A rigid tank containing 1.36 kg gas mixture of nitrogen and carbon dioxide (each 50% by volume) at 272 kPa and 65°C. Determine (a) molar analysis (or % by mol (b) molecular weight and gas constant of mixture (c) volume of mixture (d ) partial volumes of gases (e ) partial pressures of gases (f) gravimetric analysis (or % by mass) (g ) masses of gases (h) mols of gases (i) specific heats Cp and Cv of mixture (j) specific heat ratio of mixture (k) internal energy of mixture (I) enthalpy of mixture

A rigid tank containing 1.36 kg gas mixture of nitrogen and carbon dioxide (each 50% by volume) at 272 kPa and 65°C. Determine (a) molar analysis (or % by mol (b) molecular weight and gas constant of mixture (c) volume of mixture (d ) partial volumes of gases (e ) partial pressures of gases (f) gravimetric analysis (or % by mass) (g ) masses of gases (h) mols of gases (i) specific heats Cp and Cv of mixture (j) specific heat ratio of mixture (k) internal energy of mixture (I) enthalpy of mixture

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Use the van der Waals parameters for hydrogen sulfide a/(atm dm6 mol-2) = 4.484 and b/(10-2 dm3 mol-1) = 4.34 to calculate approximate values of (a) The Boyle temperature of the gas (by assuming van der Waals gas behavior); (b) The radius of the hydrogen sulfide in pm based on the argument given on Page 23 in Section 1C where b = 4 Vmolecule NA. Read the definitions on Page 23 in the textbook (atkins physical chemistry 11th edition) (c) Critical temperature Tc (in K) and critical pressure Pc (in atm). (d) Plot the p-V diagram for the hydrogen sulfide van Waals gas for three isotherms: T = 0.85 Tc, T = Tc, and T = 1. 8 Tc where Tc is the critical temperature in the range of molar volume Vm between 0.0600 L/mol and 0.800 L/mol . Show the units and the range in your plot. Note that if you plot the p-V diagram correctly, the equilibrium vapor pressure cannot be estimated, for example, at T = 0.85 Tc.
Please see image
A domestic water-carbonating kit uses steel cylinders of carbon dioxide of volume 250 cm3 They weigh 1.04 kg when fu ll and 0.74 kg when empty. What is the pressure of gas in the cylinder at 20°c?
At 300 K and 20 atm, the compression factor of a gas is 0.86. Calculate (i) the volume occupied by 8.2 mmol of the gas molecules under these conditions and (ii) an approximate value of the second virial coefficient B at 300 K.
Could 25 g of argon gas in a vessel of volume 1.5 dm3 exert a pressure of 2 bar at 30 oC it is behaved as a perfect gas ? (a) What pressure would it exert ? (b) What pressure would it exert if it behaved as Vander Waals gas if a 1.337 dm6 atm mol-2, b = ? 3.20 * 10-2 dm3 mol-1
The total pressure of a mixture of oxygen and hydrogen is 1.00 atm. The mixture is ignited, and water is removed. The remaining gas is pure hydrogen and has pressure at P = 0.400 atm when measured at the same T and V as the original mixture. What is the composition of the original mixture in mole percent?
8g of potassium trioxochlorate(v) KCLO3 was heated to liberate oxygen.The gas was collected over water at 301K and a pressure of 90KPa What is the volume of the dry oxygen gas at Stp. (Mr:KCLO3=122.5,O2=32.0,molar volume of gas at S.T.P=22.4dm3 Satured vapour pressure of water at 301K=37kPa.)
When limestone (solid CaCO3) is heated, it decomposes into lime (solid CaO) and carbon dioxide gas. This is an extremely useful industrial process of great antiquity, because powdered lime mixed with water is the basis for mortar and concrete — the lime absorbs CO2 from the air and turns back into hard, durable limestone. Suppose a limekiln of volume 800.L is pressurized with carbon dioxide gas to 26.6atm, and heated to 600.0°C. When the amount of CO2 has stopped changing, it is found that 10.1kg of CaCO3 have appeared. Calculate the pressure equilibrium constant Kp this experiment suggests for the equilibrium between CaCO3 and CaO at 600°C. Round your answer to 2 significant digits. Note for advanced students: it's possible there was some error in this experiment, and the value it suggests for Kp does not match the accepted value.
0.56g of ethene gas is 1 poin contained in a vessel at a pressure of 102 kPa and the temperature of 30 °C. What is the volume of the vessel? *
5.31 A McLeod gauge measures low gas pressures by com- pressing a known volume of the gas at constant temperature. If 345 cm' of gas is compressed to a volume of 0.0457. cm' under a pressure of 2.5 kPa, what was the original gns pressure?
4. Use the van der Waals parameters for hydrogen sulfide a/(atm dm6 mol-2) = 4.484 and b/(10-2 dm3 mol-1) = 4.34 to calculate approximate values of (a) the Boyle temperature of the gas (by assuming van der Waals gas behavior); (b) the radius of the hydrogen sulfide in pm based on the argument given on Page 23 in Section 1C where b = 4 Vmolecule NA. Read the definitions on Page 23 in the textbook; (c) critical temperature Tc (in K) and critical pressure Pc (in atm). (d) Also, plot the p-V diagram for the hydrogen sulfide van Waals gas for three isotherms: T = 0.85 Tc, T = Tc, and T = 1. 8 Tc where Tc is the critical temperature in the range of molar volume Vm between 0.0600 L/mol and 0.800 L/mol . Note that if you plot the p-V diagram correctly, the equilibrium vapor pressure cannot be estimated, for example, at T = 0.85 Tc. I only need question d answered but you need the other parts to create the table and the plot. Thank you
An experiment is conducted in which a quantity of H2(g) is chemically generated in a closed headspace of volume V1 at absolute temperature T1, thereby raising the total pressure from Pa (the initial air pressure) to Pf (the total final pressure of H2(g) + air).Compose an algebraic expression for the volume (V2) that this sample of H2(g) would occupy if it were isolated (pure -- i.e. no air) at absolute temperature T2 and partial pressure P2.Note that your expression may contain no other variables than those given above, namely: V1, T1, T2, Pa, Pf, and P2. V2 = Now, suppose that the above experiment generated n mol of H2(g), that T2 = 0 °C and that P2 = 1 atm. Give the simple algebraic expression, in terms of V2 and n, which equates to the molar volume of H2(g) at STP.VM = 8.829×10-4 mol of B2H6(g) (diborane gas) is generated into a 176.0 mL headspace, at 25.0 °C, thus increasing the pressure by 0.1209 atm. If we assume that the diborane gas obeys Boyle's Law and Charle's Law, what…