A rigid steel bar is suspended horizontally by 1m steel rod at one end and 2m bronze rod at the other end as shown. Neglecting the mass of the steel bar, at what distance X (in meters) from the steel rod should a 20 kN force be placed so that the steel bar will remain horizontal? Also, calculate the stresses in steel and bronze rod (in MPa). Use the following data. Steel, st Bronze, Br Br. 2m 20000 N Area (mm?) 600 300 St. 1m -X- E(GPa) 200 83 10 m

A rigid steel bar is suspended horizontally by 1m steel rod at one end and 2m bronze rod at the other end as shown. Neglecting the mass of the steel bar, at what distance X (in meters) from the steel rod should a 20 kN force be placed so that the steel bar will remain horizontal? Also, calculate the stresses in steel and bronze rod (in MPa). Use the following data. Steel, st Bronze, Br Br. 2m 20000 N Area (mm?) 600 300 St. 1m -X- E(GPa) 200 83 10 m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

2) A solid rod with the given dimension shown in Fig. Axial loads are applied at the positions indicated. Find the f a) The max Compressive stress in the system P-60 kN Aluminum A=400 mm b) The max Tensile stress in the system P-60 kN Steel A = 500 mm² Bronze A-200 mm² 4P 2.5 m 1.5 m 2.0 m 2P
The failure stress of a homogeneous steel bar having a diameter of 10 mm is 250 MPa. Using a factor of safety of 2.0, calculate the maximum load in N that the bar can support. A 12500*pi В) 6250*pi C) 3125*pi 1563*pi
jp
A rigid bar of negligible weight is supported as shown below. Compute the value of the load W that will cause the stress in the steel rod to be 55 MPa. Bronze L = 3 m A = 1300 mm? E = 83 GPa Steel L = 1.5 m A = 320 mm? E = 200 GPa - 1 m %3D 2.5 m 1.5 m w/
Axial loads are applied to the compound rod that is composed of an aluminum segment rigidly connected between steel and bronze segments. What is the stress (in Mpa) in the bronze given that P= 188 kN? Express your answer in four decimal places.
Read the question carefully and give me all right solutions with clear calculations.
The light rigid bar ABCD shown is pinned at C and connected to two vertical rods. The bar was initially horizontal, and the rods were stress-free before the load P = 20 KN is applied. %3D Steel E200 GPa A-600mm L1 m 2.0 m 0.6 m 1.5 m Pa20 KN Aluminum E-70 GPa A=900mm L-1.5 m What is the ratio of the deformation of steel to deformation of aluminum?
The beam is subjected to a loading condition as shown in th figure. Determine the (a) maximum tensile stress and (b) maximum compressive stress with the givenm cross section. Show you complete solution and diagram.
1/2 Problem 1: Two solid cylindrical rods AB and BC are welded together at B and loaded as shown in. If the stress must not exceed 14OMPA in either rod, determine the smallest allowable value of the diameter of rod AB and ВС. 300mm B 40 kN 250mm - d2 30 kN