A rigid cylinder of gas shows a pressure of 500 torr at 215 K. The cylin- der is moved to a new storage site where the pressure within the cylinder is now measuring 800 torr. What is the new temperature? Show your work. Answer in a complete sentence. I !!!| H Normal EEAA Enter your answer here BIUS √x Tx ΩΒΑ

A rigid cylinder of gas shows a pressure of 500 torr at 215 K. The cylin- der is moved to a new storage site where the pressure within the cylinder is now measuring 800 torr. What is the new temperature? Show your work. Answer in a complete sentence. I !!!| H Normal EEAA Enter your answer here BIUS √x Tx ΩΒΑ

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

True or false. Why?
aring Suppose that 2.45 g of gaseous nitrogen, N2, is placed in a 2.15 L container The pressure is measured to be 475.0 mmHg What is the Celsius temperature of the gas? [Hint: Your first step should be solving the ideal gas equation for T.] ΜΕ ΑΣΦ ?
5.- Nitrogen gas occupies a volume of 4.30 L at 54°C. If its volume increased to 7.80 L at the same pressure. Calculate the final temperature in kelvin. 235k 2k 593.163k 334.43k 200k
A reaction at 19.0°C evolves 483.mmol of carbon dioxide gas. Calculate the volume of carbon dioxide gas that is collected. You can assume the pressure in the room is exactly 1atm . Be sure your answer has the correct number of significant digits.
A chemical engineer must calculate the maximum safe operating temperature of a high-pressure gas reaction vessel. The vessel is a stainless-steel cylinder that measures 21.0 cm wide and 25.2 cm high. The maximum safe pressure inside the vessel has been measured to be 8.80 MPa. For a certain reaction the vessel may contain up to 0.650 kg of carbon dioxide gas. Calculate the maximum safe operating temperature the engineer should recommend for this reaction. Write your answer in degrees Celsius. Round your answer to 3 significant digits. temperature: I °C
Please answer the question Below.
Calculate to three significant digits the density of carbon monoxide gas at exactly −20°C and exactly 1atm . You can assume carbon monoxide gas behaves as an ideal gas under these conditions.
A particular football has an internal volume of 2.25 L at an outdoor temperature of 35°C. When the football is brought indoors, the temperature in the football drops to 20°C. What is the new volume of the football? Show the formula and the calculations.
7. When detern ing the mass of a liquid, ras in a hurry and did not allow enough time for the temperature of the flask to reach the temperature of the boiling water bath. The student recorded the temperature of the gas as 100.0°C when it was only 80.0°C, Is the molar mass calculated by the student higher or lower than the accepted molar mass, or does this error have no effect on the calculated result? Briefly explain your answer # 2/HB Office DEPOTS b) If the student assumed the volume of the flask was 125 mL (as marked by the side of the flask) rather than measuring the volume experimentally, would the unknown's calculated molar mass be too high, too low, or unaffected? Explain. # 2/HB 4
An 1.82g sample of a gas occupies 6.8L at a temperature of -100.∘∘C and 3.5psi. What is the identity of this gas?
When air expands adiabatically (without gaining or losing heat), its pressure P and volume V are related by the equation PV14 = C where C is a constant. Suppose that at a certain instant the volume is 310 cubic centimeters and the pressure is 87 kPa and is decreasing at a rate of 8 kPa/minute. At what rate in cubic centimeters per minute is the volume increasing at this instant? cm3 min (Pa stands for Pascal it is equivalent to one Newton/(meter squared); kPa is a kiloPascal or 1000 Pascals.
A canister of pressurized gas has a mass of 10.0000 g. A small amount of gas is released and collected. The collected gas has a volume of 50.00 mL. The pressure and the temperature of the collected gas are the same as the air pressure and air temperature that day: 100. kPa and 25oC. It is noticed that when the gas is released the mass of the pressurized canister decreases to a mass of 9.9110 g. It is not known what gas is in the canister, but you know it is one of the following gases: methane (CH4), ethane (C2H6), propane (C3H8) or butane (C4H10). Using the information provided determine which gas is actually present in the canister.