A reservoir is at effective height of 95m. An irreversible pump is used to pump a mass flow of 4500 kg/s of water from ground level into the reservoir. Consider water as an incompressible liquid with mass density of 1000kg/m . 1) What is the power consumption of pump for an isentropic pump efficiency of 82%? 2) What is the power that can be recovered from a turbine with 93%?

Q: Energy balance open system (hydraulic turbine):   Lake water contained by a dam is used to generate…

A: Given Data The pressure at point 1 is: P1=150 kPa The height of the point 1 is: 25 m The pressure at…

Q: motor-pump system with 90% efficiency is designed to increase the pressure of was from 101kPa to 250…

A: Hh

Q: Water enters a pump at 350 kPa at a rate of 1 kg/s. The water leaving the pump enters a turbine in…

A:

Q: Saturated ammonia at a temperature of 50oF and a flow rate of 3 lbm/s enters a steady-state…

A:

Q: Draw the control volume of a compressor and apply the first law of thermodynamics to it. With…

A: For solution refer below images.

Q: Does the back work ratio in steam turbines in comparison with gas turbine power plants is much…

A: back work ratio in steam turbines in comparison with gas turbine power plants is much larger because…

Q: Determine: (a) the magnitude of the pump power, in kW. W CV = 23.7625 x KW (b) the mass flow rate of…

A: dz = 25m m1.=50kg/sQcv.=-2kW Note: heat transfer from the system to the surrounding is taken as…

Q: Let's assume that we generate electrical energy through a turbine generator. A reversible adiabatic…

A: Given: The pressure at the entry of turbine, P1 = 10000 kPa The temperature at the entry of turbine,…

Q: The diagram shows a conical section fabricated from pure aluminum. It is of circular cross section…

A: The temperature at  is The temperature at  is The diameter is , The lateral surface are insulated

Q: In turbochargers a turbine is directly connected to a compressor. The power harvested by the turbine…

A:

Q: Refrigerant R-134a at 400 kPa and 80 ⁰C enters an adiabatic diffuser steadily with a velocity of 600…

A:

Q: A pump at a power plant supplies water to the boiler at a flow rate of 1,000 gal/min, measured at…

A:

Q: 3. A 1.5 kW pump delivers 1.2 kg/s water to a building. The water comes in at 100 kPa, and 15°C. The…

A: Given data

Q: The rotor of an impulse turbine is 60 cm diameter and runs at 9,610 r.p.m. The nozzles are at 20° to…

A: Given Data: Impulse turbine Diameter D=60 cm=0.6 m Impulse turbine rotation N=9610 rpm Nozzle Angle…

Q: Refrigerant R-134a at 400 kPa and T1=10⁰C  enters an adiabatic diffuser steadily with a velocity of…

A:

Q: = In turbochargers a turbine is directly connected to a compressor. The power harvested by the…

A:

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.