mm x 80 mm is reinforced by a bar of aluminium of 25 mm diameter.…
A: A rectangular timber tie 180 mm x 80 mm is reinforced by a bar of aluminium of 25 mm diameter.…
Q: When making a peanut butter sandwich, consider that the bottom piece of bread is fixed. If the knife…
A: Velocity of the knife, v = 0.1 m/s Shearing stress experienced by knife = 41 pascal (pa) Thickness…
A rope 11m long has its ends fastened to hooks on the ceiling 9m apart. A load of 500N is suspended from the rope dividing it to segments of 7m and 4m. Assuming equilibrium, determine the force exerted by 4 m rope.
Trending now
This is a popular solution!
Step by step
Solved in 2 steps
- The legs of a weight lifter must ultimately support the weights he has lifted. A human tibia (shinbone) has a circular cross section of approximately 3.6 cm outer diameter and 2.5 cm inner diameter. (The hollow portion contains marrow. ) if a 90 kg lifter stands on both legs, what is the heaviest weight he can lift without breaking his legs, assuming that the breaking stress of the bone is 200 MPa?A walkway suspended across a hotel lobby is supported at numerous points along its edges by a vertical cable above each point and a vertical column underneath. The steel cable is 1.27 cm in diameter and is 5.45 m long before loading. The aluminum column is a hollow cylinder with an inside diameter of 16.14 cm, an outside diameter of 16.24 cm, and unloaded length of 3.25 m. When the walkway exerts a load force of 8,400 N on one of the support points, how much does the point move down? mmA wooden timber is employed as a column under formwork. The timber is nominally 6x8 inches (actual dimensions 5 ½ x 7 %"). If the allowable axial design stress based on this species and grade of wood is 600 psi what is the maximum load that could be safely applied to a short length of this timber used as a column? (You can ignore slenderness criteria). Maximum axial load (include units).
- A 3.0 m long cylindrical alloy beam is 21 cm in radius. It is found to stretch by 1.5 cm under a tension of 2.0 kN. Find its Young’s modulus.By how much does a 75.0-kg mountain climber stretch her 0.750-cm diameter nylon rope when she hangs 15.0 m below a rock outcropping? (consider g=9.80 m/s2, and, for nylon Y= 1.35×109 Pa)By how much does a 65.0-kg mountain climber stretch her 0.800-cm diameter nylon rope when she hangs 35.0 m below a rock outcropping? (For nylon, Y = 1.35 × 109 Pa.)
- For safety in climbing, a mountaineer uses a nylon rope that is 65 m long and 1.5 cm in diameter. When supporting a(n) 86-kg climber, the rope elongates 1.4 m. Find its Young's modulus.Review: A soild sphere of brass (bulk modulus of 14.0 x 1010N/m2) with a diameter of 3.00m is thrown into the ocean by how much does the diameter of the sphere decrese as it sinks to a depth of 1.00km?13-
- A vertebra is subjected to a shearing force of 5.0 x 10° N. Find the shear deformation, taking the vertebra to be a cylinder 3.00 cm high and 4.00 cm in diameter. The shear modulus for vertebrae is 8.0 x 1010 N/m. shear deformation:A steel wire, 3.0 m long, has a diameter of 1.0 mm. If a 10 kg load is hung from the wire how far will it stretch? Young's modulus for steel is 2.0 × 10^11 paArtificial diamonds can be made using high- pressure, high-temperature presses. Suppose an -6' artificial diamond of volume 1.00 x 10 m is formed under pressure of 5.00 GPa. Find the change in its volume when it is released from the press and brought to atmospheric pressure. Take the diamond's bulk modulus to be B =194 GPa. Use the rules of significant figures.