Give me right solution A reinforced concrete tie with a cross section of 10 in.x10 in. is reinforced with 8 # 8 steelreinforcing bars Grade 60. Calculate the cracking tensile load and the maximum factored tensileload that can be supported by the tie. The concrete has a 28-day compressive strength of 3000 psi(fe = 3000 psi)10"t-10"-

Data Given: Dimensions of tie = 10" × 10"No. of steel bars = 8Bar type = #8 rebarSteel grade = 60 ∴…

Answered: A reinforced concrete tie with a cross…

Materials Science And Engineering Properties

1st Edition

ISBN:9781111988609

Author:Charles Gilmore

Publisher:Charles Gilmore

Chapter12: Composite Materials

Section: Chapter Questions

Problem 12.7P: Estimate the transverse tensile strength of the concrete in Problem 12.6.

See similar textbooks

Similar questions

Please give me the correct solution and answer this problem in principles of reinforced/presstresse concrete
Read the question carefully and give me right solution according to the question. Don't copy from other websites solution
A storage tank of air, 30 inches in diameter, is to withstand an internal pressure of 180 psi with a design factor of 3.5 based on ultimate stress. The steel has the strength equivalent of C1020 annealed and the welded joints should have a relative strength of 92%. Note: ultimate stress of for annealed C1020 steel is 50 ksi. Compute for longitudinal stress of the tank. a.13, 171 psi b.13, 786 psi c.12,893 psi d.12,860 psi
CRACKED ANALYSIS ON BEAM
The T-beam has the following properties: flange thickness = 125 mm flange width = 1000 mm web width = 500 mm web height = 350 mm f'c = 28 Mpa a) Calculate the stresses in concrete at uncracked stage under 200 kN-m. b) Calculate the cracking moment. c) Determine the balanced steel area and balanced ultimate moment. The steel is placed 80 mm from its cg up to extreme fiber with yield strength of 414 MPa.
Answer asap
Number 1 (parts i, ii, iii) please :)
Read the question carefully and give me right solution according to the question
24 Calculate the tensile steel stress of 5-16-mm-dia rebars in a concrete beam 270 mm by 460 mm at ultimate stage if f'c = 21 MPa and fy = 420 MPa. Express your answer in whole number.
An ASTM cast iron, grade 30, has ultimate strength at tension Sut = 350 MPa, and at compression Suc = 1150 MPa. it carries static loading resulting in the stress state listed below at the critical locations. Using the static failure analysis estimate the factor of safety. σA = 127 MPa, σB = -264 MPa.
Two pieces of wood, 60 mm by 120 mm each are glued together along the 40° joint. The permissible normal stress in the glue is limited to 100 MPa. The maximum safe load that can be applied at the joint is P+ 40° 60 mm P
Required information Consider the loading shown. The allowable normal stress for the steel used is 160 MPa. 0.8 m 50 kN/m B -2.4 m- 0.8 m For the selected design, determine the actual value of Om in the beam. (Round the final answer to one decimal place. You must provide an answer before moving to the next part.) The actual value of om in the beam is 160 MPa.

SEE MORE QUESTIONS

Recommended textbooks for you

Materials Science And Engineering Properties

Civil Engineering

ISBN:

9781111988609

Author:

Charles Gilmore

Publisher:

Cengage Learning

Materials Science And Engineering Properties

Civil Engineering

ISBN:

9781111988609

Author:

Charles Gilmore

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS