A room is filled with saturated steam at 100°C. Now a 5-kg bowling ball at 25°C is brought to the room. Heat is transferred to the ball from the steam, and the temperature of the ball rises to 100°C while some steam condenses on the ball as it loses heat (but it still remains at 100°C). The specific heat of the ball can be taken to be 1.8 kJ/kg - C. Solve for the mass of steam that condensed during this process.

A room is filled with saturated steam at 100°C. Now a 5-kg bowling ball at 25°C is brought to the room. Heat is transferred to the ball from the steam, and the temperature of the ball rises to 100°C while some steam condenses on the ball as it loses heat (but it still remains at 100°C). The specific heat of the ball can be taken to be 1.8 kJ/kg - C. Solve for the mass of steam that condensed during this process.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Consider 6.5 kg of air at T1= -53°C in a frictionless.cylinder and piston. By applying heat to the air, piston moves freely and until V2= 6 Calculate the final temperature of the air (T2), work and heat transfer during this process in kJ. Specific heats of the air are not constant during this process.
3-39 Water initially at 200 kPa and 300°C is contained in a piston-cylinder device fitted with stops. The water is allowed to cool at constant pressure until it exists as a saturated vapor and the piston rests on the stops. Then the water continues to cool until the pressure is 100 kPa. On the T-v diagram, sketch, with respect to the saturation lines, the process curves pass- 1stams! od on TURNACE ing through the initial, intermediate, and final states of the 1992 palam 11. water. Label the T, P, and U values for end states on the process artita ne odrow OFTİ 21 nucfortyd beinvarian curves. Find the overall change in internal energy between the 1610 PRICE initial and final states per unit mass of water. al state Onimals uliod Anub 1516w 3-150 3-160 In Water 200 kPa 300°C 3-17C ment rises. Now on top of air Obs will rise in a co FIGURE P3-39 180 Q
Thermodynamic. Determine the work needed to compress from V1=30 lt to V2=5 lt a gas applying a constant pressure of 2.5atm.
What is the new temperature (in K) of a closed gas system when it's volume is compressed from 5.6 L to 2.3 L and initial temperature was 455ﾟ K
One kg of superheated steam is at 400 kPa and 400°C. Heat is added to raise the temperature to 500°C. Find the amount of heat needed (kJ) if: (a) The volume of the steam is kept constant during the heating. (b) The steam is allowed to expand during the heating (e.g., in a piston/cylinder system) such that the pressure is constant. Hint: The steam is not an ideal gas under these conditions.
Determine the work done by the expanding gas using the trapezoidal rule. from the data in the image
The pressures at the inlet and exit of an air compressor are 2 bar and 7 bar respectively. Theinlet temperature is 20 degree C the volume at the beginning of compression is three times thatat the end of compression Calculate the temperature of the air at outlet and the increase ofinternal energy per kg of air.Urgent pls
answer d
Propane (MW = 44 ; k = 1.13) initially at 30 psia and 215°F, is stored inside a large spherical vessel having a diameter of 10 ft. If the temperature is increased to 635°F. Determine the following: a. Final pressure in psi b. Mass of propane in Ibm c. Constant Volume Specific heat in BTU/lbm d. Change in Internal Energy, AUU in BTU
THERMOFLUID A frictionless piston-cylinder contains 3.30 kg of saturated water at 1 MPa. The water is expanded at constant pressure until its temperature rises to 270 °C. The image of the system and process are shown in Figure 3. Determine: The final volume of water in cylinder, and sketch the process in P-V diagram
Eighteen kilograms of methang gas is confined inside a closed cylinder equipped with a piston which has an initial pressure of 3100 mmHg abs and 138°C. If the gas is cooled until its final pressure and temperature are 2340 mmHg gauge and 0°C, respectively, what is the amount of work done by the fluid in kJ?